Question

In figure 1, what is the voltage across the start switch when open 120V Start Stop A B E F CR1) c tho 1-CR1
In figure 1, what is the voltage across 1 CR-1 when open? QUESTIONS In figure 1, what is the voltage across stop switch ? QUE
QUESTION 7 In figure 1, what is the voltage across the start switch when open 120V Start Stop A B F CR1- C 1-CR1
0 0
Add a comment Improve this question Transcribed image text
Answer #1

Start switch is a Push button - so it's normally in open condition

so the voltage across the 1-CR1 is 120V

the stop switch is normally closed button when we press the switch then only it will acts as an open circuit until it's acts as an short circuit so the voltage across the stop switch is 0V

when on 1-CR1 terminals was short circuited by the start button so the voltage across the 1-CR1 is 0V entire voltage appeared across CR1 only

OFF During ON
voltage across 1-CR1 120 0
voltage across STOP button 0 0
voltage across CR1 0 120

at the time of off only the voltage across STOP button is 120 V in remaining all the cases is 0V

Add a comment
Know the answer?
Add Answer to:
In figure 1, what is the voltage across the start switch when open 120V Start Stop...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • The following questions refer to the figure below. At the start, the switch between points c and c is open as a drawn

    The following questions refer to the figure below. At the start, the switch between points c and d is open as drawn on the figure. The battery is 5 V. At this time (switch open) the current measured at point a is 5 ma, and there is a 3 V difference between a and b. R2 is larger than R3.(A) What is the current at point d?(B) What is the voltage between points b and d?(C) What is the voltage...

  • IP The switch in the circuit shown in the figure(Figure 1) is open initially. Part A...

    IP The switch in the circuit shown in the figure(Figure 1) is open initially. Part A Find the current in the circuit a long time after the switch is closed. Express your answer in terms of some or all of the variables E, R1, R2, and L. Part B. Describe the behavior of the lightbulb from the time the switch is closed until the current reaches the value found in part A. Part C. Now, suppose the switch is opened...

  • Question 23 1 pts A B 6V switch open w Figure 6 What is the potential...

    Question 23 1 pts A B 6V switch open w Figure 6 What is the potential difference in volts across Rp in Fig. 6? Question 24 1 pts Indicate your reasoning for your answer to problem 23. Question 30 1 pts A B + 6V switch M closed F Figure 7 To one d.p., what is the current in amps flowing through the battery in Fig. 7? Question 31 1 pts Indicate your reasoning for your answer to problem 30....

  • (1) Consider the RC circuit shown in Figure 1. For t<0 the switch is open, and...

    (1) Consider the RC circuit shown in Figure 1. For t<0 the switch is open, and the charge stored on the capacitor is 0. At t-0 the switch is closed, and the voltage source begins charging the capacitor. Let R1-R2-220 Ω , C-0.47 μ F , Vs-5 V. (a) Write the differential equation as an expression for the capacitor voltage fort> 0 (i.e. write the differential equation) and calculate the time constant (b) Calculate the steady-state capacitor voltage R2 R1...

  • 3. For the circuit shown in Figure START switch is pressed, the when the motor starter contactor ...

    3. For the circuit shown in Figure START switch is pressed, the when the motor starter contactor energizes as usual. However, when the START switch is released, the contactor de-energizes and the motor stops. What is the most likely cause of this problem? T1, T2, and l3. L3 AC L2 pical Motor LINE L1 FIGURE 11-2 Starter Application H1 H3H2 H4 FUSE X2 X1 OLİOLİOL EMERGENCY STOP START STOP OL 95 96 13 14 MOTOR In operation, when the rails...

  • The network showed in the figure is assembled with unchargedcapacitors X, Y, and Z with...

    The network showed in the figure is assembled with uncharged capacitors X, Y, and Z with CX= 7 microF, CY= 7 microF, and CZ= 6 micro F, and open switches, S1 and S2. A potential difference Vab =+120V is applied between points a and b. After the network is assembled, switch S1 is closed for a long time, but switch S2 is is kept open. Then switch S1 is opened and switch S2 is closed. What is the final Voltage...

  • The initial voltage across the capacitor is 0 V. At time t=0, the switch is closed

    The initial voltage across the capacitor is 0 V. At time t=0, the switch is closed a) What is the time constant for this circuit? b) What is the final voltage across the 50 capacitor? c) What is the expression for the voltage across the 50 capacitor? d) Sketch the waveform for . e) What is the maximum instantaneous current that will flow through the capacitor? f) When will the voltage reach 5.0 V? 

  • Question 23 6V switch open Figure 6 What is the potential difference in volts across RD...

    Question 23 6V switch open Figure 6 What is the potential difference in volts across RD in Fig. 6?

  • Question 3 (a) Referring to Figure Q3(a), determine: (i) (ii) i) the voltage across the capacitor...

    Question 3 (a) Referring to Figure Q3(a), determine: (i) (ii) i) the voltage across the capacitor 2F, the current through the inductor 0.25H, and the total energy stored in the capacitor and the inductor. (2 marks) (2 marks) (4 marks) 1.5? 0.25H 12V 2F 10 .50 Figure Q3(a) (b) In the network in Figure Q3(b), find the capacitance Crif (i) the switch is open aned (ii) the switch is closed (6 marks) (6 marks) 64 F Figure Q3Kb) Total: 20...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT