Homework Answers
Add Answer to:
Consider a steam power plant that operates on a simple ideal Rankine cycle and has a...
Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters...
Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is cooled in the condenser at a pressure of 10 kPa. Assume an isentropic efficiency of 85 percent for both the turbine and the pump. (a) the quality of the steam at the turbine exit (b) the thermal efficiency of the cycle (c) the mass flow rate of the steam.
. A steam power plant that operates on Rankine cycle has a net power output of...
. A steam power plant that operates on Rankine cycle has a net power output of 45 MW. Steam enters the turbine at 7 MPa and 500o C and is cooled in the condenser at a pressure of 10 kPa by running cooling water from a sea through the tubes of the condenser at rate of 2000 kg/s. Show the cycle on T‐s diagram with respect to saturation line, and determine (a) the thermal efficiency of the cycle, (b) the...
Consider a steam power plant that operales on a simple ideal Rankine cycle and has a...
Consider a steam power plant that operales on a simple ideal Rankine cycle and has a net power output of 45 MW Steam enters the turbine at 7 MPa and 500 C and is cooled in the condenser at a pressure of 10 kPa by running cooling water from a lake through the tubes of the condenser at a rate of 2000 kg/s. Use T-s diagram with respect to saturation lines, and determine (a) the thermal eMooncy ofthe cycle (%)...
Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters...
Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is cooled in the condenser at a pressure of 15 kPa. Determine the mass flow rate of the steam in kg/s.
2) Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam...
2) Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is cooled in the condenser at a pressure of 10 kPa. Show the cycle on a T-s diagram with respect to saturation lines, and determine (a) the quality of the steam at the turbine exit, (b) the thermal efficiency of the cycle, and (c) the mass flow rate of the steam.
Problem 10.3: Consider a 300-MW steam power plant that operates on a simple ideal Rankine cycle....
Problem 10.3: Consider a 300-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is cooled in the condenser at a pressure of 10 kPa. Show the cycle on a T-s diagram with respect to saturation lines, and determine (a) the quality of the steam at the turbine exit, (b) the thermal efficiency of the cycle, and (c) the mass flow rate of the steam.
Consider a steam power plant which operates on the simple ideal Rankine cycle (shown in the...
Consider a steam power plant which operates on the simple ideal
Rankine cycle (shown in the next page), where the boiler pressure
is 3 MPa and the condenser saturation temperature is 50°C. The
temperature at the exit of the boiler is 500°C. Water leaves the
condenser as a saturated liquid. The mass flow rate through each
component is 15 kg/s. Calculate:
1. The power output of the steam power plant
2. The thermal efficiency of the steam power plant
Now,...
A Rankine Cycle based steam power plant produces 200 MW of power. Steam exits the boiler...
A Rankine Cycle based steam power plant produces 200 MW of power. Steam exits the boiler at 3 MPa and 500° C. The turbine exit is at 40 kPa. Isentropic efficiencies of the turbine and pump are 75% and 70% respectively. Show the cycle on a T-s diagram Calculate the mass flow rate of steam Determine the heat transfer rates in the boiler and condenser in MW Determine the cycle efficiency Determine the mass flow rate of the condenser cooling...
Consider a steam power plant that operates on a reheat Rankine cycle and has a net...
Consider a steam power plant that operates on a reheat Rankine cycle and has a net power output of 80 MW. Steam enters the high-pressure turbine at 10 MPa and 500°C and the low-pressure turbine at 1 MPa and 500°C. Steam leaves the condenser as a saturated liquid at a pressure of 10 kPa. The isentropic efficiency of the turbine is 74 percent and that of the pump is 95 percent. Determine the quality (or temperature, if superheated) of the...
Consider a steam power plant that operates on the ideal regenerative Rankine cycle with a closed...
Consider a steam power plant that operates on the ideal
regenerative Rankine cycle with a closed feedwater heater as shown
in the figure. The plant maintains the turbine inlet at 3000 kPa
and 3508C; and operates the condenser at 20 kPa. Steam is extracted
at 1000 kPa to serve the closed feedwater heater, which discharges
into the condenser after being throttled to condenser pressure.
Calculate the work produced by the turbine, the work consumed by
the pump, and the heat...
Consider a steam power plant that operales on a simple ideal Rankine cycle and has a net power output of 45 MW Steam enters the turbine at 7 MPa and 500 C and is cooled in the condenser at a pressure of 10 kPa by running cooling water from a lake through the tubes of the condenser at a rate of 2000 kg/s. Use T-s diagram with respect to saturation lines, and determine (a) the thermal eMooncy ofthe cycle (%)...
2) Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is cooled in the condenser at a pressure of 10 kPa. Show the cycle on a T-s diagram with respect to saturation lines, and determine (a) the quality of the steam at the turbine exit, (b) the thermal efficiency of the cycle, and (c) the mass flow rate of the steam.
Problem 10.3: Consider a 300-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is cooled in the condenser at a pressure of 10 kPa. Show the cycle on a T-s diagram with respect to saturation lines, and determine (a) the quality of the steam at the turbine exit, (b) the thermal efficiency of the cycle, and (c) the mass flow rate of the steam.
Consider a steam power plant which operates on the simple ideal
Rankine cycle (shown in the next page), where the boiler pressure
is 3 MPa and the condenser saturation temperature is 50°C. The
temperature at the exit of the boiler is 500°C. Water leaves the
condenser as a saturated liquid. The mass flow rate through each
component is 15 kg/s. Calculate:
1. The power output of the steam power plant
2. The thermal efficiency of the steam power plant
Now,...
Consider a steam power plant that operates on the ideal
regenerative Rankine cycle with a closed feedwater heater as shown
in the figure. The plant maintains the turbine inlet at 3000 kPa
and 3508C; and operates the condenser at 20 kPa. Steam is extracted
at 1000 kPa to serve the closed feedwater heater, which discharges
into the condenser after being throttled to condenser pressure.
Calculate the work produced by the turbine, the work consumed by
the pump, and the heat...
Most questions answered within 3 hours.
-
A barium hydroxide solution is prepared by dissolving 1.91 g1.91
g of Ba(OH)2Ba(OH)2 in water to...
asked 6 minutes ago -
barium oxide with water Express your answer as a chemical
equation. Identify all of the phases...
asked 9 minutes ago -
In the laboratory a "coffee cup"
calorimeter, or constant pressure calorimeter, is
frequently used to determine...
asked 8 minutes ago -
Refer to the following table to answer the next five questions:
Number of Workers Output 1...
asked 11 minutes ago -
As part of Canadian government efforts to boost up economic
trade with international community, on February...
asked 8 minutes ago -
Deinococcus radiodurans is probably the world’s toughest
bacterium (first discovered growing in ground meat that had...
asked 5 minutes ago -
Which Model can be selected if user is involved in all phases of
sdlc.
select one...
asked 13 minutes ago -
An initial solution is made by combing 13 mL of 0.8 M
chloroacetic acid with 20...
asked 18 minutes ago -
Pellets of mass 2.0 g are fired in parallel paths with speeds of
120 m/s through...
asked 22 minutes ago -
You perform a study to investigate whether exercise influences
sleep duration. Participants record their total sleep...
asked 26 minutes ago -
The cell Cu(s)(1M) | Cu2+ || (1M) |
Cu(s) has E = 0.182 V
The cell...
asked 38 minutes ago -
i. y[n + 1] + 1.5y[n] = x[n]
ii. y[n + 1] + 0.8y[n] = x[n]...
asked 41 minutes ago