2. A refrigeration cycle has Qout = 1000 Btu and Wevele = 300 Btu. Determine the...
A refrigeration cycle operating has a coefficient of performance B=1.8 for cycle Qout=250KJ. Determine Qin and Wcycle each in KJ.
At steady-state, a refrigeration cycle operating between hot and cold reservoirs at 300 K and 275 K, respectively, removes energy by heat transfer from the cold reservoir at a rate of 600 kW. (a) If the coefficient of performance is 4, determine the power input required, in kW (b) Determine the minimum theoretical power required for any such cycle.
At steady-state, a refrigeration cycle operating between hot and cold reservoirs at 300 K and 275 K, respectively, removes energy by heat transfer from the cold reservoir at a rate of 600 kW. (a) If the coefficient of performance is 4, determine the power input required, in kW (b) Determine the minimum theoretical power required for any such cycle.
Consider a 300 kJ/min refrigeration system that operates on an ideal vapor-compression refrigeration cycle with R-134a as the working fluid. The refrigerant enters the compressor as saturated vapor at 140 kPa and is compressed to 800 kPa. Show the cycle on a T-s diagram with respect to saturation lines and determine (a) the quality of the refrigerant at the end of the throttling process, (b) coefficient of performance, (c) the power input to the compressor , (d) Generation of entropy...
2. (10 points) An ideal vapor-compression refrigeration cycle is modified to include a counter- flow heat exchanger, as shown below. Ammonia leaves the evaporator as saturated vapor at 1.0 bar and is heated at constant pressure to 5 "C before entering the compressor. Following isentropic compression to 18 bar, the refrigerant passes through the condenser, exiting at 40 C, 18 bar. The liquid then passes through the heat exchanger, entering the expansion valve at 18 bar. If the mass flow...
Problem #1 [30 Points] Vapor Compression Refrigeration Cycle An ideal vapor compression refrigeration system cycle, with ammonia as the working fluid, has an evaporator temperature of -20°C and a condenser pressure of 12 bar. Saturated vapor enters the compressor, and saturated liquid exits the condenser. The mass flow rate of refrigerant is 3 kg/minute. Determine the coefficient of performance and the refrigerating capacity in tons. Given: Find: T-s Process Diagram: Schematic Assume:
the coefficient of performance of an irreversible The coefficient of performance of a reversible refrigeration cycle is always refrigeration cycle when each operates between the same two thermal reservoirs. greater than equal to less than
(a) (i) For a power cycle, the heat transfers are Qin=60 kJ and Qout=40 kJ. Determine the net work, in kJ, and the thermal efficiency. (ii) A refrigeration cycle operates with a coefficient of performance β=1.5. For the cycle, Qout=500 kJ. Determine Qin and Wcyele each in kJ.(b) A gas within a piston-cylinder assembly undergoes a thermodynamic cycle consisting of three processes:Process 1-2: Compression with p V= constant, from p₁=1 bar, V₁=1.6 m³ to V₂=0.2 m³, U₂-U₁=0.Process 2-3: Constant pressure to...
Consider an ideal refrigeration cycle that has a condenser temperature at 45°C and an evaporator temperature of -15°C. Show the process in a T-S diagram. Determine the coefficient of performance of this refrigerator for refrigerant 134a as the working fluid. Repeat the calculation for ammonia.
4. Consider an ideal refrigeration cycle that has a condenser temperature at 45°C and an evaporator temperature of -15°C. Show the process in a T-S diagram. Determine the coefficient of performance of this refrigerator for refrigerant 134a as the working fluid. Repeat the calculation for ammonia.