Question

4.47 In a particular circuit application, ten “20-mA diodes” (a 20-mA diode is a diode that...

4.47 In a particular circuit application, ten “20-mA diodes” (a 20-mA diode is a diode that provides a 0.7-V drop when the current through it is 20 mA) connected in parallel operate at a total current of 0.1 A. For the diodes closely matched, what current flows in each? What is the corresponding small-signal resistance of each diode and of the combination? Compare this with the incremental resistance of a single diode conducting 0.1 A. If each of the 20-mA diodes has a series resistance of 0.2

0 0
Answer #1

has the cuxwent Eaah dfede OA CD A Small- sral rest stance Eaah diode has - 2.5 paallel combinalier O25 o diodes O025 dtade ctoConedt Nouo Constdex the sextes esfst fade Fos the ance axalMel aombination above 272 utualent istancethe u0Osneed sirple c

Know the answer?
Add Answer to:
4.47 In a particular circuit application, ten “20-mA diodes” (a 20-mA diode is a diode that...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • 4.47 In a particular circuit application, ten “20-mA diodes” (a 20-mA diode is a diode that...

    4.47 In a particular circuit application, ten “20-mA diodes” (a 20-mA diode is a diode that provides a 0.7-V drop when the current through it is 20 mA) connected in parallel operate at a total current of 0.1 A. For the diodes closely matched, what current flows in each? What is the corresponding small-signal resistance of each diode and of the combination? Compare this with the incremental resistance of a single diode conducting 0.1 A. If each of the 20-mA...

  • 3. When diodes that have unequal junction capacitances are connected in series in a circuit, they'll often be protec...

    3. When diodes that have unequal junction capacitances are connected in series in a circuit, they'll often be protected by A. parallel diodes. B. parallel capacitors. C. series resistors. D. parallel resistors. 5. The front-to-back resistance ratio of a power supply rectifier diode must be no less than A. 30 to 1. B. 2 to 1. C. 5 to 1. D. 10 to 1. 15. Which of the following is the correct equation for the percent regulation of a power...

  • Please show all of the steps Question 2: 20% We can use stack of diodes as...

    Please show all of the steps Question 2: 20% We can use stack of diodes as a voltage regulator as shown in the circuit below. Consider input voltage to this circuit as 20V DC with IV of fluctuation. Diodes in this circuit have 0.7V forward voltage drop a) What is DC output voltage Vo? 20+1V Vo= 1.4 V R=1k2 b) What is diode DC current lo? Ip= 18-6 ma c) What is the value of individual diode's small-signal resistor/? (4%)...

  • A common source amplifier circuit based on a single n-channel MOSFET is shown in Figure 4b. Assume that the transconductance gm-60 mS (equivalent to mA/ V) and drain source resistance, os,...

    A common source amplifier circuit based on a single n-channel MOSFET is shown in Figure 4b. Assume that the transconductance gm-60 mS (equivalent to mA/ V) and drain source resistance, os, is so large it may be neglected. 0) Calculate the open circuit voltage gain Av Yout/ Vis. i) The amplifier has a load of 10 k2. Determine the current gain Va. = 12 V 150k 4k3 Vout Vin 200k GND = 0 V Figure 4b a) State the name...

  • Pease answer questions 4 and 5! Thank you so much! 4. Connect the 2nd resistor in...

    Pease answer questions 4 and 5! Thank you so much! 4. Connect the 2nd resistor in parallel with the 1st resistor and connect that combination to the battery.          Measure the following:               The current passing through the R1, I1 = ___0.0058____ A               The current passing through the R2, I2 = ___0.0031____ A               The current supplied by the battery, I = ___0.0092____ A              Calculate I1 + I2 = ____________ A                     Is the following statement true? I = I1 +...

  • summarizr the followung info and write them in your own words and break them into different...

    summarizr the followung info and write them in your own words and break them into different key points.   6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...

  • summatize the following info and break them into differeng key points. write them in yojr own...

    summatize the following info and break them into differeng key points. write them in yojr own words   apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...

  • How can we assess whether a project is a success or a failure? This case presents...

    How can we assess whether a project is a success or a failure? This case presents two phases of a large business transformation project involving the implementation of an ERP system with the aim of creating an integrated company. The case illustrates some of the challenges associated with integration. It also presents the obstacles facing companies that undertake projects involving large information technology projects. Bombardier and Its Environment Joseph-Armand Bombardier was 15 years old when he built his first snowmobile...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT