Homework Answers
Add Answer to:
Q3: Water at 20 C is flowing in the pipe and out to the atmosphere as...
1. For water at 20 C flowing through a straight smooth pipe at 0.06 m/h, the...
1. For water at 20 C flowing through a straight smooth pipe at 0.06 m/h, the pipe diameter for which transition to turbulence will occur is approximately a. 1.0 cm b. 1.5 cm c.2.0 cm d. 2.5 cm e. 3.0 cm 2. Find the Reynold number, the roughness parameter, the friction factor f and the pressure drop for flow of water at 20 C through a 5 cm diameter pipe of roughness height E=0.5 mm if the flow rate is...
Water at 20 C is steadily flowing through a diverging pipe section that is inclined by...
Water at 20 C is steadily flowing through a diverging pipe section that is inclined by an angle of 30° with respect to the horizontal (See the figure) The total testing section length is 20 m long with an initial pipe diameter of 10 mm (Section 1) and final diameter of 20 mm (Section 2). The small diameter section shows a gage pressure of 100 kPa and average flow velocity 10 m/s. Other values will be obtained by reaching complete...
Question (20 marks Analysis only required Water at 15°C is discharged freely to atmosphere from a...
Question (20 marks Analysis only required Water at 15°C is discharged freely to atmosphere from a reservoir at 18 L/s through two horizontal pipes in series and a pump-motor assembly in between as shown in figure below. First pipe-A is made of cast Iron and is 20m in length with a 60mm dia. The second pipe-B is 35 m in length, has a 40 mm diameter with friction factor 0.0331. The pipe entrance from reservoir is sharp edged. Neglect any...
Please solve a,b,c,d,e,f 1) A water fountain is to be installed at a remote location by attaching a cast iron pipe directly to a water main through which water is flowing. The entrance to the pipe...
Please solve a,b,c,d,e,f
1) A water fountain is to be installed at a remote location by attaching a cast iron pipe directly to a water main through which water is flowing. The entrance to the pipe is sharp-edged 15m (K-0.5), and the 15m long piping system involves three 90 bends without vanes (K1.1), a fully open gate valve (K.-0.2), and a fully open angle valve (K-5). If the diameter of the pipe is 2 em and the system is to...
In the figure, water flows through a horizontal pipe and then out into the atmosphere at...
In the figure, water flows through a horizontal pipe and then
out into the atmosphere at a speed v1 = 16.0
m/s. The diameters of the left and right sections of the pipe are
5.20 cm and 3.00 cm. (a) What volume of water
flows into the atmosphere during a 10 min period? In the left
section of the pipe, what are (b) the speed
v2 and (c) the gauge
pressure?
Question 1 In the figure, water flows through a...
Q3 [30 Marks] Water (p=1000 kg/m) is flowing through a tube with the constant surface area...
Q3 [30 Marks] Water (p=1000 kg/m) is flowing through a tube with the constant surface area as shown in the Figure Q3. 150 kPa 400 kPa 2 20 m 45° 1 Figure Q3 i. Calculate the diameter, if the friction factor of the pipe, the allowed velocity and the length of transport of the water are 0.025, 1.5 m/s and 200 m respectively. [15 Marks] What will happen for the system, if the friction factor of the pipe increases to...
Water at 15-Celsius flowing through 25 meters of 100mm- diameter galvanized iron pipe, causes a head...
Water at 15-Celsius flowing through 25 meters of 100mm- diameter galvanized iron pipe, causes a head loss (due to pipe friction) of 75mm. Find the flow rate
QUESTION 1 Water at 10 °C is flowing in a 90 bend pipe, with inner diameter...
QUESTION 1 Water at 10 °C is flowing in a 90 bend pipe, with inner diameter of 150 mm, at an average velocity of 3.0 m/s and gauge pressure of 300 kPa. The pipe is laid in the horizontal plane as shown in figure below. The magnitude of the resultant (horizontal) force required to hold the bend in place is: a 5.46 kN b.7.72 kN Oc 10.92 kN d.5.15 kN . None of the other answers QUESTION 2 A 25.0...
In the figure, water flows through a horizontal pipe and then out into the atmosphere at...
In the figure, water flows through a horizontal pipe and then out into the atmosphere at a speed v1 = 14.0 m/s. The diameters of the left and right sections of the pipe are 4.90 cm and 3.20 cm. (a) What volume of water flows into the atmosphere during a 10 min period? In the left section of the pipe, what are (b) the speed v2 and (c) the gauge pressure?
In the figure, water flows through a horizontal pipe and then out into the atmosphere at...
In the figure, water flows through a horizontal pipe and then out into the atmosphere at a speed v_1 = 14.0 m/s. The diameters of the left and right sections of the pipe are 5.20 cm and 2.90 cm. (a) What volume of water flows into the atmosphere during a 10 min period? In the left section of the pipe, what are (b) the speed v_2 and (c) the gauge pressure?
1. For water at 20 C flowing through a straight smooth pipe at 0.06 m/h, the pipe diameter for which transition to turbulence will occur is approximately a. 1.0 cm b. 1.5 cm c.2.0 cm d. 2.5 cm e. 3.0 cm 2. Find the Reynold number, the roughness parameter, the friction factor f and the pressure drop for flow of water at 20 C through a 5 cm diameter pipe of roughness height E=0.5 mm if the flow rate is...
Water at 20 C is steadily flowing through a diverging pipe section that is inclined by an angle of 30° with respect to the horizontal (See the figure) The total testing section length is 20 m long with an initial pipe diameter of 10 mm (Section 1) and final diameter of 20 mm (Section 2). The small diameter section shows a gage pressure of 100 kPa and average flow velocity 10 m/s. Other values will be obtained by reaching complete...
Question (20 marks Analysis only required Water at 15°C is discharged freely to atmosphere from a reservoir at 18 L/s through two horizontal pipes in series and a pump-motor assembly in between as shown in figure below. First pipe-A is made of cast Iron and is 20m in length with a 60mm dia. The second pipe-B is 35 m in length, has a 40 mm diameter with friction factor 0.0331. The pipe entrance from reservoir is sharp edged. Neglect any...
Please solve a,b,c,d,e,f
1) A water fountain is to be installed at a remote location by attaching a cast iron pipe directly to a water main through which water is flowing. The entrance to the pipe is sharp-edged 15m (K-0.5), and the 15m long piping system involves three 90 bends without vanes (K1.1), a fully open gate valve (K.-0.2), and a fully open angle valve (K-5). If the diameter of the pipe is 2 em and the system is to...
In the figure, water flows through a horizontal pipe and then
out into the atmosphere at a speed v1 = 16.0
m/s. The diameters of the left and right sections of the pipe are
5.20 cm and 3.00 cm. (a) What volume of water
flows into the atmosphere during a 10 min period? In the left
section of the pipe, what are (b) the speed
v2 and (c) the gauge
pressure?
Question 1 In the figure, water flows through a...
Q3 [30 Marks] Water (p=1000 kg/m) is flowing through a tube with the constant surface area as shown in the Figure Q3. 150 kPa 400 kPa 2 20 m 45° 1 Figure Q3 i. Calculate the diameter, if the friction factor of the pipe, the allowed velocity and the length of transport of the water are 0.025, 1.5 m/s and 200 m respectively. [15 Marks] What will happen for the system, if the friction factor of the pipe increases to...
Water at 15-Celsius flowing through 25 meters of 100mm- diameter galvanized iron pipe, causes a head loss (due to pipe friction) of 75mm. Find the flow rate
QUESTION 1 Water at 10 °C is flowing in a 90 bend pipe, with inner diameter of 150 mm, at an average velocity of 3.0 m/s and gauge pressure of 300 kPa. The pipe is laid in the horizontal plane as shown in figure below. The magnitude of the resultant (horizontal) force required to hold the bend in place is: a 5.46 kN b.7.72 kN Oc 10.92 kN d.5.15 kN . None of the other answers QUESTION 2 A 25.0...
In the figure, water flows through a horizontal pipe and then out into the atmosphere at a speed v_1 = 14.0 m/s. The diameters of the left and right sections of the pipe are 5.20 cm and 2.90 cm. (a) What volume of water flows into the atmosphere during a 10 min period? In the left section of the pipe, what are (b) the speed v_2 and (c) the gauge pressure?
Most questions answered within 3 hours.
-
convert grams into vloume with the density of water being at
.997514 g/cm^3 at 23.1 Celsuis...
asked 1 hour ago -
Foreman company obtained a $20,000, 6% loan on May 1, 2018.
Principal and interest will be...
asked 1 hour ago -
5. Problem 11.05 (Discounted Payback)
eBook
Project L costs $60,000, its expected cash inflows are $14,000
per...
asked 2 hours ago -
1. Which of the following is true about politics and health
organizations?
A. Health organizations are...
asked 2 hours ago -
A space vehicle is coasting at a constant velocity of 18.1 m/s
in the +y direction...
asked 3 hours ago -
5) Use the following balanced equation to answer questions
(a)-(i).
3 Cu(s) + 8 HNO3(aq) →...
asked 3 hours ago -
A three-year maturity bond with a 12% annual coupon rate is
currently traded at par $1000...
asked 3 hours ago -
1.
What is the minimum volume to use in the Spec 20 cuvette in order
to...
asked 4 hours ago -
A builder wants to install wall-to-wall carpeting in a living
room of length 8.87 m and...
asked 4 hours ago -
Organizational change can produce anxiety in those affected by
the change. In what ways can change...
asked 4 hours ago -
Ozone in the atmosphere may react with nitric oxide.
From the following data, calculate the DG...
asked 4 hours ago -
Steven Long, a bond analyst, is analyzing a convertible bond.
The characteristics of the bond are...
asked 4 hours ago