Homework Answers
Add Answer to:
A balanced 3-0 source serves the following loads: Load 1: 18 kVA at 0.8 PF lagging...
1, Two balanced three-phase loads are in parallel. Load 1 draws 10 kW at 0.8 PF...
1, Two balanced three-phase loads are in parallel. Load 1 draws 10 kW at 0.8 PF lagging Load 2 draws 20 kVA at 0.6 PF leading a. b. The loads are supplied by a balanced three-phase 480 Vu source. (a) Draw the power triangle for the combined load. (b) Determine PF of the combined load. (c) Determine the magnitude of the line current from the source. (d) Y-connected inductors are now installed in parallel with the combined load. What value...
A three-phase load of 15 kVA with a PF of 0.8 lagging is connected in parallel...
A three-phase load of 15 kVA with a PF of 0.8 lagging is connected in parallel with a three-phase load of 36 kW at 0.6 PF leading. The line-line voltage is 2000V. a) Find the total complex power and power factor. Is it inductive or capacitive? b) How much kVAR is needed to make the PF unity? c) What is the magnitude of the current going into the total load?
(30) In the circuit with a voltage source and two loads below, find the following: 2....
(30) In the circuit with a voltage source and two loads below, find the following: 2. The complex power of each load a. b. The total complex power for the two loads - note units of power in the figure c. Sketch the triangle for the total complex power e total current from the source as a phasor assuming the line voltage at the load is 20820 VRMS The value of the parallel capacitance in parallel with the two loads...
10. Two loads connected in parallel draw a total of 2.4 kW at 0.8 pflagging from...
10. Two loads connected in parallel draw a total of 2.4 kW at 0.8 pflagging from a 120-V rms, 60- Hz line. One load absorbs 1.5 kW at a 0.707 pf lagging. Determine: (a) the pf of the second load, INV 11. Calculate the line currents for the system shown in figure. Calculate also the total power and reactive power consumed by the load. w 12. For the balanced three-phase circuit in Fig.. Calculate the line currents, the phase voltage...
3- Two balanced Y-connected loads in parallel, one drawing 25 kW at 0.6 power factor lagging...
3- Two balanced Y-connected loads in parallel, one drawing 25 kW at 0.6 power factor lagging and the other drawing 15 kVA at 0.8 power factor leading, are supplied by a balanced, three-phase, 480-volt source. (a) Draw the power triangle for each load and for the combined load. (b) Determine the power factor of the combined load and state whether lagging or leading. (c) Determine the magnitude of the line current from the source. (d) ∆- connected capacitors are now...
The following three-phase, balanced loads are connected across a three-phase, Y-connected 60 Hz source with a...
The following three-phase, balanced loads are connected across a three-phase, Y-connected 60 Hz source with a line-to-line voltage of 480 V. The loads are described below: • Load 1: ∆-connected, total three-phase apparent power is 30 kVA at 0.95 power factor lagging. • Load 2: ∆-connected, total three-phase active power is 20 kW at 0.7 power factor lagging. • Load 3: Y-connected, phase current is 30 A, and power factor is 0.9 pf leading. (a) Calculate the total complex power...
A 3-φ Y connected source supplies 12 kVA with a power factor of 0.8 lagging to a parallel
A 3-φ Y connected source supplies 12 kVA with a power factor of 0.8 lagging to a parallel combination of a Y load and a Δ load. If the Y load consumes 5.6 kVA at a power factor of 0.75 lagging and has phase-a current of 8 Arms and the angle of the current is -30°, determine the phase impedance of the Δ load. Real part of the impedance of the Δ load in Ohms: Imaginary part of the impedance of the...
of shagah Name 120 96] Proble m 1: A balanced Y. connected, 50-Hz abc source is...
of shagah Name 120 96] Proble m 1: A balanced Y. connected, 50-Hz abc source is connected to the following loads via 0.5+0.25 j 0/phase line. A Y-connected 900 kVA at 0.7 pf lagging load. · A ?-connected 500 kw at 0.6 pf lagging load. A Y-connected 350 kVAR at 0.7 pf lagging load. · 4-connected 600 kW at 0.6 pf lagging load. A Part 1: If the load voltage is always kept at 11 kV a) what is the...
Problem 3: (20 points) ase serves two balanced parallel loads. The line- A three-phase transmission line...
Problem 3: (20 points) ase serves two balanced parallel loads. The line- A three-phase transmission line with an impedance (0.2 +j1.0) 12/phase serves two balan to-line voltage at the load end of the line is 480 V (rms). Load 1: Wye-connected and absorbs a total of 200 kW with a lagging p.f. of 0.87. Load 2: Delta-connected with an impedance of (20+30) 2/phase. a. Draw the single phase representation of the circuit b. How much current flows through phase A...
Electrical Engineering Question 2. Three loads are connected in parallel across a source as shown. Load...
Electrical Engineering Question
2. Three loads are connected in parallel across a source as shown. Load 1 absorbs 7 kW and 8 KVAR. Load 2 absorbs 10 KVA at a lagging p.f. of 0.6. Load 3 absorbs 10 kW at a leading p.f. of 0.5. a) Find the total complex power absorbed by the three loads. 10.12 b) If V. = 12020° Vrms, find V, in polar form.
1, Two balanced three-phase loads are in parallel. Load 1 draws 10 kW at 0.8 PF lagging Load 2 draws 20 kVA at 0.6 PF leading a. b. The loads are supplied by a balanced three-phase 480 Vu source. (a) Draw the power triangle for the combined load. (b) Determine PF of the combined load. (c) Determine the magnitude of the line current from the source. (d) Y-connected inductors are now installed in parallel with the combined load. What value...
(30) In the circuit with a voltage source and two loads below, find the following: 2. The complex power of each load a. b. The total complex power for the two loads - note units of power in the figure c. Sketch the triangle for the total complex power e total current from the source as a phasor assuming the line voltage at the load is 20820 VRMS The value of the parallel capacitance in parallel with the two loads...
10. Two loads connected in parallel draw a total of 2.4 kW at 0.8 pflagging from a 120-V rms, 60- Hz line. One load absorbs 1.5 kW at a 0.707 pf lagging. Determine: (a) the pf of the second load, INV 11. Calculate the line currents for the system shown in figure. Calculate also the total power and reactive power consumed by the load. w 12. For the balanced three-phase circuit in Fig.. Calculate the line currents, the phase voltage...
of shagah Name 120 96] Proble m 1: A balanced Y. connected, 50-Hz abc source is connected to the following loads via 0.5+0.25 j 0/phase line. A Y-connected 900 kVA at 0.7 pf lagging load. · A ?-connected 500 kw at 0.6 pf lagging load. A Y-connected 350 kVAR at 0.7 pf lagging load. · 4-connected 600 kW at 0.6 pf lagging load. A Part 1: If the load voltage is always kept at 11 kV a) what is the...
Problem 3: (20 points) ase serves two balanced parallel loads. The line- A three-phase transmission line with an impedance (0.2 +j1.0) 12/phase serves two balan to-line voltage at the load end of the line is 480 V (rms). Load 1: Wye-connected and absorbs a total of 200 kW with a lagging p.f. of 0.87. Load 2: Delta-connected with an impedance of (20+30) 2/phase. a. Draw the single phase representation of the circuit b. How much current flows through phase A...
Electrical Engineering Question
2. Three loads are connected in parallel across a source as shown. Load 1 absorbs 7 kW and 8 KVAR. Load 2 absorbs 10 KVA at a lagging p.f. of 0.6. Load 3 absorbs 10 kW at a leading p.f. of 0.5. a) Find the total complex power absorbed by the three loads. 10.12 b) If V. = 12020° Vrms, find V, in polar form.
Most questions answered within 3 hours.
-
Hydrobromic acid
dissolves solid iron according to the followiaung reaction:
Fe(s)+2HBr(aq)→
FeBr2(aq)+ H2(g)
Part A. What...
asked 1 hour ago -
Verify the following vector identity in SPHERICAL
COORDINATES.
div(curl(A)) = 0
asked 3 hours ago -
The work function (Φ) for a metal is 7.50×10-19 J.
What is the longest wavelength (nm)...
asked 3 hours ago -
1. Would the following procedural changes cause the
calculated mass percent Ni2+ ion in Ni(NH3)nCl2 to...
asked 5 hours ago -
1. Why does the voltage of the capacitor vary with frequency?
where does this missing voltage...
asked 6 hours ago -
p p please write each step out clearly
3. A manager of a company is considering...
asked 5 hours ago -
On October 1, Ebony Ernst organized Ernst Consulting; on October
3, the owner contributed $83,540 in...
asked 6 hours ago -
A.)As an electron moves through a region of space, its speed
decreases from 9.60 × 106...
asked 6 hours ago -
In java with the netbeans program do:
Through object programming
Create a class "ContadorP", which is...
asked 6 hours ago -
Pattern Corporation acquired all of Science
Company's outstanding stock on January 1, 2016 for $600,000 cash....
asked 6 hours ago -
Here are all accounts Tyler Co. maintains.
Tax expenses $4,750
Common stocks $48,840
SG&A expenses $2,500...
asked 7 hours ago -
Lis
out the types and equation of wind profile and the respective
variables in the fds...
asked 7 hours ago