Sketch the output Vout for the given Vin in the right for (a) RC-100 us and...
Sketch the output Vout of the following circuits as a function of Vin. Mark and expressx- and y- intercepts in terms of parameters given in the drawing. (Hint: voltage divider) Vin Vref-AW R2 Vout VEE
Sketch the output Vout of the following circuits as a function of Vin. Mark and expressx- and y- intercepts in terms of parameters given in the drawing. (Hint: voltage divider) Vin Vref-AW R2 Vout VEE
Graph at least two periods of the Vout output when Vin is the
periodic signal 5sen (120πt).
Consider RC = 2.
C R Vin o o Vout ww +15V opamp U1 -15V
C R Vin o o Vout ww +15V opamp U1 -15V
(a) Sketch the output waveform Vout(t) of the circuit shown in Figure P3.42(a) when Vin = 9sin1000t V. Show the maximum and minimum values on the sketch and the equation for the curves at different time intervals. Assume that the diodes are ideal. (b) Repeat part (a) for the circuit of Figure P3.42(b).
Given Vin= 10 cos(200t). What is the steady state output Vout State your answer in the rectangular form Real + j Imaginary.
Graph at least two periods of the output Vout when Vin is the
periodic signal 2sen (2πt).
Consider Ri = Rf = 1kΩ, RC = 1 and D1 and D2 as rectifier
diodes.
Rf Ri o Vout Vin o +15V +15V opamp D2 DI opamp U2 U1 -15V -15V
Rf Ri o Vout Vin o +15V +15V opamp D2 DI opamp U2 U1 -15V -15V
Graph at least two periods of the output Vout when Vin is the
periodic signal 2sen (2πt).
Consider Ri = Rf = 1kΩ, RC = 1 and D1 and D2 as rectifier
diodes.
Rf Ri o Vout Vin o +15V +15V opamp D2 DI opamp U2 U1 -15V -15V
Rf Ri o Vout Vin o +15V +15V opamp D2 DI opamp U2 U1 -15V -15V
2. Sketch Vout VS Vin and Vout if Vin-10sin(2TT60t) for each of the following circuits. You may assume that the forward diode drops for the diodes equals zero Vout s v out Vin 5 V Vout out 3. Repeat problem 2 but with forward diode drops equal to 0.7 V 4. What are the primary mechanisms for current flow in a. A forward biased diode. b. A reverse biased diode not in breakdown. c. A reverse biased diode in breakdown...
Problem 5: (20 points) Given the following circuit VIN L Vout R a) Write the loop equation for the circuit, and then find the transfer function Vout(s) H(S) = Express H(s) so that the coefficient of the s in the denominator is 1. Vin(s) b) If Vin(t) is 20u(t), find out(t). c) If Vin(t) is 20u(t) find the final value using the final value theorem (show your work), d) Assume (R/L) = 10, if the input is Vin(t) = 100...
Vin across the left port, Vout across the right port.
R1 L1 C1 Find the phase difference (in radians) between an input sine wave at Vin and the output wave at Vout for the circuit in the above problem, as a function of frequency.
VCC RC1 RC2 Vout+ Vout Q1 NPN Q2 NPN Vin Vin- Q3 NPN Use VA-5V for Q3, and VA-00 for Q1 and Q2. If IEE-1mA, Rc,-12711 Ω, and RC2-1271 2Ω, what is the common mode to differential mode conversion gain? What is the common mode rejection ratio? Use Vr = 26mV and β 100 . Assume IE=Ic tr all a ACM-DMl CMRR- dB