Question

Parallel circuit transmission lines in the form of ACSR Merlin di line = 2m, d4-2m Determine the electrical conductivity per

0 0
Add a comment Improve this question Transcribed image text
Answer #1

60 dy 12m 5006 em offieximale diametere of ACSR Merlin o conductor 117.35x10 m) Area of creen adlien 1179.9 Mb X16 CM dc ReveCamR of phase c Vre) x (CC) 8. CTX 103) 3 x 4.47)? 0019 Sony CMR ER): 70-1980:13X0:19 - 10.16) am D BA Between ab Vabxabxab

Add a comment
Know the answer?
Add Answer to:
Parallel circuit transmission lines in the form of ACSR Merlin di line = 2m, d4-2m Determine...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • A 3-phase, 60-Hz transmission line consisting of one ACSR Bluejay conductor per phase has a spacing...

    A 3-phase, 60-Hz transmission line consisting of one ACSR Bluejay conductor per phase has a spacing of 9 m between conductors. The transmission line is 100 miles long and delivers 40 MW at 220 kV with a 0.9 pf lagging. Determine Voltage, current, and power factor at the sending end Voltage regulation and efficiency

  • Problem 4 (10 points) A three-phase, 60 Hz, completely transposed overhead transmission line has one Redwing...

    Problem 4 (10 points) A three-phase, 60 Hz, completely transposed overhead transmission line has one Redwing ACSR conductor per phase. The conductors are oriented in a flat, horizontal configuration with 5 meter spacings between A and B, 5 meter spacing between B and C, and 10 meters between A and C. What is the inductive reactance for a 10 mile length of this transmission line? Problem 5 (10 points) a.) Calculate the capacitance-to-neutral (F/m) for the transmission line of problem...

  • Problem #1 Part I (50 points) Consider the following one-line diagram of a three-phase power system. Assume that the system has the following base quantities: S3 100 MVA, and VbaselL 38 kV at the...

    Problem #1 Part I (50 points) Consider the following one-line diagram of a three-phase power system. Assume that the system has the following base quantities: S3 100 MVA, and VbaselL 38 kV at the generator side. The rated line-to-line terminal voltage of the generator (BUS 1) is 38 kV. A single-circuit three-phase transposed overhead line composed by one ACSR Partridge conductor per phase with vertical configuration. The transmission line length is 50 km and the distance between phases a-b, b-c...

  • I need help to solve this questions about Generator Governor Droop and Transmission Line. A complete...

    I need help to solve this questions about Generator Governor Droop and Transmission Line. A complete solutions with answers would be great. Thank you Generation Question 1 to 5 relate to the following grid connected generator. A governor-controlled, steam-driven 450 MW synchronous generator with 5% droop is synchronized to the 60 Hz grid and its load set-point adjusted to deliver 300 MW to the grid. Q1. (a) 000 What is the actual droop of the generating unit? 0.0225 Hz/MW (b)...

  • Fig Qshows the one-line diagram of a three-phase power system. As shown in Fig. Q3. the...

    Fig Qshows the one-line diagram of a three-phase power system. As shown in Fig. Q3. the two zones are connected by a 400 MVA, 240-kV/24-kV, Ý-A three phase transformer. The Y-A three phase transfonmer has an equivalent series impedance of ZTH - 1.2 + j1.6n per phase referred to the high voltage side (primary side). The three-phase power system can be studied with per unit quantities using base values of S-500 MVA and 240 kV in zone 1. By using...

  • solve no: 3.14 , 3.16, 3.19 please show each step and solve for beginners 120 Power...

    solve no: 3.14 , 3.16, 3.19 please show each step and solve for beginners 120 Power System Analysis 3.12. A single-phase system similar to that shown in Figure 3.11 has two transformers A-B a B-C connected by a line B feeding a load at the receiving end C. The ratings and parame ter values of the components are 500 V/1.5 kV, 9.6 kVA. leakage reactance 5 % 1.2 kV/120 V, 7.2 kVA, leakage reactance 4 % series impedance (0.5 +...

  • Bob places a neutrally charged conducting ball next to a large, charged plate. The conducting ball...

    Bob places a neutrally charged conducting ball next to a large, charged plate. The conducting ball is weakly attracted to the plate. What is the net charge on the plate? 1. a) Positive b) Negative c) Neutral (i.e., zero charge) d) Either positive or negative, but it is impossible to tell which A +1 C charge is at the origin, and a second +1 C charge is at position (x,y)-(2 m, 0). How much work is required to move the...

  • summarizr the followung info and write them in your own words and break them into different...

    summarizr the followung info and write them in your own words and break them into different key points.   6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...

  • summatize the following info and break them into differeng key points. write them in yojr own...

    summatize the following info and break them into differeng key points. write them in yojr own words   apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...

  • How can we assess whether a project is a success or a failure? This case presents...

    How can we assess whether a project is a success or a failure? This case presents two phases of a large business transformation project involving the implementation of an ERP system with the aim of creating an integrated company. The case illustrates some of the challenges associated with integration. It also presents the obstacles facing companies that undertake projects involving large information technology projects. Bombardier and Its Environment Joseph-Armand Bombardier was 15 years old when he built his first snowmobile...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT