What is the maximum value of the force, P, using each of the allowable values? (It should be two different answers)
Will mark best answer!
What is the maximum value of the force, P, using each of the allowable values? (It...
What is the maximum value of the force, P, using each of the
allowable values? (It should be two different answers)
Will mark best answer!
3 M □ 1150mm 서서 allow 3
3 M □ 1150mm 서서 allow 3
Problem 4 Determine the maximum force P that can be applied on the system if the maximum allowable tension and compression in each bar are respectively 4 kN and 3 kN. d/2 d/2
4. For the 5 m long shaft ABC,
determine the allowable force P (based on analysis of max. compound
stresses and ) for the following shaft with given geometry and
allowable stresses for tensile strength and shear strength.
For the 5 m long shaft ABC, determine the allowable force P (based on analysis of max. compound stresses σ and τ) for the following shaft with given geometry and allowable stresses for tensile strength and shear strength. 4 70 points...
Problem 8.62 Part A Determine the maximum ram force P that can be applied to the clamp at Dif the allowable normal stress for the material is allow = 190 MPa (Figure 1) Express your answer using three significant figures and include the appropriate units. μΑ ? P= Value Units Submit Request Answer Provide Feedback Figure < 1 of 1 > 0 -200 mm 10 mm 40 mm 60 mm -10 mm
find the minimum force required to keep a book up. What is the maximum allowable force, as a function of θ and μ? Is there a special angle that arises? Given μ, make a rough plot of the allowed values of F for −π/2 < θ < π/2.
Two cables tied together at C are loaded as shown. Knowing that the maximum allowable tension in each cable is 650 N, determine (a) the magnitude of the largest force P which may be applied at C, (b) the corresponding value of a.
P1 P2 P3 A | В +d- a b The maximum allowable value of each of the reactions is 250.25. Neglecting the weight of the beam, determine the range of the distance 'd' for which the beam is safe. (Note in this case the reaction for the roller may be positive or negative.) If P1=50 N, P2=75 N, P3=260 N, a=450 mm, b=550 mm. i) d 2 (m, 3 sigfig) = ii) d s (m, 3 sigfig)=
The maximum allowable potential difference across a 200 mH inductor is 310 V . You need to raise the current through the inductor from 1.1 A to 2.9 A . What is the minimum time you should allow for changing the current? Express your answer to two significant figures and include the appropriate units.
Learning Goal: To calculate the maximum allowable stresses in pressure vessels, compute the minimum allowable thickness of pressure vessels to meet certain constraints, and observe and compare properties of different pressure vessel shapes. Engineers are considering two possible vessel shapes for storing fuel. One shape is cylindrical and the other is spherical. Each vessel would be constructed out of the same material such that its hoop stresses and longitudinal stresses would be no greater than 15.0 ksi . The cylindrical...
The transistor’s maximum allowable operating power, in W:
(kindly use the values given, thanks !)
A circular transistor of 10-mm diameter is cooled by impingement of an air jet exiting a 2-mm-diameter round nozzle with a velocity of 18 m/s and a temperature of 15°C. The jet exit and the exposed surface of the transistor are separated by a distance of 10 mm. Air jet Transisto If the transistor is well insulated at all but its exposed surface and the...