Current distribute in parallel combination is opposite to the ratio of resistors
Ratio of resistors R1 & R2 is 2200:1100 = 2:1
R1 : R2 = 2:1
So the current distribute in 2200ohm and 1100ohm resistors in ratio of 1:2
so current flow from 2200ohm resistor is half that of 1100ohm resistor
8) Two resistors are in parallel, one within each branch of a simple circuit. One resistor...
7) Two light bulbs A and B are connected to a constant voltage source and an open switch as shown in the figure. When the switch is closed, bulb B: a) Burns more brightly. b) Burns more dimly. ACO c) Acts like a capacitor d) Burns as brightly. BO e) Goes out [B 8) Two resistors are in parallel, one within each branch of a simple circuit. One resistor is 2200 Ohm and the other is 1100 Ohm. The current...
A simple circuit is constructed by connecting one voltage source E Volt with one resistor resistor R Ohm and current is measured 1.48 Amps. If the voltage of the source is TWICE and resitor is ONE-THIRD of their previous values, what is the new current?
A circuit consists of two resistors in series followed in series by two resistors in parallel. Each resistor has a resistance of 5 Ohm. What is the equivalent resistance of this circuit? If the circuit is connected to an AC power source of V_rms = 110V what will be the peak current in the circuit? What will be the average power drawn by the circuit?
A 120.0 ohm resistor is connected in parallel to a 60.0 ohm resistor. These two resistors in parallel are then connected in series with a 20.0 ohm resistor. The total combination is connected across a 15.0 V battery. a. Find the total current in the circuit. b. Find the power dissipated in the 120.0 ohm resistor.
Using Matlab When several resistors are connected in an electrical circuit in parallel, the current through each of them is given by in=vs/Rnwhere in and Rn are the current through resistor n and its resistance, respectively, and vs is the source voltage. The equivalent resistance, Req, can be determined from the equation 1/Req=1/R1+1/R2+1/R3+.......+1/Rn. The source current is given by is , and the power, Pn, dissipated in each resistor is given by . is=vs/Req, and Pn=vsin. Write a program in...
The parallel circuit at the right depicts three resistors connected to a voltage source. The voltage source is a 110-V source and the resistor values are R_1 = 15.4 Ohm. R_2 = 21.9 Ohm, and R_3 = 11.7 Ohm. Determine the equivalent resistance of the circuit. 5.10 Ohm 5.20 Ohm 0.196 Ohm
A circuit consists of a power supply and two resistors R1 and R2 connected in parallel. An ammeter is placed to measure the current through resistor R1. The ammeter reads I1 = 8.9 mA, and the values of the resistors are R1 = 7.7 kOhm and R2 = 820 Ohm. What is the value of voltage across R2?
Experiment RESISTANCE IN COMBINATION PURPOSE: To study series, parallel, and series.parallel combinations of resistors. EQUIPMENTThe experiment board and accompanying bundle of connecting wires. PROCEDURE: 1. Resistors in series: Connect the circuit shown in Fig. 1. Using circuit theory (Ohms Law in conjunction with the predicted procedure for combining resistors in series), calculate the expected current in or through the three resistors in series and the expected voltage across each of the three resistors. After the instructor has approved your connections,...
In circuit 1, four resistors are connected purely in parallel to a battery. Three resistors are unknown and one of the resistors is 6 Ohms. In circuit 2, the resistor whose resistance is known (6 Ohms is removed from the circuit and the other three resistors are connected purely in parallel to the same battery. The power output of the battery in circuit 1 is 5.1 Watts more than the power output of the battery in circuit 2. What is...
The parallel circuit above contains 2 resistors, each with a resistance R. If a third resistor (Rs) is connected in parallel with the other two resistors, what will happen to current measured by the ammeters? Ignore the resistance of the wires. A1 will increase and A2 will stay the same A1 and A2 will stay the same A1 will increase and A2 will decrease A1 and A2 will increase RK Az