Emitter Base Collector 5. Figure illustrates the minority carrier concentrations along a BJT. We are told...
Emitter Collector PIN 5. Figure illustrates the minority carrier concentrations along a BJT. We are told that V=> and VBO according to polarity shown in the figure. State the type of the transistor and the mode in which it is operating a. PNP, active mode b. NPN, saturation mode c. NPN, reverse active mode d. PNP, cut-off mode
Emitter Collector DIN 5. Figure illustrates the minority carrier concentrations along a BJT. We are told that VÆ> and VBO according to polarity shown in the figure. State the type of the transistor and the mode in which it is operating a. PNP, active mode b. NPN, saturation mode c. NPN, reverse active mode d. PNP, cut-off mode
A uniformly doped silicon pnp transistor with base width of 2um is biased in forward active mode (with BC junction reverse biased). The doping concentrations are NE-1018cm NB-5x1016cm3, and Nc-1015cm3. Assume DB-25 cm2/s, TB-10-s and LB 16um (a) Calculate the values of no, рво, and nco. (b) For VEB 0.65V, determine the respective minority carrier concentration at the edge of the depletion layer, pa(0) and ne(0) (c) Sketch the minority carrier concentration through the device and label each curve (d)...
Forward Active Reverse Active Cutoff Saturation 2. The minority carrier distribution in a NPN BJT under forward active bias is given in the following questions. On top of the figure, sketch the corresponding new minority carrier concentration when the given condition is changed. (To make the question simple, you may assume the depletion width remains unchanged in all questions. But you have to indicate the new equilibrium minority concentration if they are affected.) 6. a) collector doping is increased by...
8.3 Consider a conventional NPN BJT with uniform doping. The base-emitter junction is forward biased, and the base-collector junction is reverse biased. (a) Qualitatively sketch the energy band diagram. (b) Sketch the minority carrier concentrations in the base, emitter, and collector regions. (c) List all the causes contributing to the base and collector currents. You may neglect thermal recombination-generation currents in the depletion regions.
HELP with finding 8 and 9
2. IC temperature sensor The emitter-base voltage VEB of a PNP bipolar junction transistor (BJT) with its base and collector shorted (figure 1(a)) can be expressed by VEB (kT/q) In(Ic/Is), in which Is is the saturation current of the emitter-base junction (a) (3 pts) Choose any statement below that correctly describe the effect of temperature on the property of the BIT under a constant 1c as shown in figure 1(a).18_.(one or more than one...
Consider the npn BJT with a turn-on voltage V1 = 0.70 V, and a saturation emitter-collector voltage V CE/SAT) = 0.20 V. (a) [20 points) Consider this transistor in a common- emitter circuit (Re = 0). Design this common- emitter circuit to produce the IV (Ic vs. VCE) characteristic and load line (LL) as shown in the graph. Your answers are the following: a drawing of the circuit; the values of Vcc, Rc, VBB, and Ra; and the value for...