A rectangular pulse of an amplitude 27 V and a duration 1 µs is applied via a series resistor Rg to the terminals of a lossless transmission line of length l = 400m terminated in a load resistance RL. The phase velocity of waves on the line is up =3 × 108 m/s.
(a) Using the bounce diagram, sketch the voltage and current at the mid-point of the transmission line (z = l/2) for 0 < ?< 3 µs. (b) Using the bounce diagram, sketch the voltage and current on the line at ? = 2 µs
Homework Answers
Add Answer to:
A rectangular pulse of an amplitude 27 V and a duration 1 µs is
applied via...
Problem 4 A generator with an internal resistance of RG = 1202 produces a 5us square...
Problem 4 A generator with an internal resistance of RG = 1202 produces a 5us square pulse with an open-circuit voltage of Ve 5V. The pulse travels at half the speed of light on a 3km lossless transmission line with a characteristic impedance of Zo= 1800 that is terminated with a load resistance of R 902. Use a bounce diagram to construct a voltage vs. time plot for the voltage signal observed at the center point of the transmission line,...
A DC voltage Vs is applied to a lossless transmission line of length L, with characteristic...
A DC voltage Vs is applied to a lossless transmission line of length L, with characteristic impedance Zo and propagation velocity Up. The line is terminated in a short circuit. Draw the "bounce diagram" for the voltage along the line as a function of time for the following cases: a) Rs = 1/3Zo b) Rs = 3Zo c) Rs= Zo Where Rs is the source impedance. For the case Rs= Zo plot the voltages at both ends of the line...
A 6 m section of a lossless transmission line has a distributed capacitance C = 33.33...
A 6 m section of a lossless transmission line has a distributed capacitance C = 33.33 pF/m and a distributed inductance L = 0.75 μH/m. The transmission line is driven by a generator operating at 40 MHz, with a voltage Vg = 4.33 - 2.5j V and a source impedance Zg = 150 Ω. The line is terminated by a load ZL= 150 – j50 Ω. Calculate the current drawn from the source.
A 2.5 meter long section of Zo=50 12 lossless coaxial transmission line is connected to a...
A 2.5 meter long section of Zo=50 12 lossless coaxial transmission line is connected to a source with vg(t) = 10 sin(611 10't + 60°) (V) and Zg=150 12. If the line, which uses insulating material with a relative permittivity of &r=4, is terminated in a load ZŁ=(100 – j 50) (2, determine: (a) Wavelength a on the line. (b) The reflection coefficient I at the load. (c) The input impedance at the source. (d) The voltage phasor V; at...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
Q1. A transmission line has Zo-Z,-150 Ω and ZL-50 Ω. The propagation velocity on the line is 200 m/us and the line is 800 m long. At time t-0, a single voltage pulse of 16 V and 1 us duration is tran...
Q1. A transmission line has Zo-Z,-150 Ω and ZL-50 Ω. The propagation velocity on the line is 200 m/us and the line is 800 m long. At time t-0, a single voltage pulse of 16 V and 1 us duration is transmitted by the generator. Using relevant equations and diagrams, discuss the voltage and current pulse behavior on the line.
Q1. A transmission line has Zo-Z,-150 Ω and ZL-50 Ω. The propagation velocity on the line is 200 m/us and...
(4) A voltage source of V40-V cos (ot) (o-2 π. 106 rad/s) drives a transmission line...
(4) A voltage source of V40-V cos (ot) (o-2 π. 106 rad/s) drives a transmission line (Zo -100 Ω, length λ/8) terminated with a resistor R1 00 Ω in parallel with an inductor L -16 μΗ. What are the input impedance, the input voltage Vin (t) and load voltage VL(t)? What power is dissipated in resistor R? 2 -100
Past exam question, 2010 The following questions concern the voltage V(z, t) along a 3-m long...
Past exam question, 2010 The following questions concern the voltage V(z, t) along a 3-m long lossless line characterised by Zo = 50 and u, 0.66c. The line is fed by Ug = 80 V, and Ra a step voltage at t 0 with generator voltage = 752. The line is terminated with ZL = 252 (a) Compute the voltage reflection coefficients at both the load and generator ends, and show that the travel time along the line is 10ns....
Consider the circuit shown below. V, changes from 0 V to 1.5 V at t =...
Consider the circuit shown below. V, changes from 0 V to 1.5 V at t = 0 and remains at 1.5V. The transmission line has air between the conductors. {= 6 cm Rs=1502 WO w RL= 450 12 Vo=1.5V ( Zo=502 a) Find the following reflection coefficients: i. Tų (refl. coeff. at the load) ii. I's (refl. coeff. at the source) b) Complete the bounce diagram below by finding the values of the voltage pulses Vi+, Vi V2+, V2, V3+...
3. A system of two transmission lines connected in series are driven by a voltage source fi(t) Vo...
3. A system of two transmission lines connected in series are driven by a voltage source fi(t) Vou(t) and terminated by a resistive load of 60S2 as shown in the figure below. A switch is closed at t 0 and the positive voltages are measured for 5 μs giving the bounce diagram shown in the figure-the voltage values indicated in the diagram correspond to delta function weights times the source voltage products such as VOTg, VOTg(1 +「2), etc. 400 m...
Problem 4 A generator with an internal resistance of RG = 1202 produces a 5us square pulse with an open-circuit voltage of Ve 5V. The pulse travels at half the speed of light on a 3km lossless transmission line with a characteristic impedance of Zo= 1800 that is terminated with a load resistance of R 902. Use a bounce diagram to construct a voltage vs. time plot for the voltage signal observed at the center point of the transmission line,...
A 2.5 meter long section of Zo=50 12 lossless coaxial transmission line is connected to a source with vg(t) = 10 sin(611 10't + 60°) (V) and Zg=150 12. If the line, which uses insulating material with a relative permittivity of &r=4, is terminated in a load ZŁ=(100 – j 50) (2, determine: (a) Wavelength a on the line. (b) The reflection coefficient I at the load. (c) The input impedance at the source. (d) The voltage phasor V; at...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
Q1. A transmission line has Zo-Z,-150 Ω and ZL-50 Ω. The propagation velocity on the line is 200 m/us and the line is 800 m long. At time t-0, a single voltage pulse of 16 V and 1 us duration is transmitted by the generator. Using relevant equations and diagrams, discuss the voltage and current pulse behavior on the line.
Q1. A transmission line has Zo-Z,-150 Ω and ZL-50 Ω. The propagation velocity on the line is 200 m/us and...
(4) A voltage source of V40-V cos (ot) (o-2 π. 106 rad/s) drives a transmission line (Zo -100 Ω, length λ/8) terminated with a resistor R1 00 Ω in parallel with an inductor L -16 μΗ. What are the input impedance, the input voltage Vin (t) and load voltage VL(t)? What power is dissipated in resistor R? 2 -100
Past exam question, 2010 The following questions concern the voltage V(z, t) along a 3-m long lossless line characterised by Zo = 50 and u, 0.66c. The line is fed by Ug = 80 V, and Ra a step voltage at t 0 with generator voltage = 752. The line is terminated with ZL = 252 (a) Compute the voltage reflection coefficients at both the load and generator ends, and show that the travel time along the line is 10ns....
Consider the circuit shown below. V, changes from 0 V to 1.5 V at t = 0 and remains at 1.5V. The transmission line has air between the conductors. {= 6 cm Rs=1502 WO w RL= 450 12 Vo=1.5V ( Zo=502 a) Find the following reflection coefficients: i. Tų (refl. coeff. at the load) ii. I's (refl. coeff. at the source) b) Complete the bounce diagram below by finding the values of the voltage pulses Vi+, Vi V2+, V2, V3+...
3. A system of two transmission lines connected in series are driven by a voltage source fi(t) Vou(t) and terminated by a resistive load of 60S2 as shown in the figure below. A switch is closed at t 0 and the positive voltages are measured for 5 μs giving the bounce diagram shown in the figure-the voltage values indicated in the diagram correspond to delta function weights times the source voltage products such as VOTg, VOTg(1 +「2), etc. 400 m...
Most questions answered within 3 hours.
-
Your friend is interested in the characteristics of fast tree
planters. He searched through the records...
asked 5 minutes ago -
. 0.67 g of Ag is deposited electrolytically from
AgNO3 after a certain period of time...
asked 6 minutes ago -
assuming that the boric acid, h3po3 present at the end of the
borax tritation has a...
asked 5 minutes ago -
When a carbonate solution is acidified, carbon dioxide is
produced.
2H+(aq) + CO32-(aq) → H2O(l) +...
asked 45 minutes ago -
A reaction has the following rate law: Rate =
kr[A][B]2. In experiment 1, the
concentrations of...
asked 42 minutes ago -
king owns a large number of public pay phones. as rhe use of
payphones decline deamatically,...
asked 46 minutes ago -
3.7 - A book is sitting on a table. The mass of the book
is 1...
asked 1 hour ago -
Which term describes the process by which a single strand of DNA
serves as a template...
asked 1 hour ago -
LAB FOOD DRING
ANSWER THE QUESTIONS:
Q1. What value is the moisture content versus time and...
asked 1 hour ago -
You are told that an object has zero acceleration. Two forces on
the object are: F_1...
asked 1 hour ago -
The usual starting point for preparing a master budget is
forecasting or estimating:
Multiple Choice
Sales....
asked 1 hour ago -
How to make a simple game in pygame where an object is randomly
falling from the...
asked 1 hour ago