2) The filter unit can remove 70% of turbidity from the source,Water The efflueht concentration of...
( Water & Westwater Treatment Curse ) b) Design of a Sand Filter A 1) Design a new sand filter for a small operation. The est rate for this site is 1880 m/day. The surface overflow ra exceed 145 m3/m2/d. What will be the surface area of the f can use some leftover Ottawa sand (dzo - 0.00055m) from your filtration project. How deep should the filter be? (C3) (5) te shod You 2) The filter unit can remove 70%ofturbidity...
It is required that a wastewater flow of 2 MGD with a strength of 300 mg/L BOD5 be treated to remove 90% of the BOD5. To achieve this, a 25-ft deep filter will be constructed and plastic media will be used. A treatability study has shown that n = 0.5 and K= 0.05 min-1 at 20⁰C. If the critical wastewater temperature is expected to be 10⁰C, what size filter should be required? Recirculation will not be used. Use Excel and...
An ion exchange resin is used to remove nitrate from a water supply with the ionic concentrations found below. The total resin capacity is 1.5 equivalents per liter of resin. a) Do the anions and cations balance? b) What volume of water can be treated with each liter of resin? c) Qualitatively, how would your answer differ if the concentration of CI^- and SO_4^2- were reversed?
solve part C part D and E 4. A wet scrubber uses lime to remove HCI from a gas waste stream. The scrubber operation characteristics are as follows: Scrubber efficiency Minimum gas velocity 90% 2.5 m/s 18 m3/s 120 ppm, by volume . Gas flow rate HCL Concentration Calculate: a) Scrubber diameter b) HCL removal rate, kg/day c) Required stoichiometric CaO loading, kg/day (theoretical) d) If the lime is only available in a 12% slurry concentration, what is the field...
Treating Drinking Water Phosphate can be removed from drinking-water supplies by treating the water with Ca(OH)2. How much Ca(OH), is required to remove 90% of the PO43-from 4.5 × 106 L of drinking water containing 25 mg/L of PO
We are trying to remove tetrachloroethene (C_2Cl_4) from ground water by air stripping process. The maximum level of tetrachloroethene in the ground water is 5 mg/L and this must be reduced to 50 mu g/L using air stripping column. Here is given information; Liquid-phase mass transfer (m/sec) kL = 19.86 times 10^-4 m/sec Wetted packing area (m^2/m^3), a_w = 89.18 m^2/m^3 gas-phase mass transfer (m/sec), k_G = 4.94 times 10^-3 m/sec liquid flow rate, Q_w = 8L/sec Temperature = 6...
For each filter mentioned in the following cases, first simulate the circuit using Multisim. You can get a plot of the transfer function that is called the Bode plot. From the right toolbar, select "Bode Plotter". Change initial (I) and final (F frequencies to 1Hz and 200 KHz, respectively. Use a Voltage AC source as the input signal. You do not need to change any parameter from voltage AC source Connect "Bode Plotter" to input and output of your circuit...
#3 An absorber is to be used to remove acetone from air entering gas stream is 2 mole % acetone and enters at a rate of 40 kmol/hr. The water enters at a rate of 120 kmol hr. Both streams enter at 293 K and 1.4 atm pressure. We wish to remove 90 % of the entering acetone in this column. a. What is the minimum water flow to accomplish this separation? b. How many equilibrium stages would be required...
Molar concentration 1. How many of NaCl is in 2002 M solution Atomic N C 2. How many of 0.25 M solution can be prepared from 20 g of N . Alemi mass Na-23 8. Oog.Hulg 3. How many ml of water must be added to 600 ml of 0.5 M KCl solution 4 M solution? Atomis mass: K:19. C1-35.5g Ans. 150 4. 200 ml of 0.5 M solution of NaCl was added to 300 ml of 2M solution of...
Name: ID: 2. The activated sludge process can be used to remove organic carbon (BOD) and nitrogen species (ammonia, nitrite and nitrate) from wastewater. The schematic below is a of the 4-stage Bardenpho process that can achieve low levels of ammonia and nitrate in the final effluent). Please describe how BOD and nitrogen species concentrations evolve in each stage, include what the return activated sludge, the internal mixed liquor return, and the methanol injection are used for. "nitrite does not...