Constants Periodic Table A square loop of side length 100 mm is placed on a wooden...
A square loop of wire with side 3 cm is placed in a uniform magnetic field of magnitude 0.4 T. A line perpendicular to the plane of the loop is angled at 30 degrees to the magnetic field. What is the magnitude of the magnetic flux through the coll A square loop of wire with side 3 cm is placed in a uniform magnetic field of magnitude 0.4 T. A line perpendicular to the plane of the loop is angled...
A 5-turn square loop whose side length is (0.20 m) is placed in a magnetic field that makes an angle of 30° with the normal to the plane of the loop. The magnitude of this field varies with time as: B(t) = - 3.0t^3 where t is measured in s and B in T. What is the magnitude of the induced potential difference in the loop at t=2.0 s?
CHW6 Item 13 < 13 of 16 Constants Periodic Table A circular loop with an area of 1.6x10-2 mn is in a uniform magnetic field of 0.20 T. Part A What is the flux through the loop's plane if it is parallel to the field? Express your answer using two significant figures. IVO AL c 2 T. Submit Request Answer Part B What is the flux through the loop's plane if it is at an angle of 38 to the...
A circular loop of radius 100 mm is placed in a magnetic field of magnitude 0.052 T . The magnetic flux through the loop is 3.00 × 10−4 T⋅m2 . Part A What is the angle between the plane of the loop and the field?
A square conducting loop with side length a = 1.25 cm is placed at the center of a solenoid 40.0 cm long with a current of 4.60 A flowing through its 470 turns, and it is aligned so that the plane of the loop is perpendicular to the long axis of the solenoid. The radius of the solenoid is 5.00 cm. (a) What is the magnetic flux through the loop? Wb (b) What is the magnitude of the average emf...
A loop of wire in the form of a square 2.20 m on each side, its plane makes an angle of 36.0° with a uniform magnetic field of 0.80 T. What is the magnetic flux through the loop? ( I give thumbs up if correct right away, so rlly appreciate ur help :)
A square loop of wire with side length 10 cm is moving to the right with constant speed of 16 m/s. The loop has total resistance of .8 ohms. It begins in a region with no magnetic field, then enters a region of magnetic field (wider than 10 cm) with a strength of .5 T pointing out of the page. a) while entering the field what is the direction of the induced current as seen from above the plane of...
The square surface shown has a side length of 3.9 mm. It is in a uniform electric field with a magnitude of 1925 N/C, which makes an angle of 44.0 degrees with a normal to the square surface as shown. Take that normal to define outward direction for the surface. Calculate the electric flux through the surface. Normal 350
A square loop of wire, 0.59 m on each side, has one edge along the positive z-axis and is tilted toward the y-z plane at an angle of 30.0° with respect to the horizontal (x-z plane). There is a uniform magnetic field of 0.22 T pointing in the positive x-axis direction. (a) What is the flux through the loop? (b) If the angle increases to 60°, what is the new flux through the loop? (c) While the angle is being...
A square loop 10 cm on a side is placed in a uniform, time-varying magnetic field perpendicular to the plane of the loop, as indicated in the figure below. The field has an instantaneous magnitude of 0.63 T and is increasing at the rate of 0.33 T/ms. The loop has a resistance of 0.0162. (a) Find the loop's magnetic moment. magnitude direction Select (b) Find the torque on the loop A square loop 10 cm on a side is placed...