Homework Answers
No. In the first part of the experiment, the combination reaction between zinc and iodine occurs. Here, the zinc metal was initially in zero oxidation state which then oxidized to +2 state. But iodine was initially in 0 oxidation state which is reduced to -1 state in the same reaction.
In the second part of the experiment, the decomposition reaction of zinc iodide is described. Here zinc was initially in +2 oxidation state and it is reduced to zero oxidation state. However, iodine in zinc iodide was initially in -1 oxidation state. It is oxidized to zero oxidation state.
So, in the first and second parts, different species are oxidized.
Add Answer to:
4. In parts I and II of this experiment, were the same atoms oxidized? Explain. 83...
Determine the percent yield of copper. 3. What is the theoretical yield of copper produced by...
Determine the percent yield of copper.
3. What is the theoretical yield of copper produced by this reaction? Materials: Copper (II) chloride • Aluminum foil • Stirring rod • Two 100 ml beakers • Graduated cylinder • Safety glasses • Spatula or scoopula • Balance Filter paper front counter Funnel • Watch glass Ring stand • Iron ring Safety: Safety glasses must be worn at all times! Copper (II) chloride is an irritant and moderately toxic. Avoid inhaling the powder...
Heat lamp or drying oven Hydrated copper chloride Distilled water Aluminum wire 30-ml beaker Glass rod...
Heat lamp or drying oven Hydrated copper chloride Distilled water Aluminum wire 30-ml beaker Glass rod Watch glass Buchner fiannel Hot plate Ethanol Füter paper CAUTION: Wear all safety equipment, follow all normal safety procedures and experiment as directed by your instructor follow instructions. Dispose of all liquid AND solid waste products from the 1. Weigh a clean, dry 30-mL beaker and record its mass to 3 decimal places. When-it-is-time,heat the beaker 2. Add approximately 1.00 gram of the hydrated...
i need help answering the questions plz and thanks! Experiment 9 Report Sheet: Calculations and Questions...
i need help answering the questions plz and thanks!
Experiment 9 Report Sheet: Calculations and Questions Calculations 1. Determine which of the two starting materials is the limiting reagent, then determine the theoretical yield of [Cu(NH3)]SO4+H20. 2. Determine the percent yield after the first crystallization. Is this a valid percent yield? Explain. 3. Determine the percent yield of the second crystallization. Conclusion On the back of this page write a conclusion that comments on what you were trying to accomplish...
THE EMPIRICAL FORMULA OF SELECTED HYDRATES experiment PROCEDURE THIS EXPERIMENT SHOULD BE DONE IN PAIRS. 1....
THE EMPIRICAL FORMULA OF SELECTED HYDRATES experiment PROCEDURE THIS EXPERIMENT SHOULD BE DONE IN PAIRS. 1. Available to you should be: a Büchner funnel, a rubber funnel adapter, side-arm filter flask, thick-walled rubber tubing, plastic forceps and a plastic spatula. 2. Before you turn the hotplate on, wipe the hotplate down with a damp paper towel. During this experiment you will be placing filter paper containing products directly onto the surface of the hotplate. As such, you will want to...
Please help! (These are the instructions I had) 1) Preparation of K2[Cu(C2O4)2] 2H2O CuSO4•5H2O + 2K2C2O4•H2O...
Please help! (These are the instructions I had) 1) Preparation of K2[Cu(C2O4)2] 2H2O CuSO4•5H2O + 2K2C2O4•H2O → K2[Cu(C2O4)2]•2H2O + K2SO4 + 5H2O Heat a solution of 2.5g of potassium oxalate monohydrate in 12.5mL of water contained in a 50mL beaker (approx. 90°C). Heat 1.55g of copper sulfate pentahydrate in 3mL of water to about 90°C and add it rapidly, with vigorous stirring to the hot potassium oxalate solution. Set on the bench and allow to cool to room temperature then...
Introduction The chemical reactions involved in this experiment are: CuSO4(aq) + Zn(s) → ZnSO4(aq) + Cu(s)...
Introduction The chemical reactions involved in this experiment are: CuSO4(aq) + Zn(s) → ZnSO4(aq) + Cu(s) Zn(s) + H2SO4(aq) → ZnSO4(aq) + H2(g) The copper on the surface quickly reacts with oxygen according to the following reaction: 2Cu(s) + O2(g) → 2CuO(s) Experimental Procedure Dissolve completely about 0.5 to 0.7 g of copper (II) sulphate pentahydrate in about 10 to 20 mL of deionized water. Calculate the amount of zinc powder that must be added to a copper sulfate solution...
PartA: Penny-→ Cu2+(aq) Make sure it is dated prior to 1982. Record mass to nearest 0.001 I. Weig...
PartA: Penny-→ Cu2+(aq) Make sure it is dated prior to 1982. Record mass to nearest 0.001 I. Weigh a copper penny. grams. 2. Place 450 mL of distilled water in a clean 600-mL beaker. Place the beaker on a hotplate and heat until the water boils. Do not wait for the water to boil now, but proceed with the rest of the experiment. You will need this water for rinsing in step C3. CAUTION. You will generate poison°แs nitrogen dioxide...
i did the synthesis of aspirin experiment and got the data below. how do you do...
i did the synthesis of aspirin experiment and got the data
below. how do you do the theoretical yield? percent yield of the
pure aspirin?
DATA: Mass of Salicylic Acid: 2.034g Volume of Acetic Anhydride used in synthesis: 4.00ml Mass of filter paper: 0.196g Mass of filter paper plus Aspirin: 1.868g Mass of Aspirin: 1.672g Percent Yield of Pure Aspirin: I Experimental Procedure HAZARD: Sulfuric acid, acetic anhydride and glacial acetic acid are corrosive to the skin. They are also...
The first picture is used for question #2, and question #3 can be normally answered. I...
The first picture is used for question #2, and question #3 can
be normally answered. I believe the answer to question 3 is ->
0.07144M. However I would like someone to check it. I am not sure
about 2.
BE SURE THAT YOU RECORD ALL OF YOUR DATA AND LABEL PROPERLY FOR PARTI OF THIS LABORATORY EXPERIMENT. YOU WILL NEED TO ACCESS THIS INFORMATION IN THREE WEEKS. Part I Synthesis of the Complex Salt containing Copper Procedure 16.004 1. In...
i need to calculate the theortetical yield by finding the limiting reactant of the experiment by...
i need to calculate the theortetical yield by finding the
limiting reactant of the experiment by converting reactants to
product, then calculate the percent yield using the limiting
reactant
-in my experiment the amout of crystals i obtained was 1.232 g
(watch glass + filter paper = 31.228 g and watch glass, filter
paper, + crystals = 32.460 g)
REACTION SCHEME H сно, ОН- ОСH, CH panisaldehyde acetophenone Molar Mass: 120.15g/mol Molar Mass: 136.15g/mol Molar Mass: 239.30g/mol Density: 1.119g/mL Density:...
Determine the percent yield of copper.
3. What is the theoretical yield of copper produced by this reaction? Materials: Copper (II) chloride • Aluminum foil • Stirring rod • Two 100 ml beakers • Graduated cylinder • Safety glasses • Spatula or scoopula • Balance Filter paper front counter Funnel • Watch glass Ring stand • Iron ring Safety: Safety glasses must be worn at all times! Copper (II) chloride is an irritant and moderately toxic. Avoid inhaling the powder...
Heat lamp or drying oven Hydrated copper chloride Distilled water Aluminum wire 30-ml beaker Glass rod Watch glass Buchner fiannel Hot plate Ethanol Füter paper CAUTION: Wear all safety equipment, follow all normal safety procedures and experiment as directed by your instructor follow instructions. Dispose of all liquid AND solid waste products from the 1. Weigh a clean, dry 30-mL beaker and record its mass to 3 decimal places. When-it-is-time,heat the beaker 2. Add approximately 1.00 gram of the hydrated...
i need help answering the questions plz and thanks!
Experiment 9 Report Sheet: Calculations and Questions Calculations 1. Determine which of the two starting materials is the limiting reagent, then determine the theoretical yield of [Cu(NH3)]SO4+H20. 2. Determine the percent yield after the first crystallization. Is this a valid percent yield? Explain. 3. Determine the percent yield of the second crystallization. Conclusion On the back of this page write a conclusion that comments on what you were trying to accomplish...
PartA: Penny-→ Cu2+(aq) Make sure it is dated prior to 1982. Record mass to nearest 0.001 I. Weigh a copper penny. grams. 2. Place 450 mL of distilled water in a clean 600-mL beaker. Place the beaker on a hotplate and heat until the water boils. Do not wait for the water to boil now, but proceed with the rest of the experiment. You will need this water for rinsing in step C3. CAUTION. You will generate poison°แs nitrogen dioxide...
i did the synthesis of aspirin experiment and got the data
below. how do you do the theoretical yield? percent yield of the
pure aspirin?
DATA: Mass of Salicylic Acid: 2.034g Volume of Acetic Anhydride used in synthesis: 4.00ml Mass of filter paper: 0.196g Mass of filter paper plus Aspirin: 1.868g Mass of Aspirin: 1.672g Percent Yield of Pure Aspirin: I Experimental Procedure HAZARD: Sulfuric acid, acetic anhydride and glacial acetic acid are corrosive to the skin. They are also...
The first picture is used for question #2, and question #3 can
be normally answered. I believe the answer to question 3 is ->
0.07144M. However I would like someone to check it. I am not sure
about 2.
BE SURE THAT YOU RECORD ALL OF YOUR DATA AND LABEL PROPERLY FOR PARTI OF THIS LABORATORY EXPERIMENT. YOU WILL NEED TO ACCESS THIS INFORMATION IN THREE WEEKS. Part I Synthesis of the Complex Salt containing Copper Procedure 16.004 1. In...
i need to calculate the theortetical yield by finding the
limiting reactant of the experiment by converting reactants to
product, then calculate the percent yield using the limiting
reactant
-in my experiment the amout of crystals i obtained was 1.232 g
(watch glass + filter paper = 31.228 g and watch glass, filter
paper, + crystals = 32.460 g)
REACTION SCHEME H сно, ОН- ОСH, CH panisaldehyde acetophenone Molar Mass: 120.15g/mol Molar Mass: 136.15g/mol Molar Mass: 239.30g/mol Density: 1.119g/mL Density:...
Most questions answered within 3 hours.
-
A coach uses a new technique to train gymnasts. Seven
gymnasts were randomly selected and their...
asked 47 minutes ago -
While rotating the tires on your car you notice a rock [mass =
0.1 Kg] stuck...
asked 2 hours ago -
Using MARS simulator, write MIPS programs according to
the following scenarios: Receive a positive integer number...
asked 4 hours ago -
An object in front of a concave mirror has a real image that is
11.5 cm...
asked 4 hours ago -
Consider the reaction, C3 H8 + O2 --> CO2 + H2O. How many
moles of O2...
asked 6 hours ago -
You and your opponent both roll a fair die. If you both roll the
same number,...
asked 6 hours ago -
In a study of the accuracy of fast food drive-through orders,
Restaurant A had 257 accurate...
asked 6 hours ago -
Identify and describe in detail the four categories of
institutions that could be included in a...
asked 6 hours ago -
In python
class Customer:
def __init__(self, customer_id, last_name, first_name, phone_number, address):
self._customer_id = int(customer_id)
self._last_name =...
asked 7 hours ago -
What is an example of a limitation in implementing a new
ERP system and how it...
asked 7 hours ago -
In a section of 9.7cm of an artery with a radius of 2.6mm there
is a...
asked 7 hours ago -
the two carboxylic acid groups of aspartic acid have different
acidities with pKa values of 2.1...
asked 7 hours ago