Calculate the buckling stress in MPa of rod BC (E=200 GPa) about the x-x axis, if...
Calculate the buckling stress in MPa of rod BC (E=200 GPa) about the x-x axis, if a =17 mm and b = 30 mm. Assume pin-pin connection. Round your answer to 2 decimal places. a B X 3 m b у X с -4 m
Calculate the buckling stress in MPa of rod BC (E=200 GPa) about the y-y axis, if a = 16 mm and b = 34 mm. Assume fixed-fixed connection. Round your answer to 2 decimal places. B a 3 m y C 4 m
Calculate the buckling stress in MPa of rod BC (E=200 GPa) about the y-y axis, if a =24 mm and b = 38 mm. Assume fixed-fixed connection. Round your answer to 2 decimal places. a B X 3 m b V Α. C 4 m
Calculate the buckling stress in MPa of rod BC (E-200 GPa) about the yay axis. If a 19 mm and b-32 mm. Komeadfed currection Party 2 decimal places a B 3 m b
The rod ABCD is made of an aluminum alloy with a modulus of elasticity E = 70 GPa. For the loading shown, and neglecting the weight of the rod, determine the stress in sections AB, BC, and CD and the deflection of point D. For stress, answer to nearest whole number. Use 3 decimal places for displacement. Drawing is not to scale. Assume compressive stresses are positive, and that displacement to the right is positive. Stress in AB = _______ MPa Stress...
Required information The 4-mm-diameter cable BC is made of a steel with E= 200 GPa. Knowing that the maximum stress in the cable must not exceed 200 MPa and that the elongation of the cable must not exceed 7 mm. Ifa - 3 m and b 4 m, find the allowable load P that can be applied as shown
The 4-mm-diameter cable BC is made of a steel with E = 200 GPa. Knowing that the maximum stress in the cable must not exceed 190 MPa and that the elongation of the cable must not exceed 5 mm, find the maximum load P that can be applied as shown. В 2.5 m P 3.5 m с -4.0 m
Figure Q1 The jib crane is pinned at A and supports a chain hoist that can travel along the bottom flange of the a) the force in rod BC b) the minimum diameter of rod BC (to the nearest 5 mm). c) the minimum diameter of pin B (to the nearest 5 mm). The material properties are listed in Table Q2 and use factor of safety of FS-2 (10 marks) beam boist Figure Q2 Table Q2: Material properties (MPa) Shear...
A solid aluminum [E = 76 GPa] rod (1) is connected to a solid bronze [E = 93 GPa] rod (2) at flange B, as shown. Aluminum rod (1) has an outside diameter of 31 mm and bronze rod (2) has an outside diameter of 15 mm. The norma stress in the aluminum rod must be limited to 128 MPa, and the normal stress in the bronze rod must be limited to 97 MPa. Assume L1 = 180 mm and...
. The rod has an E= 200 GPa. and a diameter of 54 mm. It is used as a strut to support the beam. Determine the maximum intensity w of the uniform distributed load that can be applied to the beam without causing the strut to buckle. Take F.S. - 2 against buckling. :6 m- 3m Cinlar ame Pa (KL)