Homework Answers
Add Answer to:
Example 3. Consider a Thin layer chromatography experiment of compounds A, B, C and D using...
Example 3. Consider a Thin layer chromatography experiment of compounds A, B, C and D using 50:50 Acetone : Eth...
Example 3. Consider a Thin layer chromatography experiment of compounds A, B, C and D using 50:50 Acetone : Ether showed four spots under UV light (3 points) a) Calculate the Rf values for all spots A, B and C-show your work b) Match spots A, B, C and D with the four compounds below? solvent front O Die A B C D OH
2. The diagram below shows the results of a simple thin layer chromatography experiment. height reached...
2. The diagram below shows the results of a simple thin layer chromatography experiment. height reached by the solvent the "solvent font a) Describe briefly, but precisely, what you would have done in order to get to this stage. You can assume that you have been given a suitable thin layer chromatography plate. b) Why is there a cover on the beaker? c) In order to help identify the things in a chromatogram, you can measure the Rf value for...
Which of the following statements regarding thin layer chromatography are TRUE? Partition chromatography separates compounds based...
Which of the following statements regarding thin layer chromatography are TRUE? Partition chromatography separates compounds based on how they distribute themselves between the stationary and mobile phases. In thin layer chromatography, a polar organic compound will be attracted to the adsorbent and therefore travel further up the plate than a non-polar compound The Rf value is independent of the adsorbent material used. In thin layer chromatography, a polar organic compound will be repelled by the adsorbent and therefore travel not...
A chemist runs a thin–layer chromatography (TLC) plate and, after development, forgets to mark the solvent...
A chemist runs a thin–layer chromatography (TLC) plate and, after development, forgets to mark the solvent front. The chemist doesn\'t realize this until the solvent has evaporated. Assuming that accurate Rf values are needed, select the correct course of action for the chemist. a. Assume that the solvent front is at the top of the plate. b. Dip the plate in phosphomolybdic acid (PMA) and heat the plate with a heat gun. c. Run the TLC analysis of these samples...
Problem 1 Thin layer Chromatography consist of three parts: The analyte, the stationary phase and mobile...
Problem 1 Thin layer Chromatography consist of three parts: The analyte, the stationary phase and mobile phase. Match each of these terms to what is was in out experiment. Stationary Phase ____ a) The solvent Mobile Phase ____ b) Silica Analyte ____ c) One of the analgesiscs Problem 2 Complete the sentences Analytes on a TLC should have a(n) _________ Rf in a less polar solvent. Analytes on a TLC should have a(n) _________ Rf in a more polar solvent....
Thin layer chromatography was performed on an unknown substance. The substance separated into two spots: A...
Thin layer chromatography was performed on an unknown substance. The substance separated into two spots: A AND B. Spot A travelled 3.85 cm and Spot B travelled 5.98cm. The colvent travelled 7.54 cm. 1.) Which of the two components (A or B) was more attracted to the stationary phase? Explain 2.) Calculate the Rf and of A and B. (show work) 3.) An analysis on an unknown showed one spot with an Rf of 0.52. Which component was the unknown,...
Case C Thin Layer Chromatography 1. TOXI-LAB is a screening method that uses: chromatography (column /...
Case C Thin Layer Chromatography 1. TOXI-LAB is a screening method that uses: chromatography (column / planar) The first step consists of the extraction of drug metabolites from biological fluids when we place the sample in a test tube containing a mixture of solvents and buffering salts that cause the extraction of basic and neutral drugs. The solvent extract of the sample is concentrated by heat and evaporation, then is deposited onto a small disc of chromatographic media (small circle...
2. An unknown compound was analyzed using thin layer chromatography, its constituted of two components (A...
2. An unknown compound was analyzed using thin layer chromatography, its constituted of two components (A and B) as shown in the TLC (Silica coated stationary phase; Chloroform and Ethyl acetate as mobile phase). The mixture was then loaded onto column with silica as the stationary phase and the same solvent system was used. (2 points) Column Chromatography TLC time A В Predict the order of elution of the compounds (A and B). which one would be eluted first/last and...
Thin Layer Chromatography (TLC) is a common technique that is routinely used in chemistry labs. It...
Thin Layer Chromatography (TLC) is a common technique that is routinely used in chemistry labs. It is simple, inexpensive, and very useful. Select the TRUE statement. More polar compounds travel faster on a TLC plate than less polar compounds. If compound A has a smaller Rf value than compound B, we can conclude that compound A is more polar than B. The stationary phase of a TLC silica gel plate is nonpolar. Rr is calculated as the distance traveled...
Can someone please help me out with the Rf value PLEASE!! Thin Layer Chromatography Procedures 1)...
Can someone please help me out with the Rf value
PLEASE!!
Thin Layer Chromatography Procedures 1) Prepare a solvent solution in a 150 mL beaker by using 5 mL of Hexane and 3 mL of ethyl acetate Take one plate and spot (small spots) it with the three different standard solutions given. The standard solutions are 2-nitroaniline, 3-nitroaniline, and 4-nitroaniline. The fourth spot will be the unknown sample obtained. 2) 3) Align these spots at 1 cm from the bottom...
Example 3. Consider a Thin layer chromatography experiment of compounds A, B, C and D using 50:50 Acetone : Ether showed four spots under UV light (3 points) a) Calculate the Rf values for all spots A, B and C-show your work b) Match spots A, B, C and D with the four compounds below? solvent front O Die A B C D OH
2. The diagram below shows the results of a simple thin layer chromatography experiment. height reached by the solvent the "solvent font a) Describe briefly, but precisely, what you would have done in order to get to this stage. You can assume that you have been given a suitable thin layer chromatography plate. b) Why is there a cover on the beaker? c) In order to help identify the things in a chromatogram, you can measure the Rf value for...
Case C Thin Layer Chromatography 1. TOXI-LAB is a screening method that uses: chromatography (column / planar) The first step consists of the extraction of drug metabolites from biological fluids when we place the sample in a test tube containing a mixture of solvents and buffering salts that cause the extraction of basic and neutral drugs. The solvent extract of the sample is concentrated by heat and evaporation, then is deposited onto a small disc of chromatographic media (small circle...
2. An unknown compound was analyzed using thin layer chromatography, its constituted of two components (A and B) as shown in the TLC (Silica coated stationary phase; Chloroform and Ethyl acetate as mobile phase). The mixture was then loaded onto column with silica as the stationary phase and the same solvent system was used. (2 points) Column Chromatography TLC time A В Predict the order of elution of the compounds (A and B). which one would be eluted first/last and...
Can someone please help me out with the Rf value
PLEASE!!
Thin Layer Chromatography Procedures 1) Prepare a solvent solution in a 150 mL beaker by using 5 mL of Hexane and 3 mL of ethyl acetate Take one plate and spot (small spots) it with the three different standard solutions given. The standard solutions are 2-nitroaniline, 3-nitroaniline, and 4-nitroaniline. The fourth spot will be the unknown sample obtained. 2) 3) Align these spots at 1 cm from the bottom...
Most questions answered within 3 hours.
-
What is meant by a “term premium”?
What can explain such a premium? Is it a...
asked 49 minutes ago -
23. Which molecule has only covalent bonds? A. CO2 B. Al2O3 C.
Mg3N2
24. The octet...
asked 1 hour ago -
the
total pressure for a mixture of N2O4 and NO2 is 2.20 atm. If Kp=
7.10...
asked 1 hour ago -
Delaware Corp. prepared a master budget that included $22,385
for direct materials, $28,600 for direct labor,...
asked 1 hour ago -
For pesticide HCB (hexachlorobenzene), its logarithmic partition
coefficient log Kow is 5.6. What would be the...
asked 1 hour ago -
A chemist requires 0.422 mil Na2CO3 for a reaction. How many
grams does this correspond to?
asked 1 hour ago -
If the vapor pressure of carvone is approximately 9.4 torr at 99
°C, approximately how much...
asked 1 hour ago -
A juice bottling company is carrying out a test at 10%
significance that the mean population...
asked 1 hour ago -
What is the reflectivity (in percent) needed to keep water at a
temperature near its freezing...
asked 1 hour ago -
Suppose that the average surface temperature of Earth is 300K.
Assume this is uniform over its...
asked 1 hour ago -
Draw the condensed structural formula for alkenes and alkynes or
the line-angle structural formula for cycloalkenes...
asked 1 hour ago -
M. Laing has suggested a new arrangement of the periodic table
(J.Chem.Ed.1989, 66,
746). Answer the following...
asked 2 hours ago