A uniform, 8.0 m long, 1000 kg beam is resting on the floor and supported by...
2. (10 points) (Based upon 11.45 and 11.46) A uniform, 8.00-m beam is hinged to a wall and supported by a thin cable attached 2.00 m from the free end of the beam, as shown in the figure. Label the horizontal and vertical components of the contact force (where the beam touches 40.0 2.0 m the wall) as H and V. If the magnitude of FH is H- 5340 N, find the magnitude of V. Do your calculations with at...
A 2.0 m long uniform beam is supported by a cable as shown below. The cable is at an angle of 35 degree to the horizontal and has a tension of 300 N. Find the vertical and horizontal forces of the hinge and the mass of the beam.
The figure shows a uniform, horizontal beam (length = 10.0 m, mass = 30.0 kg) that is held by a horizontal pin (pivoted at the wall), with its far end supported by a cable that makes an angle of 51 degree with the horizontal. A person of mass M stands 3.00 magnitude of 454 N. (a) Calculate the mass M of the person standing on the beam? (b) What are the horizontal and vertical components of the force the pin...
13. A non-uniform beam 4.50 m long and weighing 1.35 kN makes an angle 25o below the horizontal. It is supported by a cable 3.0 m farther down the beam and perpendicular to it. The center of gravity of the beam is 2.0 m down the beam from the pivot. Lightning equipment exerts a 5.00 kN downward force on the lower left end of the beam. Find tension T in the cable 4 points 25 Pivot Cable Center of gravity...
A 15 kg uniform beam, 2 m in length, is supported at it's end by a cable as shown below. The angle between the cable and the horizontal is 45 degrees. 2. Cable Beam Find the horizontal and vertical components of the force from the hinge (left end of the beam) acting on the beam a. b. If the tension in the cord exceeds 115N, the cord will break. Will placing a 5 kg mass at the right end of...
blem 1. A 8.0 m long, non-uniform beam weighing 750 N, supported by two weightless cables, is at rest in horizontal position, as shown. The cable on the right has a tension of Tj-375\3 N. (a) The location of the center of mass of the beam measured from its left end is (b) The tension T2 in the other cable is 60 T2 30 т, fiction). The
Please answer all parts of question (a-c). 4:45 PM 33% AT&T Notes May 1, 2019 at 4:45 PM Problem 1 a) A uniform beam (5.00 m long, 40.0 kg) is attached to the wall and supported by a cable at the far end, as shown. A 60.0 kg box is placed in the middle of the beanm What is the tension in the cable? b) A wheel in the shape of a solid disk (mass 250 g, radius 30.0 cm)...