What specification in the Ontario Electrical Code would be used to find the framing requirements for...
What specification in the Ontario Electrical Code would be used to find the framing requirements for a Primary 3Phase 10kV/17.3kV line with a conductor angle of 21°? question from hydrocodes and standards
Homework Answers
Ontario electric code under section 75-200(Pole framing) it is cleary stated that Pole used in primary line shall be framed according to the Specification-13 because the given parameters are satisfied in specification-13.
Specification-13: Primary,l 3-phase, angle 4°-90°, 2.14/4.16 to 16/27.6 kV
Add Answer to:
What specification in the Ontario Electrical Code would be used
to find the framing requirements for...
What specification in the Ontario Electrical Code would be used to find the framing requirements for...
What specification in the Ontario Electrical Code would be used to find the framing requirements for a Primary 3Phase 10kV/17.3kV line with a conductor angle of 21°?
pleas help me in this do any question you know using National Electrical Code 2011 Applied Electricity NEC...
pleas help me in this do any question you know using National
Electrical Code 2011
Applied Electricity NEC worksheet t hree Copper conductors with THHN insulation run in Electrical A branch-circuit Consther conductors. The conductor terminations are rated for a maximum ure in the area of this installation is not expected to exceed 30C size 8 AWG, the maximum ampacity of the conductors If the conductors for this circuit are permitted A 40 amperes. B. 50 amperes. to be used...
(1). In regard to installation of electrical conductions and equipment, who may grant exceptions to the...
(1). In regard to installation of electrical conductions and equipment, who may grant exceptions to the requirements of the NEC? A. nfpa b. ahj c. ieee d. ul. (2). Exceptions to the Code permit alternate methods to the general (main) rule. Exceptions are permitted. A. when all of the provisions of the exception are met. B. when a written request is submitted to and approved by the NEC. C. any time the electrician deems it necessary. D. not more than...
Please help me with the following C Programming project. I am providing the code I used...
Please help me with the following C Programming project. I am providing the code I used which needs to be reworked to add the following requirements. Here is my code #include<stdio.h> char input; int main() { int i = 0; while (true){ scanf_s("%c", &input); if (input == 'X') break; printf("%c", input); } return 0; } Here are the requirements for the code plus and additional note what the code should have. Goals Understand the ASCII representation of character values. Understand...
the following is in java find the errors and answer the question what would the output...
the following is in java
find the errors and answer the question
what would the output be if the program was functioning and the
following was entered
Obect-Orientated Programming Systems Languages Applications
import java. Scanner: public class LabProgram { public static String create acconym String usssPhrase) { string total Acronym: intji: total Asconym "" for (1 == 0; j <user Phrass.length); ++j1) { if (i= usesPhrase.length0 - 1) { if (i=0) if (user Phrase.charAt(1) >= 65 & userPhrase.charAt()=90) { totalAcronym...
City code %drivers21 fatal accidents/1000 1 12 1.309 2 5 0 3 12 2.539 4 9 2...
city code
%drivers21
fatal accidents/1000
1
12
1.309
2
5
0
3
12
2.539
4
9
2.003
5
11
2.034
6
14
4.08
7
13
2.639
8
9
0.124
9
6
0
10
10
1.145
11
13
2.719
12
18
3.128
13
10
1.676
14
17
3.769
15
14
2.639
16
13
1.449
17
12
3.121
18
10
2.616
19
9
0.788
20
14
2.631
21
10
1.887
22
12
1
23
9
0.652
24
12
1.209
25
15
0.775...
Matching: What are 4 fundamental activities in software processes? definition of the software function and operational...
Matching: What are 4 fundamental activities in software processes? definition of the software function and operational constraints Answer 1Choose...software developmentsoftware evolutionsoftware specificationsoftware validation software is modified to reflect changing customer / market needs Answer 2Choose...software developmentsoftware evolutionsoftware specificationsoftware validation design and implementation of the software code Answer 3Choose...software developmentsoftware evolutionsoftware specificationsoftware validation process of ensuring the software meets the customer's requirements Answer 4Choose...software developmentsoftware evolutionsoftware specificationsoftware validation Please answer all parts of the question. Question 2 Answer saved Marked out...
Python 3.5 Code Part A: 10 points A tick is a short line that is used...
Python 3.5 Code Part A: 10 points A tick is a short line that is used to mark off units of distance along a line. Write a function named drawTick() that uses a turtle parameter to draw a single tick of specified length perpendicular to the initial orientation of the turtle. The function drawTick() takes two parameters: 1. a turtle, t, that is used to draw 2. an integer, tickLen, that is the length of the tick When drawTick() is...
Please, I need help writing a memo to the CCO analyzing the survey results attached (strengths...
Please, I need help writing a memo to the CCO analyzing the
survey results attached (strengths and weaknesses) to gain a better
understanding of employees' perceptions of the company's compliance
and ethics program.
Many aspects of a successful compliance and ethics program can
be evidenced by documentation that supports the effectiveness of
the program. However, like other entity-level controls (an
effective code of ethics is considered an entity-level control),
employee perceptions and buy-in may significantly influence the
success of a...
Question 1: 1. Figure out what the following MATLAB code does (Notice that R n =...
Question 1: 1. Figure out what the following MATLAB code does (Notice that R n = 500 for jay - 1:4 ifjoy > 1;oldtime = time; end M rand(n); t cputime; forrep -1:5 R chol(A): en time = cputime-t; if jay > 1; ratio - time/oldtime, end en If you put these instructions into a file named, say, zap.m, you can run the program by typing zap from the MATLAB command line. The functions randn, cputime, and chol are built-in...
pleas help me in this do any question you know using National
Electrical Code 2011
Applied Electricity NEC worksheet t hree Copper conductors with THHN insulation run in Electrical A branch-circuit Consther conductors. The conductor terminations are rated for a maximum ure in the area of this installation is not expected to exceed 30C size 8 AWG, the maximum ampacity of the conductors If the conductors for this circuit are permitted A 40 amperes. B. 50 amperes. to be used...
the following is in java
find the errors and answer the question
what would the output be if the program was functioning and the
following was entered
Obect-Orientated Programming Systems Languages Applications
import java. Scanner: public class LabProgram { public static String create acconym String usssPhrase) { string total Acronym: intji: total Asconym "" for (1 == 0; j <user Phrass.length); ++j1) { if (i= usesPhrase.length0 - 1) { if (i=0) if (user Phrase.charAt(1) >= 65 & userPhrase.charAt()=90) { totalAcronym...
city code
%drivers21
fatal accidents/1000
1
12
1.309
2
5
0
3
12
2.539
4
9
2.003
5
11
2.034
6
14
4.08
7
13
2.639
8
9
0.124
9
6
0
10
10
1.145
11
13
2.719
12
18
3.128
13
10
1.676
14
17
3.769
15
14
2.639
16
13
1.449
17
12
3.121
18
10
2.616
19
9
0.788
20
14
2.631
21
10
1.887
22
12
1
23
9
0.652
24
12
1.209
25
15
0.775...
Please, I need help writing a memo to the CCO analyzing the
survey results attached (strengths and weaknesses) to gain a better
understanding of employees' perceptions of the company's compliance
and ethics program.
Many aspects of a successful compliance and ethics program can
be evidenced by documentation that supports the effectiveness of
the program. However, like other entity-level controls (an
effective code of ethics is considered an entity-level control),
employee perceptions and buy-in may significantly influence the
success of a...
Question 1: 1. Figure out what the following MATLAB code does (Notice that R n = 500 for jay - 1:4 ifjoy > 1;oldtime = time; end M rand(n); t cputime; forrep -1:5 R chol(A): en time = cputime-t; if jay > 1; ratio - time/oldtime, end en If you put these instructions into a file named, say, zap.m, you can run the program by typing zap from the MATLAB command line. The functions randn, cputime, and chol are built-in...
Most questions answered within 3 hours.
-
Look at sample problem 19.6 in the 8th ed Silberberg book.
Enter your answers in scientific...
asked 5 minutes ago -
A long straight wire carries a current of 5.00 A at a distance r from the...
asked 6 minutes ago -
A 125
g baseball is thrown at a speed of 127ft/sec at a batter, the ball...
asked 11 minutes ago -
If you have an eta squared of .34 and used a
between-subjects design, what does that...
asked 19 minutes ago -
*Healthcare Adminstration*
Scutchfield and Keck's Principles of Public Health Practice
4th edition
What are the differences...
asked 23 minutes ago -
Find the complete optimal solution to this linear programming
problem. Max 5x + 3y s.t. 2x...
asked 52 minutes ago -
The pH of an acetate buffer was determined to be 4.76. Then, a
few drops of...
asked 54 minutes ago -
a sample of size 1500 is used to find a confidence
interval for the percentage of...
asked 1 hour ago -
Explain in detail the differences between qualitative and
quantitative forecasts. Include at least two examples of...
asked 1 hour ago -
Differentiate between response time and throughput.
Explain how the physical design of a database influences
performance...
asked 1 hour ago -
Write MATLAB code to plot the following
waveforms.
Rectangular pulses:
????(?)
????(? − ?)
????(?/?) ...
asked 1 hour ago -
4. Adam’s Inc.’s outstanding common stock is currently selling
in the market for $28. Dividends of...
asked 1 hour ago