Consider the combined gas-steam power cycle,The topping cycle is a gas-turbine cycle that has a pressure ratio of 8.Air enters the compressor at 300K and the turbine at 1300K.The isentropic efficiency...
Consider the combined gas-steam power cycle,The topping cycle is a gas-turbine cycle that has a pressure ratio of 8.Air enters the compressor at 300K and the turbine at 1300K.The isentropic efficiency of the compressor is 80 percent, and that of the gas is 85 percent.The bottoming cycle is a simple ideal Rankine cycle operating between the pressures limits of 7 MPa and 5 KPa.Steam is heated in a heat exchanger by the exahust gases to a temperature of 5000C.The exhaust gases leave the heat exchanger at 450 K,Draw the TS diagram of this cycle and determine:
The ratio of the mass flow rates of the steam and the combustion gases.
The thermal efficiency of the combined cycle.
Homework Answers
Add Answer to:
Consider the combined gas-steam power cycle,The topping cycle is a gas-turbine cycle that has a pressure ratio of 8.Air enters the compressor at 300K and the turbine at 1300K.The isentropic efficiency...
2. Consider a combined gas steam power cycle. The gas cycle is a simple Brayton cycle...
2. Consider a combined gas steam power cycle. The gas cycle is a
simple Brayton cycle that has a pressure ratio of 7. Air enters at
9.8 kg / s at the compressor at 15 ° C and 100 kPa, and at the gas
turbine at 950 ° C. The steam cycle is a Rankine cycle with
overheating between the pressure limits of 6 MPa and 10 kPa. The
water vapor is heated in the heat exchanger at a rate...
1. A combined gas-steam power cycle uses a single gas turbine cycle for the air cycle...
1. A combined gas-steam power cycle uses a single gas turbine
cycle for the air cycle and a simple Rankine cycle for the water
vapor cycle. Atmospheric air enters the compressor at a rate of
88.2 lbm / s, at 14.7 psia and 59 ° F, and the maximum gas cycle
temperature is 1,742 ° F. The pressure ratio in the compressor is
7. The isentropic efficiency of both the compressor and the turbine
is 80%. Gas exits the heat...
A combined gas-steam power plant uses a simple gas turbine for the topping cycle and a...
A combined gas-steam power plant uses a simple gas turbine for
the topping cycle and a simple Rankine cycle for the bottoming
cycle. Atmospheric air enters the compressor at 101 kPa and 20 °C,
and the maximum gas cycle temperature is 1100 °C. The
compressor pressure ratio is 8. The gas stream leaves the heat
exchanger at the saturation temperature of the steam flowing
through the heat exchanger. Steam enters the heat exchanger at a
pressure of 6 MPa and...
Problem 2/2 (50%) -The gas-turbine cycle of a combined gas-steam power plant has a pressure ratio...
Problem 2/2 (50%) -The gas-turbine cycle of a combined gas-steam power plant has a pressure ratio of 12. Air enters the compressor at 310 K and the turbine at 1400 K. The combustion gases leaving the gas turbine are used to heat the steam at 12.5 MPa to 500 C in a heat exchanger. The combustion gases leave the heat exchanger at 247"C. Steam expands in a high pressure turbine to a pressure of 2.5 MPa and is reheated in...
The gas turbine cycle of a gas-steam combined cycle power plant has a pressure ratio of...
The gas turbine cycle of a gas-steam combined cycle power plant has a pressure ratio of 12. The air enters the compressor at 310 K and 100 kPa (1) and the turbine at 1400 K (3). The combustion gases leaving the gas turbine (4) are used to heat the steam to 12.5 MPa up to 500 °C (6) in a heat exchanger. The flue gas exits the heat exchanger (5) at 247 °C. The steam is expanded in a high...
Problem 1 0/5 points (0%) Consider a combined gas-steam power plant that has a net power...
Problem 1 0/5 points (0%) Consider a combined gas-steam power plant that has a net power output of 500 MW. The pressure ratio of the gas-turbine cycle is 12. Air enters the compressor at 308 K and the turbine at 1300 K. The combustion gases leaving the gas turbine are used to heat the steam at 9 MPa to 360°C in a heat exchanger. The combustion gases leave the heat exchanger at 460 K. An open feedwater heater incorporated with...
Problem4 (a) (40 points) A combined gas-steam powe cycles. The ideal Brayton and Rankine plant operates on Rankine cycle has a reheater. The Brayton cycle operates on a gas- of the gas-turbine c...
Problem4 (a) (40 points) A combined gas-steam powe cycles. The ideal Brayton and Rankine plant operates on Rankine cycle has a reheater. The Brayton cycle operates on a gas- of the gas-turbine cycle 1400 K The 15MPa to ercooling, reheating, and regeneration cycle. The pressure ratio 300 K for compressor stages is do Air enters compressors a combustion gases leaving the lower pressure gas turbine are used to heat the steam at C in a heat exchanger. The combustion gases...
A combined gas–steam power plant has been designed with a net power output of 450 MW....
A combined gas–steam power plant has been designed with a net power output of 450 MW. The pressure ratio of the gas-turbine cycle is 14. Air enters the compressor at 300 K and the turbine at 1400 K. The combustion gases leaving the gas turbine are used to heat the steam at 8 MPa to 400 C in a heat exchanger. The combustion gases leave the heat exchanger at 460 K. An open feedwater heater incorporated with the steam cycle...
Section B – combined cycles Overview: a combined gas – steam power cycle in Sweden provides...
Section B – combined cycles Overview: a combined gas – steam power cycle in Sweden provides electricity and hot water for heating duties for a small city. The gas turbine drives an electricity generator with an efficiency of 97%. A sub-critical coal fired boiler is used as a heat recovery steam generator, as well as providing additional steam from coal during the winter months. The steam turbine drives an electricity generator with an efficiency of 95%. The plant is located...
MECH 3312 (Thermodynamics) Extra Credits01 Spring 2019 Q2.0 The gas-turbine portion of a combined...
MECH 3312 (Thermodynamics) Extra Credits01 Spring 2019 Q2.0 The gas-turbine portion of a combined gas-steam power plant has a pressure ratio of 18. Air enters the compressor at 350 K at a rate of 15.5 kg/s and is heated to 1580 K in the combustion chamber. The combustion gases leaving the gas turbine are used to heat the steam to 417'C at 10 MPa in a heat exchanger. The combustion gases leave the heat exchanger at 430 K. The steam...
2. Consider a combined gas steam power cycle. The gas cycle is a
simple Brayton cycle that has a pressure ratio of 7. Air enters at
9.8 kg / s at the compressor at 15 ° C and 100 kPa, and at the gas
turbine at 950 ° C. The steam cycle is a Rankine cycle with
overheating between the pressure limits of 6 MPa and 10 kPa. The
water vapor is heated in the heat exchanger at a rate...
1. A combined gas-steam power cycle uses a single gas turbine
cycle for the air cycle and a simple Rankine cycle for the water
vapor cycle. Atmospheric air enters the compressor at a rate of
88.2 lbm / s, at 14.7 psia and 59 ° F, and the maximum gas cycle
temperature is 1,742 ° F. The pressure ratio in the compressor is
7. The isentropic efficiency of both the compressor and the turbine
is 80%. Gas exits the heat...
A combined gas-steam power plant uses a simple gas turbine for
the topping cycle and a simple Rankine cycle for the bottoming
cycle. Atmospheric air enters the compressor at 101 kPa and 20 °C,
and the maximum gas cycle temperature is 1100 °C. The
compressor pressure ratio is 8. The gas stream leaves the heat
exchanger at the saturation temperature of the steam flowing
through the heat exchanger. Steam enters the heat exchanger at a
pressure of 6 MPa and...
Problem 2/2 (50%) -The gas-turbine cycle of a combined gas-steam power plant has a pressure ratio of 12. Air enters the compressor at 310 K and the turbine at 1400 K. The combustion gases leaving the gas turbine are used to heat the steam at 12.5 MPa to 500 C in a heat exchanger. The combustion gases leave the heat exchanger at 247"C. Steam expands in a high pressure turbine to a pressure of 2.5 MPa and is reheated in...
Problem 1 0/5 points (0%) Consider a combined gas-steam power plant that has a net power output of 500 MW. The pressure ratio of the gas-turbine cycle is 12. Air enters the compressor at 308 K and the turbine at 1300 K. The combustion gases leaving the gas turbine are used to heat the steam at 9 MPa to 360°C in a heat exchanger. The combustion gases leave the heat exchanger at 460 K. An open feedwater heater incorporated with...
Problem4 (a) (40 points) A combined gas-steam powe cycles. The ideal Brayton and Rankine plant operates on Rankine cycle has a reheater. The Brayton cycle operates on a gas- of the gas-turbine cycle 1400 K The 15MPa to ercooling, reheating, and regeneration cycle. The pressure ratio 300 K for compressor stages is do Air enters compressors a combustion gases leaving the lower pressure gas turbine are used to heat the steam at C in a heat exchanger. The combustion gases...
MECH 3312 (Thermodynamics) Extra Credits01 Spring 2019 Q2.0 The gas-turbine portion of a combined gas-steam power plant has a pressure ratio of 18. Air enters the compressor at 350 K at a rate of 15.5 kg/s and is heated to 1580 K in the combustion chamber. The combustion gases leaving the gas turbine are used to heat the steam to 417'C at 10 MPa in a heat exchanger. The combustion gases leave the heat exchanger at 430 K. The steam...
Most questions answered within 3 hours.
-
3) What are the typical social structures in a global city?
asked 19 minutes ago -
Luther Corporation
Consolidated Balance Sheet
December 31, 2019 and 2018 (in $ millions)
Assets
2019
2018...
asked 21 minutes ago -
(Expected rate of return and risk) Carter Inc. is evaluating a
security. Calculate the investment’s expected...
asked 3 hours ago -
What specific indicators can point to lack of progress for
African Americans in American society?
asked 4 hours ago -
1-The Electrons in a beam are moving at 2.7×108 m/s in an
electric field of 15000...
asked 4 hours ago -
A gas tank is a vertical cylinder. It has a radius of 1m, a
height of...
asked 4 hours ago -
Accent Software faces the following conditions. All of these
support Accent’s use of a market-penetration pricing...
asked 5 hours ago -
A mathematically inclined friend emails you the following
instructions: "Meet me in the cafeteria the first...
asked 5 hours ago -
A monopoly sells in two countries . The demand curves in the two
countries are p1...
asked 6 hours ago -
A .15kg rubber ball is bounced off a wall. Before hitting the
wall, the ball moves...
asked 7 hours ago -
A manufacturing company preparing to build a new plant is
considering three potential locations for it....
asked 7 hours ago -
B. If compound Y has approximately the same values of solubility
in toluene as compound X,...
asked 8 hours ago