obtain the transfer function (Y/X) and the disturbance function (Y/D)
obtain the transfer function (Y/X) and the disturbance function (Y/D) - FF - + - P...
Find transfer function by differential method A-2-11. Obtain the transfer function of the system defined by 1 10x 0 0 -2 x y= [1 0 01x2
3. (10 points) Simplify the following block diagram and obtain the transfer function from s) to Y(s) input output + Y(s) X(s) 8+2 s+ 2 3. (10 points) Simplify the following block diagram and obtain the transfer function from s) to Y(s) input output + Y(s) X(s) 8+2 s+ 2
Xs) H/(%) Fig. 2. System with disturbance a) Draw its corresponding Signal-Flow graph model b) Obtain the transfer function G(s) = Y(s)/T1(s) using Mason's formula based on the Signal-Flow graph model. Assume that R(s)0.
02 Obtain the transfer function Y(s)yU(s) of the system shown in Figure. The vertical motion u at point P is the input. This system is a simplified version of an automobile or motorcycle suspension system. (In the figure mi and ki represent the wheel mass and tire stiffness, respectively.) Assume that the displacements x and y are measured from their respective equilibrium positions in the absence of the input u. Use Newton second law to derive the movement equations.
• For the realization of the following state table using D-FF, find the input function of A-FF. (Fig. 01) x=1 x=0 x=1 A B AB у 0 0 0 0 x=0 AB 00 11 11 00 0 1 01 10 01 0 1 1 0 1 0 1 1 0 0 10 Fig. 01 DA = f(X,A,B)= 2m (1, 2, 5, 7) LA DA = f(X,A,B)= 2m (0, 1, 4, 7) DB. DA=f(x,A,B)= 2m (1, 3, 4, 6) DA =...
Question 3 (10 pts): Consider the closed-loop system pictured below, with two inputs: the reference input z (ideally, to be tracked by output y) and a "disturbance" input d. (Note the minus sign at the bottom entry of the summing junction on the left.) Block H and G represent LTI systems; H has transfer function HL and G has transfer function GL. All blocks are causal (so that the closed-loop system is causal as well). Both z and d are...
mwu Q3. a) Consider the mechanical system shown, obtain the transfer function x(s)/P(s), assuming all initial conditions are zeros. (10 marks) Ž p3k, у b) For the question in part (a), assuming that m = 20 kg, b2 = 12 N.s/m, K1 = 20 N/m, K2 = 35 N/m and P=1 N. Write a MATLAB program to produce the response curve x(t). (15 Marks)
Obtain the transfer function Y(s)/U(s) of the system m2 k2 m1 ki Lu
Simplify the following block diagram. Obtain the transfer function from R to C for Fig. 1, and the transfer function from X(s) to Y(s) for Fig. 2.Convert the block diagram of figures 1 and 2 to a signal flow graph.Below are the diagrams:
Consider the function: 10x2 + 2x + 2.5 = f(s) Obtain: 1.) the transfer function X(s)/F(s) treating f(t) as a unit step function 2.) the transfer function X(s)/F(s) treating f(t) as a unit impulse function Plot both responses using Matlab and explain the differences