Homework Answers
Add Answer to:
Please find the voltage and power of the circled 100 Ohm
resistor, and then repeat for...
Given the circuit and find the average Power absorbed by the 10 Ohm resistor. Question 4...
Given the circuit and find the average Power absorbed
by the 10 Ohm resistor.
Question 4 [20] Given the circuit of Fig. 3.4 find the average power absorbed by the 100 resistor -50 40 8V 220° ontv 0.1VO 81 50 Fig. 3.4 Question 5 65 lagging power factor and an efficiency
Circuits group exercise Analyze the circuit below, i.e. find the voltage across each resistor and the...
Circuits group exercise Analyze the circuit below, i.e. find the voltage across each resistor and the current through each resistor as well as through the batteries. Finally find the power output of each resistor and of the circuit as a whole. Use the boxes below to show each step of simplification of the circuit using the rules on combining resistors in parallel and in series. (You may not need all four boxes.) Attach extra sheets showing your work. Where applicable,...
I need to find the power dissipated in the circled resistor with detailed steps , the...
I need to find the power dissipated in
the circled resistor with detailed steps , the voltage is 10 V.
I've asked this 4 times and gotten 4 different answers...
Vth = 1.54 Volt Rth = 118.5 ohm Inorton = 13 mAmp a. Draw the Thévenin...
Vth = 1.54 Volt
Rth = 118.5 ohm
Inorton = 13 mAmp
a. Draw the Thévenin and Norton equivalent circuits of the
schematic shown above
b. Connect a 100 Ohm “load” resistor to the terminals of the
original circuit (this means in parallel with R
c. Calculate the voltage across the load resistor, and calculate
its power. Repeat the procedure for a 220 Ohm load.
Resistance (Ohms)
Voltage (Volts)
Power (milliwatts)
100
220
R1 R5 Vout+ 15 100 V1 +...
A 20mH inductor, a 40.0 Ohm resistor, a 50.0 muF capacitor, and voltage source of 100...
A 20mH inductor, a 40.0 Ohm resistor, a 50.0 muF capacitor, and voltage source of 100 e^-100t are connected in series in an electric circuit. Find the charge on the capacitor as a function of time t, if q = 0 and i = 0 when t = 0
If the voltage drop across the 30 Ohm resistor in the figure is 60V from top...
If the voltage drop across the 30 Ohm resistor in the figure is
60V from top to bottom, find:
a) The voltage across the source, Vs
b) The current delivered by the voltage source
c) The power delivered by the voltage source
64 Ω 30Ω Vs 90 Ω 75Ω 50 Ω
4. Calculate the voltage, Vx across 100 ohm resistor. 100Ω 100 kΩ 10Ω 100Ω ΊΜΩ ΊΜΩ
4. Calculate the voltage, Vx across 100 ohm resistor. 100Ω 100 kΩ 10Ω 100Ω ΊΜΩ ΊΜΩ
In the circuit, the battery voltage is 12 V, the resistor has value 100 Ohm, the...
In the circuit, the battery voltage is 12 V, the resistor has value 100 Ohm, the diode turn-on voltage is 0.6 V, and the source is a 60-Hz sine with amplitude 24 V. Determine the fraction of the time (in %) that the diode is conducting ID US(t) = G) Vs sin ar ーVB
Determins the power dissipated by the 4-ohm resistor in the right hand circuit using algebra. Show...
Determins the power dissipated by the 4-ohm resistor in the right
hand circuit using algebra. Show the following calculations.
4. Take a Screenshot of the full circuit board showing all four circuits and save it as "DC Circuit_2.pog". Print it out and submit it with your lab report. 5. Determine the power dissipated by the 4-2 resistor in the left-hand circuit by adding either an ammeter or a voltmeter to the circuit. Use the reading from that meter in calculating...
A small power plant produces a voltage of 10 V and 100 A. The voltage is...
A small power plant produces a voltage of 10 V and 100 A. The voltage is stepped up to 120 by a transformer before it is transmitted to a substation. The resistance of the transmission line between the power plant and the substation is 75 ohm. What is the current in the transmissions line from the plant to the substation. please show all work
Given the circuit and find the average Power absorbed
by the 10 Ohm resistor.
Question 4 [20] Given the circuit of Fig. 3.4 find the average power absorbed by the 100 resistor -50 40 8V 220° ontv 0.1VO 81 50 Fig. 3.4 Question 5 65 lagging power factor and an efficiency
Circuits group exercise Analyze the circuit below, i.e. find the voltage across each resistor and the current through each resistor as well as through the batteries. Finally find the power output of each resistor and of the circuit as a whole. Use the boxes below to show each step of simplification of the circuit using the rules on combining resistors in parallel and in series. (You may not need all four boxes.) Attach extra sheets showing your work. Where applicable,...
I need to find the power dissipated in
the circled resistor with detailed steps , the voltage is 10 V.
I've asked this 4 times and gotten 4 different answers...
Vth = 1.54 Volt
Rth = 118.5 ohm
Inorton = 13 mAmp
a. Draw the Thévenin and Norton equivalent circuits of the
schematic shown above
b. Connect a 100 Ohm “load” resistor to the terminals of the
original circuit (this means in parallel with R
c. Calculate the voltage across the load resistor, and calculate
its power. Repeat the procedure for a 220 Ohm load.
Resistance (Ohms)
Voltage (Volts)
Power (milliwatts)
100
220
R1 R5 Vout+ 15 100 V1 +...
A 20mH inductor, a 40.0 Ohm resistor, a 50.0 muF capacitor, and voltage source of 100 e^-100t are connected in series in an electric circuit. Find the charge on the capacitor as a function of time t, if q = 0 and i = 0 when t = 0
If the voltage drop across the 30 Ohm resistor in the figure is
60V from top to bottom, find:
a) The voltage across the source, Vs
b) The current delivered by the voltage source
c) The power delivered by the voltage source
64 Ω 30Ω Vs 90 Ω 75Ω 50 Ω
4. Calculate the voltage, Vx across 100 ohm resistor. 100Ω 100 kΩ 10Ω 100Ω ΊΜΩ ΊΜΩ
In the circuit, the battery voltage is 12 V, the resistor has value 100 Ohm, the diode turn-on voltage is 0.6 V, and the source is a 60-Hz sine with amplitude 24 V. Determine the fraction of the time (in %) that the diode is conducting ID US(t) = G) Vs sin ar ーVB
Determins the power dissipated by the 4-ohm resistor in the right
hand circuit using algebra. Show the following calculations.
4. Take a Screenshot of the full circuit board showing all four circuits and save it as "DC Circuit_2.pog". Print it out and submit it with your lab report. 5. Determine the power dissipated by the 4-2 resistor in the left-hand circuit by adding either an ammeter or a voltmeter to the circuit. Use the reading from that meter in calculating...
Most questions answered within 3 hours.
-
convert grams into vloume with the density of water being at
.997514 g/cm^3 at 23.1 Celsuis...
asked 1 hour ago -
Foreman company obtained a $20,000, 6% loan on May 1, 2018.
Principal and interest will be...
asked 1 hour ago -
5. Problem 11.05 (Discounted Payback)
eBook
Project L costs $60,000, its expected cash inflows are $14,000
per...
asked 1 hour ago -
1. Which of the following is true about politics and health
organizations?
A. Health organizations are...
asked 2 hours ago -
A space vehicle is coasting at a constant velocity of 18.1 m/s
in the +y direction...
asked 3 hours ago -
5) Use the following balanced equation to answer questions
(a)-(i).
3 Cu(s) + 8 HNO3(aq) →...
asked 2 hours ago -
A three-year maturity bond with a 12% annual coupon rate is
currently traded at par $1000...
asked 2 hours ago -
1.
What is the minimum volume to use in the Spec 20 cuvette in order
to...
asked 3 hours ago -
A builder wants to install wall-to-wall carpeting in a living
room of length 8.87 m and...
asked 3 hours ago -
Organizational change can produce anxiety in those affected by
the change. In what ways can change...
asked 3 hours ago -
Ozone in the atmosphere may react with nitric oxide.
From the following data, calculate the DG...
asked 3 hours ago -
Steven Long, a bond analyst, is analyzing a convertible bond.
The characteristics of the bond are...
asked 3 hours ago