Suppose a lab scale consistently measures 2 g too
high. How would that effect measurement of specific heat?
Too high, too low, or not at all?
You have not specified the other details regarding the experiment so the statement is pretty much unclear. I am still giving an answer based on the concept behind similar questins such as this.
Since the lab scale is giving the high measurement consistently, this means every time it is giving this high reading.
So overall there is no effect on specific heat because an error would have been caused if the scale gave a high reading just once and not consistently.
Hope this helps! Revert back if you have any queries!
Suppose a lab scale consistently measures 2 g too high. How would that effect measurement of...
Suppose the thermometer you used in your Charles's law experiment consistently gave low temperature readings. How would that influence the value of k' you would obtain? a. Make it too high. b. Make it too low. c. Would not influence it.
Question 1 O out of 5 points Would the calculated equilibrium constant be too high or too low if some solid calcium hydroxide leaked through the filter paper? Selected Answer: Answers: Too low Too high Too low No effect Question 2 O out of 5 points In titrating the Ca(OH)2 filtrate. A student consistently went past the end point by about 2.0 ml every time. Will the measured Ksp be too big or too small? Too big because the moles...
Explain how each of the following would affect the percent sulfate you calculated, i.e., too low, too high, no effect. Be specific. 3. You added 15 mL (instead of 10 mL) of 0.25 M BaCI, to your unknown. a. You were in a hurry to get out of lab, so you did not rinse the last traces of solid BaSO, from the reaction beaker into the funnel. b.
i
need help on questions 1-5
EXPERIMENT 2 Each person in the lab group should read each measurement and record it in this table to reduce errors t 1 Lab Partner 1 57.7 27.4 24.2 9 242 Partner 121. 100.59 Lab 23.9 1116 2 5 7 Lab Partner 3 57 Average Metal hot lost final T. gained Cup+ Stirrer Ti cold Water % Error QUESTIONS What would be the effect on your calculation of co if there was heat lost...
Indicate how each of the following would affect the value of the absorbance (too high, too low, or not effect) of the indicated solution. I really need help. I do not understand these questions! This is from a chemistry activity to determine the unknown concentration of an Erythrosin B solution by using a spectrophotometer. a. A student prepares solution A as instructed and pours it into a wet beaker. b. A student rinses the 10.00 mL pipet only with DI...
E AFTER COMPLETING LAB. ANSWER IN SPACE PROVIDED. Suppose the heat of neutralization had been determined using a glass beaker instead of a polystyrene coffee cup How would the measured value have been affected? The heat of combustion of octane, C,H,. can be measured in a way similar to the method youC used to measure the heat of neutralization. The bomb calorimeter is used instead of a coffee cup. The reaction is 2C,H,1)+ 25 O, (g) 16 CO, (g) +...
Explain what effect the following scenarios would have on the calculated specific heat (i.e. would it be calculated artificially high, low, or have no effect). Your explanation should address what variable(s) would be affected by the scenario and how that affects the calculation of specific heat.(1.5pt each) A student accidently dropped the piece of metal on the countertop during the process of transferring it from the boiling water bath to the calorimeter, but was quickly picked up and put into...
QUESTIONS Why do the crucible and lid need to be cooled before weighing? Be specific. 1. Assume that you failed to clean some grease off of your crucible before doing the percent water determination. If that grease then burned off during the determi- nation, explain how the percent water you calculated would be affected (i.e., to0 low, too high, no effect). Be specific. 2. Explain how each of the following would affect the percent sulfate you calculated, i.e, too low,...
What is the appropriate level of measurement/ primary scale. for each of the following variables? List each as nominal, ordinal, interval, or ratio. a. Stock price b. Socioeconomic status (coded as "low income", "middle income" and "high income") c. Number of days since you last ate in a restaurant (the exact number) d. Number of days since you last ate in a restaurant coded as (1=Within the past week, 2=With the past 2 weeks, 3=Within the past month, 4=Within the past 3 months, 5=More...
(1) Suppose the risk-free rate goes up to 7%. What effect would higher interest rates have on the SML and on the returns required on high-risk and low-risk securities? (2) Suppose instead that investors’ risk aversion increased enough to cause the market risk premium to increase to 8%. (Assume the risk-free rate remains constant.) What effect would this have on the SML and on returns of high-and low-risk securities?