Chapter 26, Problem 085 A 30 μF capacitor is connected across a programmed power supply. During...
Chapter 26, Problem 085 A 35 μF capacitor is connected across a programmed power supply. During the interval from t-o to t-3.00 s the output voltage of the supply is given by V(t)-6.00 + 4.00t-2.002 volts. At t 1.00 s find (a) the charge on the capacitor, (b) the current into the capacitor, and (c) the power output from the power supply. (a) Number 2.8E-4 (b) Number (c) Number Units Units Units
A capacitor and a resistor that are in series are initially connected to a power supply with 22 volts. The power supply is then cut-off and the capacitor begins to discharge through the resistor. At t = 20 s, the voltage across the capacitor drops to 7 volts. What is the resistance of the resistor, in mega ohms (MΩ) if the capacitance, C = 7 μF ? Please give your answer in two decimal places.
nment MESSAGE MY İNSTRUCTOR FULL SCREEN : PRINTER VERSION : BACK NEXT Chapter 32, Problem 009 In the figure a uniform electric field is directed out of the page within a circular region of radius R electric at radial distances (a)2.50 cm and (b)7.00 cm? 3.50 cm. The magnitude of the (4.00 x 10 V/mes)t, where t is in seconds. What is the magnitude of the magnetic field that is induced c field is given by E Units Units (a)...
Chapter 23, Problem 07 A capacitor is connected across an ac generator whose frequency is 1000 Hz and whose peak output voltage is 160 V. The rms current in the circuit is 3.2 A. (a) What is the capacitance of the capacitor? (b) What is the magnitude of the maximum charge on one plate of the capacitor? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. + 99 V sin 20...
(a) A capacitor of capacitance 220 μF is connected in series with a 150 kΩ resistor, a switch and an ammeter. A d.c. power supply of negligible internal resistance is connected to the circuit as shown below 1 50 kΩ 220HF A stopclock is started and after 10 seconds the switch S is closed Ammeter readings are noted at regular intervals until a time of 80s is shown on the stopclock. The graph below shows how the current in the...
Chapter 10, Problem 034 The figure gives angular speed versus time for a thin rod that rotates around one end. (a) What is the magnitude of the rod's angular acceleration? (b) At t = 4.0 s, the rod has a rotational kinetic energy of 5.58 ). What is its kinetic energy at t - 0? 0 (rad/s) t(s) (a) Number (b) Number Units Units Click if you would like to Show Work for this question: Open Show Work LINK TO...
I will rate ! Problem 27: A 13-Q resistor, 42-μF capacitor, and 3.5-mH mductor are connected in series with an AC source of amplitude 14 V and frequeney 135 Hz. Part (a) What is the impedance of the eireuit, in ohms? Numerie A nueric value is expeeted and not an e Part (b) What is the amplitude of the eurrent in the eircuit, in amperes? Numerie A numerie value is expected and not an expression. Part (c) What is the...
NEXT Chapter 11, Problem 034 A partide is to move in an xy plane, clock wise around the origin as seen from the positive side of the z axis. In unit vector notation, what torque acts on the ts angular momentum about the origin is (a)5.3 kg-m2/s, (b)5.3t2 kgm2/s, (o)5.3t/2 kg-m2/s/2, and (d)5.3/ ko m2s (a) Number (b) Number (c) Number (d) Number k Units k Units k Units k Units VIDEO MINI-LECTURE LINK TO SAMPLE PROBLEM
RUCTOR FULL SCREEN PRINTER VERSION BACK NEXT Chapter 10, Problem 041 In the figure, two particles, each with mass m - 0.91 kg, are fastened to each other, and to a rotation axis at 0, by two thin rods, each with length d = 5.4 cm and mass M = 1.3 kg. The combination rotates around the rotation axis with angular speed w = 0.33 rad/s. Measured about o, what is the combination's (a) rotational Inertia and (b) kinetic energy?...
ILIR YELL Announcements CES PRINTER VERSION BACK NEXT Chapter 14, Problem 059 Water is moving with a speed of 6.4 m/s through a pipe with a cross-sectional area of 3.6 cm2. The water gradually descends 9.4 m as the pipe increases to 8.0 cm2. (a) What is the speed at the lower level? (b) If the pressure at the upper level is 1.4 x 105 Pa, what is the pressure at the lower level? (a) Number Units (b) Number Units...