Problem 4 A generator with an internal resistance of RG = 1202 produces a 5us square...
A DC voltage Vs is applied to a lossless transmission line of length L, with characteristic impedance Zo and propagation velocity Up. The line is terminated in a short circuit. Draw the "bounce diagram" for the voltage along the line as a function of time for the following cases: a) Rs = 1/3Zo b) Rs = 3Zo c) Rs= Zo Where Rs is the source impedance. For the case Rs= Zo plot the voltages at both ends of the line...
A rectangular pulse of an amplitude 27 V and a duration 1 µs is applied via a series resistor Rg to the terminals of a lossless transmission line of length l = 400m terminated in a load resistance RL. The phase velocity of waves on the line is up =3 × 108 m/s. (a) Using the bounce diagram, sketch the voltage and current at the mid-point of the transmission line (z = l/2) for 0 < ?< 3 µs. (b)...
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect a sinusoidal source with internal resistance Rs=50 2, and 10 Volts peak value to feed a load of ZL=300 Q. At an operating signal wavelength of do, the length of the transmission line is L=2.25o. Determine the followings: a) Standing wave ratio on the line b) Average power delivered to the load in dBm. c) The voltage and current phasor expressions on the transmission...
answer number 3 and 4 Problem 7. Transmission Lines The figure below shows a transmission line with a characteristic impedance Z,-50 Ω, connected to a single frequency generator with an internal impedance R,-50 C (not shown), and terminated in a purely resistive load RL 50 2. At the frequency of the generator, the wavelength of the transmission line is λ = 2 m. At a distance dl-1.25 m away from the load, a shorted stub is connected via a tee....