What is the color of the product?[1] What do you observe when the product is left...
1.25 g of CuSO4.5 H2O is treated with excess ammonia, when a deep blue solution is obtained. To this solution 5 mis of ethanol is added and the solid copper sulfate tetramine sulfate is obtained on filtration using a Buchner filter. On drying, the mass of the filter paper (085g) and compound is found to be 1.12 grams Calculate the percent yield? [6]
for this experiment of syntheis of aspirin, was the product
obtained pure (based on color)? how do you know? the color was
white
Experimental Procedure HAZARD: Sulfuric acid, acetic anhydride and glacial acetic acid are corrosive to the skin. They are also irritants, and all operations in which these substances are used should be carried out under the hood. Prepare a hot-water bath by heating a 400-ml beaker containing about 200 mL of water. 1. Use a centigram balance and...
PartA: Penny-→ Cu2+(aq) Make sure it is dated prior to 1982. Record mass to nearest 0.001 I. Weigh a copper penny. grams. 2. Place 450 mL of distilled water in a clean 600-mL beaker. Place the beaker on a hotplate and heat until the water boils. Do not wait for the water to boil now, but proceed with the rest of the experiment. You will need this water for rinsing in step C3. CAUTION. You will generate poison°แs nitrogen dioxide...
the 3 pages deal with limiting reactant and percentage yield.
the mixture starts out as a bright blue and when spinning in the
cup smokes ans starts to tirn a black color and the end result is a
brown color. then the funnel part was a light blue color.
1. Weigh approximately 7.0 g of CuCl2 and place them in the 100 ml beaker. Record the exact mass in the data table below. Note the appearance of the CuCl2 crystals...
question#1
Experiment 17A. A Solubility Product Constant Procedure Getting Started 1. Obtain a 10 ml pipet, a 50 mL buret, and 2 pieces of 120 cm filter paper Preparing Saturated Solutions of M10J MIO), is an insoluble divalent iodate salt. The identity of the cation M-is unknown. 1 Prepare MIO,), by adding S0 ml of o.2 M KIO, to 20 mL of 1 Molar M(NO,J, in a 150 mt 2. Stir the mixture vigorously with a stirring rod. A white,...
Determine the percent yield of copper.
3. What is the theoretical yield of copper produced by this reaction? Materials: Copper (II) chloride • Aluminum foil • Stirring rod • Two 100 ml beakers • Graduated cylinder • Safety glasses • Spatula or scoopula • Balance Filter paper front counter Funnel • Watch glass Ring stand • Iron ring Safety: Safety glasses must be worn at all times! Copper (II) chloride is an irritant and moderately toxic. Avoid inhaling the powder...
THE EMPIRICAL FORMULA OF SELECTED HYDRATES experiment PROCEDURE THIS EXPERIMENT SHOULD BE DONE IN PAIRS. 1. Available to you should be: a Büchner funnel, a rubber funnel adapter, side-arm filter flask, thick-walled rubber tubing, plastic forceps and a plastic spatula. 2. Before you turn the hotplate on, wipe the hotplate down with a damp paper towel. During this experiment you will be placing filter paper containing products directly onto the surface of the hotplate. As such, you will want to...
1. what is the percent yield if 16.75g of product is obtained when the theoretical yield is 22.74g? 2. Which property that is used to determine if a chemical reaction has occurred can also the result of physical changes. -formation of a solid -formation of a gas -presence of a flame - change of color -change in temperature 3. The evaporation of water is endothermic as shown in the equation H2O (l) > H2O (g) H= +44.01 kJ What mass...
Please help with question 3. Thank you!
Disposal of waste: When necessary, all organic waste must be disposed into the organic waste container, all aqueous waste to the aqueous waste container and all solid waste to the solid waste container. Nothing is disposed in the sink or trash can. Synthesis of acetanilide In a dry small conical vial, dissolve 300 mg (or 30 drops) of freshly distilled aniline in 1.0 mL of 1.0 M hydrochloric acid. Swirl the mixture to...
#5 Write the solubility product expression for PbCl2.
Using the concentration for the Pb+2 and Cl- ions, solve for your
experimental Ksp.
#6 Using your book, find the theoretical Ksp for PbCl2
to determine your percent error
A Solubility Product Constant Introduction: Many substances are very soluble in water. However, in this experiment you will be concerned with substances that are insoluble or only slightly soluble. Dynamic equilibrium is established when an excess of a slightly soluble substance is placed...