Question

just check my value looks good? and help me find the h( cm) and the d(cm) please

2. Using the 30 cm ruler, measure the length of the copper specimen, estimating to the nearest tenth of a [mm] or to the nearest hundreth of a [cm] Note: Use the following technique in measuring the length of the specimen so that you are not biased in your reading. Place the specimen arbitrarily at some location against the ruler, then read the larger value on one end of the specimen to the nearest tenth of a [mm), call it hı, then read the smaller value on the other end again to the nearest tenth of a [mm), call it ho. Record these readings in (cm) in a data table similar to the one shown in Fig. 4. S. Araci 2 3. Repeat step 2, seven more Height (ruler) Diameter (ruler) h1 (cm) h2 cm) h (cm) times. di (cm) d2 cm) dcm) 1 15.9 6.3 16.0 5.0 2 22.5 10.4 19.0 7.0 4. Take the difference between 3 23.6 13.2 21.0 9.0 h, and he and record them as 4 25.5 16.2 25.0 11.0 h in data table of Fig.4 in 5 26.4 16.6 27.0 13.0 [cm]. The values should be 6 27.9 18.1 28.0 17.0 7 28.3 20.4 29.0 18.0 to the nearest one hundredth 8 29.7 of a [cm] 22.6 30.0 20.0 Fig. 4 - Raw data table for height and diameter measurements 5. Now repeat steps 2, 3, and 4 based on ruler with the diameter measurement of the specimen. But this time refer to the larger measurement as di, the smaller reading as da, and the difference as d. The diameter measurements can be recorded in the data table of Fig.4 again to the nearest one hundreth of a [cm]. Nanesith the ruler with the Marianeliner Recondite smallest sealedwidionas MEBOOK Pro

Answer 1

Answer