Homework Answers
Add Answer to:
At a point in a horizontal pipeline, the pressure of the water flowing at a velocity...
Water is flowing through a 600mm diameter horizontal pipe n = 0.013 and 1000m in length....
Water is flowing through a 600mm diameter horizontal pipe n = 0.013 and 1000m in length. A gage pressure downstream has a reading of 16 kPa and another gage in between the ends of the pipe reads 20 kPa while on the upstream side reads 30 kPa. a. Determine the total head loss of the pipe b. Determine the velocity of flow in m/s. c. Determine the rate of discharge in liter per second.
Water flows from one large reservoir to another via a pipeline which is 0.9 m in...
Water flows from one large reservoir to another via a pipeline which is 0.9 m in diameter, 15km long, and for which f-0.04. The difference in height between the water surface levels in the two reservoirs is 50m. (a) Ignoring the minor losses in the pipeline, calculate the flow rate between the two reservoirs. (b) Assuming that the pipeline entrance and exit are sharp and that the minor losses are as in Table 1, calculate the discharge now. What is...
Water is flowing into a factory in a horizontal pipe with a radius of 0.0173 m...
Water is flowing into a factory in a horizontal pipe with a radius of 0.0173 m at ground level. This pipe is then connected to another horizontal pipe with a radius of 0.0300 m on a floor of the factory that is 10.6 m higher. The connection is made with a vertical section of pipe and an expansion joint. Determine the volume flow rate that will keep the pressure in the two horizontal pipes the same.
Please!. I need help PROBLEMS 1. What is the Reynold's number for water flowing in a...
Please!. I need help
PROBLEMS 1. What is the Reynold's number for water flowing in a 24-inch circular pipe at a velocity of 6.21 ft/s? Is the flow laminar or turbulent? 2. Water is flowing in a 2/2-inch pipe with a discharge of 0.150 cfs. Find the Reynold's number for this flow. Is the flow laminar or turbulent? 3. Water is flowing in a 4-inch pipe with a discharge of 4.0 × 10-3 cfs. Find the Reynolds number for this...
(c) A venturi meter is mounted in a pipeline of diameter 150 mm, which is inclined at 30° from the horizontal. Water is flowing upwards through the pipeline. The throat diameter of the venturi meter...
(c) A venturi meter is mounted in a pipeline of diameter 150 mm, which is inclined at 30° from the horizontal. Water is flowing upwards through the pipeline. The throat diameter of the venturi meter is 90 mm. One static pressure tapping is located at the throat and another 0.3 m upstream in the pipeline. The pressure difference measured between the two tappings is 200 mm of mercury. The coefficient of discharge for the meter is 0.97. Determine the actual...
Review A water filled pipe has water flowing at v1= 6.20 m/s in a section of...
Review A water filled pipe has water flowing at v1= 6.20 m/s in a section of pipe where the diameter is d1= 19.2 cm and the pressure is known to be P1= 7.00×104 N/m2 above atmospheric pressure. 1- If the pipe carries the water 3.5 meters up hill without any change in diameter, what is the new absolute pressure within the pipe? 2- After flowing up the hill described above, the pipe narrows to 80% of its original radius, what...
Water is flowing in a straight horizontal pipe of variable cross section. Where the cross-sectional area...
Water is flowing in a straight horizontal pipe of variable cross section. Where the cross-sectional area of the pipe is 3.70·10-2 m2, the pressure is 8.10·105 Pa and the velocity is 0.660 m/s. In a constricted region where the area is 16.90·10-4 m2, what is the velocity? Tries 0/15 What is the pressure (in Pa)? (Assume an ideal fluid)
40. There is a pressure loss of300 kN/m2 when water is pumped through pipeline A at a rate of 2 m/s and there is a pres...
40. There is a pressure loss of300 kN/m2 when water is pumped through pipeline A at a rate of 2 m/s and there is a pressure loss of 250 kN/m2 when w pressure loss which will occur when 1.5 m3/s of water are pumped connected (i) in series, (i) in parallel, assuming that junction losses may be neglected. In the latter case calculate the volume rate of flow through each pipe. (10 marks) m2 when water is pumped through pipeline...
Water at 20 C is steadily flowing through a diverging pipe section that is inclined by...
Water at 20 C is steadily flowing through a diverging pipe section that is inclined by an angle of 30° with respect to the horizontal (See the figure) The total testing section length is 20 m long with an initial pipe diameter of 10 mm (Section 1) and final diameter of 20 mm (Section 2). The small diameter section shows a gage pressure of 100 kPa and average flow velocity 10 m/s. Other values will be obtained by reaching complete...
Water is flowing through a horizontal pipe with an inside diameter of 8.00cm. The pipe narrows...
Water is flowing through a horizontal pipe with an inside diameter of 8.00cm. The pipe narrows to an inside diameter of 3.75cm. Assume the water is an ideal incompressible fluid. What is the velocity of the fluid initially, v_1 (when It is flowing in the 8.00cm diameter section) if the velocity of the water in the narrow part of the pipe is measured at V_2 = 27m/s? If the initial pressure is known to be 670 kPa what is the...
Water flows from one large reservoir to another via a pipeline which is 0.9 m in diameter, 15km long, and for which f-0.04. The difference in height between the water surface levels in the two reservoirs is 50m. (a) Ignoring the minor losses in the pipeline, calculate the flow rate between the two reservoirs. (b) Assuming that the pipeline entrance and exit are sharp and that the minor losses are as in Table 1, calculate the discharge now. What is...
Please!. I need help
PROBLEMS 1. What is the Reynold's number for water flowing in a 24-inch circular pipe at a velocity of 6.21 ft/s? Is the flow laminar or turbulent? 2. Water is flowing in a 2/2-inch pipe with a discharge of 0.150 cfs. Find the Reynold's number for this flow. Is the flow laminar or turbulent? 3. Water is flowing in a 4-inch pipe with a discharge of 4.0 × 10-3 cfs. Find the Reynolds number for this...
(c) A venturi meter is mounted in a pipeline of diameter 150 mm, which is inclined at 30° from the horizontal. Water is flowing upwards through the pipeline. The throat diameter of the venturi meter is 90 mm. One static pressure tapping is located at the throat and another 0.3 m upstream in the pipeline. The pressure difference measured between the two tappings is 200 mm of mercury. The coefficient of discharge for the meter is 0.97. Determine the actual...
40. There is a pressure loss of300 kN/m2 when water is pumped through pipeline A at a rate of 2 m/s and there is a pressure loss of 250 kN/m2 when w pressure loss which will occur when 1.5 m3/s of water are pumped connected (i) in series, (i) in parallel, assuming that junction losses may be neglected. In the latter case calculate the volume rate of flow through each pipe. (10 marks) m2 when water is pumped through pipeline...
Water at 20 C is steadily flowing through a diverging pipe section that is inclined by an angle of 30° with respect to the horizontal (See the figure) The total testing section length is 20 m long with an initial pipe diameter of 10 mm (Section 1) and final diameter of 20 mm (Section 2). The small diameter section shows a gage pressure of 100 kPa and average flow velocity 10 m/s. Other values will be obtained by reaching complete...
Water is flowing through a horizontal pipe with an inside diameter of 8.00cm. The pipe narrows to an inside diameter of 3.75cm. Assume the water is an ideal incompressible fluid. What is the velocity of the fluid initially, v_1 (when It is flowing in the 8.00cm diameter section) if the velocity of the water in the narrow part of the pipe is measured at V_2 = 27m/s? If the initial pressure is known to be 670 kPa what is the...
Most questions answered within 3 hours.
-
Computer Programming II CS141(Java)
Mention the appropriate relationship between following
classes:
HOD–StaffMember
Car–Ferrari
Student-Address
BankAccount–FixedAccount
House-Building...
asked 36 minutes ago -
Assume one of your finals has 50 questions on it, and
lucky for you, it's all...
asked 1 hour ago -
Rice Products in Bangladesh
Business behavior is derived in large part from the basic cultural
environment...
asked 3 hours ago -
The following base sequence is found for a mRNA fragment from
wild-type E. coli: 5'- UAUCAGUAGAUAAUGUAACC-3'...
asked 3 hours ago -
For this exercise, round all regression parameters to three
decimal places.
One of the two tables...
asked 3 hours ago -
What is the 5% level of significance for mean = 3.60, standard
deviation = 0.94, and...
asked 4 hours ago -
Prior to beginning work on this discussion, please read the
article by Hayley Peterson, 15 Companies...
asked 4 hours ago -
Which pair of aqueous solutions, when mixed, will form a
precipitate?
A) NaNO3 and AgC2H3O2
B)...
asked 4 hours ago -
1-Write an algorithm to get two numbers from the user (as
inputs) and calculate the sum...
asked 8 hours ago -
Define white-collar crime. What is the difference between
offender and offense-based definitions of white-collar crime? What...
asked 8 hours ago -
Consider a reaction which is 1st order with respect to A and 1st
order with respect...
asked 8 hours ago -
c++
The length of the hypotenuse of a right-angled triangle is the
square root of the...
asked 9 hours ago