the question above is the
extra information that is needed
the question above is the extra information that is needed Calculate alpha values for the following...
Titration: Acids and Bases
2. How can you determine which acid is diprotic?
3. using the answers to questions one and two, which acid is
diprotic?
4. Which base has more hydroxide ions per molecule?
Acid Volume Base Base Initial Volume (mL) Base Final Volume (mL) Volume of Base Used (mL) Acid: Base Ratio Acid 1 20 mL Base 1 50 mL 34.5 15.5 4:3 Acid 2 20 mL Base 1 Acid 1 20 mL Base 2 Acid 2 20...
A buffer solution is able to maintain a constant pH when small amounts of acid or base are added to the buffer. Consider what happens when 1 mL of a 5 M solution is added or 0.005 mol of HCl are added to a 100.0 mL solution acetic acid buffer that contains 0.0100 mol of Acetic acid, HC,H,O,, and 0.0100 mol of sodium acetate, NaC,H,O,. The initial concentration of both the acid and the base are 0.0100 mol/ 0.1000 L...
i want answer to all questions please
Answer: 29) Consider the following generalized buffer solution equilibrium: When a small amount of a strong base such as sodium hydroxide is added to the solution, which of the four species shown would experience an increase in concentration? A) BH B)H C) HO D)B E None of the species would increase in concentration. Answer: ( 30) What is true about a solution whose pH is less than 7 at 25°C? A) It has...
the two photos above are information need so solve the
question below
Practice 08: Reactions With Multiple Pathways Key In the presence of O ferrous ion, Fe is oxidized to ferrie lon, Fet. The rate law for this reaction depends on the pH, following one rate law when the pH is greater than 3.6 and a different rate law when the pH IN below 3.5. Part 1: pH > 3.5 The following initial rates (defined is greater than 3.5. ***/dt)...
I
know some of the measured pH values are a little off due to error
in the lab, but I need help filling out the “Ion Hydrolyzed” table
and then the “Net Ionic Equation” part. I remember doing net ionic
equations in General Chemistry I, bit don’t see how it applies
here.
Thanks, in advance! (i will rate!)
Learning Objectives: 1. To test the acidic and basic properties of ionic compounds. 2. To create a buffer solution and calculate its...
I need help with the problem in the last photo.. I thought I’d
post my lab explanation and data if that helps you get a better
understanding, but it’s just the question at the end. I know I need
to use the Henderson Hasselbach equation.. so... 4.70 = pKa + log(
[acetate-ion] / [acetic-ion] ) and solve for pKa, then Ka.. but how
do I find the concentrations to put in the log fraction?
Thanks, in advance!
Learning Objectives: 1....
I need helo on question #12. I solved the problem but the
percent error is a large number. Are my calculations correct?
Titration of a weak unknown acid: Name: Noora Hamil Unknown acid A Mass of the Unknown acid: Volume NaOH added (letter or number on the unknown bottle) 0.19 Concentration of NaOH(aq):_01705 M рн 0.5 2.5 2.61 2.6u 2.67 2.69 2.73 2.77 2.81 2.86 2 .93 3.04 3.13 3.23 3.37 3 .5 u u.s 5:5 6.5 3.59 7.5 u.co...
Our teacher said.....for this book
Page286....
His Question is, calculate the three endpoints
in page 286.
For the P.286, I take some pics.below....
We were unable to transcribe this image(3) Geochemical or charge-balance definition (8.38) where BC are base cations (principally Na+. K+. Ca2. Mg). and SA are strong acid anions (principally CI SO) Of course, the three definitions define essentially the same property of water, but each emphasizes a different aspect of alkalinity, respectively: () the way we measure...
can
someone help me answer these 5 questions and figire this graph out
please?
Acid-Base Titration of a Weak Acid with a Strong Base: Determination of K. Introduction: You will be titrating a solution of a weak acid with 0.100 M NaOH, while monitoring the reaction using a pH meter. Weak acids have characteristic acid-ionization constants, K. The purpose of this lab is to use the titration to determine the value of this constant for the weak acid called “benzoic...
It's a weak acid strong base titration
Experiment 4: Identification of an unknown acid by titration Page 2 of 15 Background In this experiment, you will use both qualitative and quantitative properties to determine an unknown acid's identity and concentration. To do this analysis, you will perform a titration of your unknown acid sample-specifically a potentiometric titration where you use a pH meter and record pH values during the titration, combined with a visual titration using a color indi- cator...