Hello,
Please find the answers to
questions 5-8 attached below. If the answer has
helped you please give a thumbs up rating. Thank
you and have a nice day!
5. Chain structure
6. Synchronous parallel
7. Schmitt Trigger
8. One way of eliminating timing hazards in combinational circuits is by putting delay buffers in the feedback path.
*************************************************************
PS: Please do not forget the thumbs
up!!
5. For parity circuits, with the same number of inputs, is faster (Chain structure or Tree...
A retaining wall is to be constructed in a normally consolidated clayey sand deposit in the figure below. Ground water table is lmbelow the bottom of the excavation. A 20 kN/m2 surcharge pressure is applied over a wide area at the ground surface. Assume the wall moves into the excavation. Consider long-tem analysis (as it is usually the more critical analysis in excavation problems). Ignore capillarity as shown 20 kPa Clayey sand T17 kNm Y-20 kNm 5 m c'-10 kPa...
5. (a) With the aid of a well-labelled disgram, describe in detail the operation of a p-channel MOSFET 15 marks) (b) Mention the modes of operation of a n-channel MOSFET with their corresponding equations for the drain current 16 marks (c) Give three (3) reasons why CMOS technology is preferred to NMOS technology in modern electronic devices? 13 marks) 6. (a) Why are some logic gates referred to as universal gates? Mention two universal cates and provide the truth table...
5) Decoders: Given the following circuit, S0 and S1 are computed using a 4-2 priority encoder with the priorities indicated on the figure. (hint: IDLE signal is always 0, if any of the inputs 10,11,12, or 13 is 1) 6 points) 4-to-2 Priority Encoder 10 YO YI 13 IDLE 13> 11 > 12>10 12 Full c Adder So Fill the following table showing the output signals S0 and SI given the input signals w, x, y, a) and z. Prof...
Could you please show me how I can drw those circuits. please using (NI Multisim 14) Optocoupler Objectives Use an ohmmeter to determine the condition of the optoisolator. Observe the operation of an optocoupler. Determine the maximum frequency response of the optocoupler. Required Materials (1) Dual DC power supply (1) Function generator (1) Oscilloscope (2) Multimeters (1) Optocoupler (ECG3040) (1) 3.9ΚΩ resistor (1) 220 resistor Introduction An optoisolator is a hybrid integrated circuit that contains an LED on one side...