Calculate the temperature change needed for a cylinder of copper to increase in length by 0.30%....
Calculate the temperature change needed for a cylinder of copper to increase in length by 0.30%. The relevant coefficient of linear expansion is 16.5*10-6 (Express your answer to two significant figures.)
Homework Answers
Add Answer to:
Calculate the temperature change needed for a cylinder of copper
to increase in length by 0.30%....
The temperature coefficient of resistance α in equation R(T)=R0[1+α(T−T0)] equals the temperature coefficient of resistivity α...
The temperature coefficient of resistance α in equation R(T)=R0[1+α(T−T0)] equals the temperature coefficient of resistivity α in equation ρ(T)=ρ0[1+α(T−T0)] only if the coefficient of thermal expansion is small. A cylindrical column of mercury is in a vertical glass tube. At 20 ∘C, the length of the mercury column is 12.0 cm. The diameter of the mercury column is 1.6 mm and doesn't change with temperature because glass has a small coefficient of thermal expansion. The coefficient of volume expansion of...
A 22.0-m-long bar of steel expands due to a temperature increase. A 11.0-m-long bar of copper...
A 22.0-m-long bar of steel expands due to a temperature
increase. A 11.0-m-long bar of copper also gets longer due to the
same temperature rise. The two bars were originally separated by a
gap of 1.6 cm. Assume the steel and copper bars are fixed on the
ends, as shown in the following figure.
1)
Calculate the change in temperature if the gap is exactly
"closed" by the expanding bars. (Express your answer to two
significant figures.)
Answer in K...
When the temperature of a copper coin is raised by 130 C°, its diameter increases by...
When the temperature of a copper coin is raised by 130 C°, its diameter increases by 0.22%. To two significant figures, give the percent increase in (a) the area of a face, (b) the thickness, (c) the volume, and (d) the mass of the coin. (e) Calculate the coefficient of linear expansion of the coin.
Part C - Calculate the load P required for a length change of 0.01 in A...
Part C - Calculate the load P required for a length change of 0.01 in A 6061-T6 aluminum tube is used as a sleeve for a steel post (Tool L2), as shown. When not loaded, and at a temperature of 60°F, both the tube and post have a length of 24 in The system is subjected to a load P and the temperature is increased to 115°F. Assume that both the tube and post are rigidly connected to the rigid...
A hollow aluminum cylinder 16.5 cm deep has an internal capacity of 2.000 L at 16.0°C....
A hollow aluminum cylinder 16.5 cm deep has an internal capacity of 2.000 L at 16.0°C. It is completely filled with turpentine at 16.0°C. The turpentine and the aluminum cylinder are then slowly warmed together to 70.0°C. (The average linear expansion coefficient for aluminum is 24 ✕ 10−6°C−1, and the average volume expansion coefficient for turpentine is 9.0 ✕ 10−4°C−1.) (b) What is the volume of turpentine remaining in the cylinder at 70.0°C? (Give your answer to at least four...
A 13 cm-diameter cylinder contains argon gas at 10 atm pressure and a temperature of 55...
A 13 cm-diameter cylinder contains argon gas at 10 atm pressure and a temperature of 55 degree C. A piston can slide in and out of the cylinder. The cylinder's initial length is 23 cm. 2300 J of heat are transferred to the gas, causing the gas to expand at constant pressure. What is the final temperature of the cylinder? Express your answer to two significant figures and include the appropriate units. What is the final length of the cylinder?...
Part A Review What is the final temperature of the cylinder? Express your answer to two...
Part A Review What is the final temperature of the cylinder? Express your answer to two significant figures and include the appropriate unit:s A 12 cm -diameter cylinder contains argon gas at 10 atm pressure and a temperature of 55 piston can slide in and out of the cylinder. The cylinder's initial length is 17 cm.2300 J of heat are transferred to the gas, causing the gas to expand at constant pressure | Tfinal= Value Units Submit Request Answer Part...
A 12 cm -diameter cylinder contains argon gas at 10 atm pressure and a temperature of...
A 12 cm -diameter cylinder contains argon gas at 10 atm pressure and a temperature of 50 °C. A piston can slide Part in and out of the cylinder. The cylinder's initial length is 21 cm. 2700 J of heat are transferred to the gas, What is the final temperature of the cylinder? causing the gas to expand at constant pressure. Express your answer to two significant figures and include the appropriate units. ? degC Value TTinal Request Answer Submit...
Chapter 18, Problem 014 When the temperature of a copper coin is raised by 140 Co,...
Chapter 18, Problem 014 When the temperature of a copper coin is raised by 140 Co, its diameter increases by 0.24%. To two significant figures, give the percent increase in (a) the area of a face, (b) the thickness, (c) the volume, and (d) the mass of the coin. (e) Calculate the coefficient of linear expansion of the coin. (a) Number (b) Number (c) Number (d) Number (e) Number Units Units Units Units Units
Thin strips of brass and copper of equal length are used to construct a bimetallic strip....
Thin strips of brass and copper of equal length are used to construct a bimetallic strip. When the strip is heated, due to the difference in the coefficient of linear expansion of the two metals, the brass strip will have a greater increase in length than the copper strip, causing them to bend into an arc with the brass on the outside of the curve. When the temperature of s by 25.8 C, the angle subtended by the two ends...
A 22.0-m-long bar of steel expands due to a temperature
increase. A 11.0-m-long bar of copper also gets longer due to the
same temperature rise. The two bars were originally separated by a
gap of 1.6 cm. Assume the steel and copper bars are fixed on the
ends, as shown in the following figure.
1)
Calculate the change in temperature if the gap is exactly
"closed" by the expanding bars. (Express your answer to two
significant figures.)
Answer in K...
Part C - Calculate the load P required for a length change of 0.01 in A 6061-T6 aluminum tube is used as a sleeve for a steel post (Tool L2), as shown. When not loaded, and at a temperature of 60°F, both the tube and post have a length of 24 in The system is subjected to a load P and the temperature is increased to 115°F. Assume that both the tube and post are rigidly connected to the rigid...
A 13 cm-diameter cylinder contains argon gas at 10 atm pressure and a temperature of 55 degree C. A piston can slide in and out of the cylinder. The cylinder's initial length is 23 cm. 2300 J of heat are transferred to the gas, causing the gas to expand at constant pressure. What is the final temperature of the cylinder? Express your answer to two significant figures and include the appropriate units. What is the final length of the cylinder?...
Part A Review What is the final temperature of the cylinder? Express your answer to two significant figures and include the appropriate unit:s A 12 cm -diameter cylinder contains argon gas at 10 atm pressure and a temperature of 55 piston can slide in and out of the cylinder. The cylinder's initial length is 17 cm.2300 J of heat are transferred to the gas, causing the gas to expand at constant pressure | Tfinal= Value Units Submit Request Answer Part...
A 12 cm -diameter cylinder contains argon gas at 10 atm pressure and a temperature of 50 °C. A piston can slide Part in and out of the cylinder. The cylinder's initial length is 21 cm. 2700 J of heat are transferred to the gas, What is the final temperature of the cylinder? causing the gas to expand at constant pressure. Express your answer to two significant figures and include the appropriate units. ? degC Value TTinal Request Answer Submit...
Chapter 18, Problem 014 When the temperature of a copper coin is raised by 140 Co, its diameter increases by 0.24%. To two significant figures, give the percent increase in (a) the area of a face, (b) the thickness, (c) the volume, and (d) the mass of the coin. (e) Calculate the coefficient of linear expansion of the coin. (a) Number (b) Number (c) Number (d) Number (e) Number Units Units Units Units Units
Thin strips of brass and copper of equal length are used to construct a bimetallic strip. When the strip is heated, due to the difference in the coefficient of linear expansion of the two metals, the brass strip will have a greater increase in length than the copper strip, causing them to bend into an arc with the brass on the outside of the curve. When the temperature of s by 25.8 C, the angle subtended by the two ends...
Most questions answered within 3 hours.
-
1. What is the meaning of the term communication style?
2. What are the benefits to...
asked 37 minutes ago -
9.) You are buying a car that cost $26,500. You make payments of
$412 each month...
asked 1 hour ago -
. Suppose a discrete random variable has probability
distribution
P(x) = .2 if x = 0...
asked 2 hours ago -
Problem #1
The area between Z = 0 and Z = 2.50
The area between Z...
asked 1 hour ago -
Under the influence of its drive force, a snowmobile is moving
at a constant velocity along...
asked 2 hours ago -
Why do organizations decline? What steps can top
management take to halt, decline, and restore organizational...
asked 2 hours ago -
What mechanisms Drive speciation??
(I.e. what was Dawins theory on the orgin of species, and how...
asked 4 hours ago -
The manager at a car assembly plant believes that the mean
assembly time for a car...
asked 5 hours ago -
Which of the following is true of electron capture?
A) It decreases the nuclide's mass number...
asked 6 hours ago -
Assuming an efficiency of 43.10%, calculate the actual yield of
magnesium nitrate formed from 114.9 g...
asked 7 hours ago -
The highly pathogenic bacterium Clostridium
perfringens causes gangrene, a disease that results in the
destruction of...
asked 8 hours ago -
In the context of situation analysis, which of the following is
a category for analysis in...
asked 8 hours ago