Question 1: A 45-N vertical force P is applied at A to the bracket shown, which...
Question 1 (10 Marks) Three forces are applied on a steel bracket as is shown in Figure 1. Given that the resultant force acting on the steel bracket is 1000 N in x direction, what are the magnitude (F) and 250 N 75 45° 500 N Figure 1
A 43 N horizontal force is applied to the handle of the industrial water valve as shown. The force is perpendicular to the vertical place containing line OA of the handle. Determine the equivalent force- couple system at point O. A 43-N horizontal force is applied to the handle of the industrial water valve as shown. The force is perpendicular to the vertical plane containing line OA of the handle. Determine the equivalent force-couple system at point O. 155 mm...
P A a koto C a B b A 475 N force is applied at A to the rolled-steel section shown. Replace that force with an equivalent force-couple system at the center C of the section. If a = 150 mm, b = 75 mm, c = 75 mm. Magnitude of the force C (N, 3 sigfig) a B Lo b A 475 N force is applied at A to the rolled-steel section shown. Replace that force with an equivalentforce-couple...
Figure 2 of 3 Part C - Analyzing another force-couple system on a bracket The same bracket and force-couple system as that in Part B (F=159 lb, F = 53 lb, and M-590 lb-ft) is set up again, only this time, the resultant force is to be applied to the horizontal member CB.(Figure 2)Replace this force and couple system with an equivalent force by specifying the magnitude of the force, the direction in which the force acts, and where the...
Question 1 As shown in Figure 1, the belt passing over the pulley is subjected to two forces F1 and F, each having a magnitude of 40 N. Fl acts in the-k direction. Take θ-45°. a) Replace these forces by an equivalent force and couple at point A. Express the result in vector form in the coordinate system shown. Replace the force-couple at point A by a single resultant force R passing through b) pulley and determine the y and...
four forces are applied to the machine component ABDE as shown. Replace the forces by an equivalent force couple system at A
QUESTION Two farces of 500 N and 300 N act on a bracket as shown, (a) The magnitude of the total moment of the two orces about point is a single force, (b) the magnitude of this single force is |NCm. When the two forces acting on thee bracket are reduced into N and (c) it would be looated 2 Momeot and Conple on a Bracket of 50 NCn in the clockwise direction is to be applied to the bracket...
Replace the forces acting on the L-shaped bracket with the following force-couple systems. Neglect the thickness of the bar in your calculations. (Express the resultant forces in vector form in newtons.) 290 NA 190 mm 480N 190 mm cDE I 190 mm 190 mm 190 N (a) an equivalent force-couple system that acts at point A Indicate the magnitude in N.m and direction of the couple moment, magnitude Nm direction -Select- (b) an equivalent force-couple system that acts at point...
Question 3 points Save Answer An angle bracket is subjected to the forces and couple as shown below. Consider clockwise from horizontal as to be positive for moments and angles. Detemine the equivalent force-couple system at A. 30cm 200N 150 N 13 em 15 cm 50 N-m 150 N 92 N at 174.1-103 Nm 114 N at 15350 Nm 292 N at-5.9, 103 Nm 333 N at 42.9, 53 Nm Question2 3 points Save Answer The loading shown requires a...
four forces are applied to the machine component ABDE as shown. Replace the forces by an equivalent force couple system at A