In
case of any doubt please comment ..
Rotational Dynamics 1. You are using a wrench and trying to loosen a rusty nut. Which...
You are using a wrench in an attempt to loosen a nut by applying
a force as shown; but this fails to loosen the nut. Which one of
the following choices is most likely to loosen this tough nut?
Select all that apply.
Doubling the length or doubling the force will have the same
result, but doubling the length is easier.
Continue applying the same force as in the drawing and
eventually the nut will loosen.
Place a pipe of...
QUESTION 1 A wrench is used to loosen a nut as shown below by applying a force 13 N. Determine the torque (magnitude and direction:+for CCW and for CW) about the nut joint Express your answer in Sl units with 3 or more significant figures 0.28 m QUESTION 2 The drawing shows a person mass 59 kg. doing push-ups. Find the force exerted by the floor on each foot assuming that the person holds this position Express your answer in...
Tennessee State University Dr. Orville N. Bignall PHYS2110 Exam Fall 2014 Name points: 1 1) Which one of the following stresses would be most likely to cause a bone to fracture? A) tensile stress B) sheer stress C) bulk stress. D) compressive stress Points: 1 2) Tensile stress is A) the strain per unit length. B) the applied force per cross-sectional area c) the ratio of the change in length to the original length. D) he same as force. the...
Please answer all of question
3
Rotational Dynamics Assignment (200 Points) • Due Friday, July 31 at 5:00 pm Equations are in a separate document entitled “Equations for Rotational Dynamics Assignment” • Moments of inertia formulas are provided on the last page of this document • Show all of your work when solving equations. It is not sufficient to merely have a correct numerical answer. You need to have used legitimate equations and algebra. You also need to have correctly...
Dynamics.
Please find the following.
1-using the relative velocity method
2-using the instantaneous center of rotation method
thank-you in advance!.
6) In the position shown, calculate: (c) CD (a) vc (b) wBc WBC 305 mm min 254 mm 2 rad/s 45° 30°
You are trying to diversify your portfolio and reduce risk. Which of the following correlations between the returns of your portfolio and those of a proposed addition would give the most diversification benefit (other things equal)? Group of answer choices -1 +1 0 -.5
#9. if you were trying to separate two compounds with very close
boiling points how could you increase the efficiency of a
fractional distillation in order to separate those compounds?
thank you!!
b. Which component should still off ist? How does the boiling point of that liquid compare to comperare mesurements at the beginning of both simple and fractional distillation? d What does this comparison tell you about the composition of the station from both simple and tractional distillation? e....
Consider an 8 to 256 decoder built using 256 8-input AND gates. 1. For the decimal input A=65, 0x41, how many inverters will be used with the 8-input AND gate used to perform a successful decode of A? 2. Numbering the eight AND gate inputs a7 through a0, a7..a0, with a7 associated with the most significant bit of the input A and a0 associated with the least significant bit, list the inputs in descending order that will have an inverter...
1. You are asked to prepare a buffered solution at a pH of 4.30 using the following acids and its potassium salt. What ratio of [HA] / [A- ] is required for each system? a) Benzoic acid (C7H6O2, Ka = 6.4 x 10-5) b) Hypochlorous acid (HClO; Ka = 3.5 x 10-8) c) Which system would you choose to prepare the most effective buffering system? Explain. d) For the system you chose, what mass (in grams) of all the necessary...