please do not just copy solution manual..
please do not just copy solution manual.. B PROBLEM 17.113 The slender rod AB of length...
PROBLEM 17.113 The slender rod AB of length L = 1 m forms an angle B = 30° with the vertical as it strikes the frictionless surface shown with a vertical velocity 7 = 2 m/s and no angular velocity. Knowing that the coefficient of restitution between the rod and the ground is e = 0.8, determine the angular velocity of the rod immediately after the impact.
please do not just copy solution manual.. PROBLEM 17.127 Member ABC has a mass of 2.4 kg and is attached to a pin support at B. An 800-g sphere D strikes the end of member ABC with a vertical velocity v of 3 m/s. Knowing that L = 750 mm and that the coefficient of restitution between the sphere and member ABC is 0.5, determine immediately after the impact (a) the angular velocity of member ABC, (b) the velocity of...
2. (40 points) A soccer ball tester consists of a 15-kg slender rod AB with a 1.1-kg sim- ulated foot located at A and a torsional spring located at pin B. The torsional spring has a spring constant of k 910 N.m/rad and is unstretched when AB is its lowest position. Fig. 2 depicts the simulation. The length of AB is 0.9 m, and you can assume that the foot ban be modcled as a particle, Knowing that the velocity...
A pendulum consists of a slender rod, AB, of weight Wr = 8.70 lb and a wooden sphere of weight Ws = 28.9 lb .(Figure 1) The length of the rod is d1 = 7.20 ft and the radius of the sphere is R = 0.500 ft . A projectile of weight Wp = 0.300 lb strikes the center of the sphere at a velocity of v1 = 866 ft/s and becomes embedded in the center of the sphere. What...
21 (25) A uniform slender rod AB rests on a frictionless rizontal surface and a force P of magnitude 1N is applied at A ia direction perpendicular to the rod. Knowing that the rod weighs 0.8 kg, determine the acceleration of (a) point A, (b) point B. (gmP/12)
A 12 kg slender rod is placed against the wall at an angle of 45 degrees as shown. If it is released from rest, determine the angular velocity of the rod at the instant just before it hits the ground (angle 0 degrees). Neglect friction. Moment of Inertia lg of rod-2 12 8 Bar AB is l0 k Spring unstrctched Starth from rest Hint: Tou k" A 12 kg slender rod is placed against the wall at an angle of...
please do not just copy solution manual.. PROBLEM 17,101 A 45-g bullet is fired with a velocity of 400 m/s at 0 = 30° into a 9-kg square panel of side b = 200 mm. Knowing that h=150 mm and that the panel is initially at rest, determine (a) the velocity of the center of the panel immediately after the bullet becomes embedded, (b) the impulsive reaction at A, assuming that the bullet becomes embedded in 2 ms.
Question 4 A homogeneous slender rod AB of mass m and length L is held in the position shown in Figure Q4. The end A of the rod is free to move along the smooth horizontal surface. The end B of the rod is connected to rod BC of negligible mass. The rod AB is released from rest in the position shown when 0 = 60°. If the acceleration of end B is ā, = -a,j, derive the expressions in...
D PROBLEM 17.127 Member ABC has a mass of 2.4 kg and is attached to a pin support at B. An 800-g sphere D strikes the end of member ABC with a vertical velocity vi of 3 m/s. Knowing that L = 750 mm and that the coefficient of restitution between the sphere and member ABC is 0.5, determine immediately after the impact (a) the angular velocity of member ABC, (b) the velocity of the sphere
D L/2 G L/2 B MO A uniform slender rod of mass M=10 kg and length L=3m, is hinged at A. The rod is held in a horizontal position against А the spring (k= 200kN/m) at G, the spring being in compression. When the rod is released from this horizontal position k Rigid (the spring is not connected to the rod), support it will rotate about the frictionless hinge Spring A in a vertical plane. Determine: support a. The minimum...