The part number for the thermistor is BC2398-ND. Use the link below to access the corresponding...
The part number for the thermistor is BC2398-ND. Use the link below to access the corresponding datasheet. Use this datasheet to plot the resistances at 0⁰ C, 25⁰ C and 100⁰C. Assume your thermistor is NTCLE100E3338.
https://www.digikey.com/products/en?keywords=BC2398-ND%20
Please show steps and explain procedures thank you
Homework Answers
Hello,
Please find
the answer attached as under. Please give a thumbs up rating if you
find the answer useful! Have a rocking day ahead!
The resistance of a thermistor will vary depending on the temperature coefficient. The value may increase or decrease depending on whether the coefficient has a negative or positive value. However, the part number that is mentioned in the question has it's complete characteristic defined in the data sheet itself. i.e. the resistance values at 0?0?, 250, and 1000? are plotted in the data sheet itself. You can find the concerned data in the table titled "Resistance values at intermediate temperatures" in the data sheet. For your convenience, the values are as below:
Resistance at 0?0C = 7.904 ohms
Resistance at 250C = 3.3 ohms
Resistance at 100?0C = 0.473 ohms
The plot is shown below:
Add Answer to:
The part number for the thermistor is BC2398-ND. Use the link
below to access the corresponding...
PART C PLEASE!!! IF YOU KNOW HOW TO CODE MATLAB PLEASE HELP THANK YOU Write a Matlab/Python scrip...
PART C PLEASE!!! IF YOU KNOW HOW TO CODE MATLAB PLEASE HELP
THANK YOU
Write a Matlab/Python script which computes the trajectory of P
according to the system of equations (1) and the corresponding
(non-dimensional) range for given values of (α,φ,0), varying values
of φ 0 Plot the trajectories for 6 values of φ 0 of your choice in
the interval 0< φ0 π/2.
Compute the corresponding range reached by each trajectory.
Note: Special attention will be given to the...
Part Two. Can you help me with the binomial probability distribution? Please see instructions below. Please...
Part Two. Can you help me with the binomial probability
distribution? Please see instructions below.
Please show all steps to understand better. Thank you in
advance.
5. Use the binomial distribution table to find the binomial probabilities for these cases: a) n=10, p=1, k= 3 b) n=14, p = 6, k = 7 c) n =25, p=5, k = 14 6. Consider a binomial experiment with n = 20 and p=0.70. Use the binomial formula to calculate: a) P(x =...
I do not understand what theta m is in part a? Please complete problem and explain...
I do not understand what theta m is in part a? Please complete
problem and explain what theta m is. Thank you!
1) (25 points) A 1-kg collar is attached to a spring and slides without friction along a circular rod which lies in a vertical plane. The spring has a constant k-0.60 kN/m and is undeformed when the collar is at point B. The collar is release from rest at point C. Calculate 0m, where θm is the maximum...
Hide/Show Time Remaining Part 1 of 1- Question 1 of 38 When designing a new database,...
Hide/Show Time Remaining Part 1 of 1- Question 1 of 38 When designing a new database, the first question users should ask themselves is O A. How much information is going to be stored in this database? B. Where should this database be stored? O C. Who is going to use this database? O D. What questions should this database be able to answer? Question 2 of 38 When linking two tables in a relational database, a user will use...
please answer all questions neatly and use Matlab for part C Vout - - Current Source...
please answer all questions neatly and use Matlab for part C
Vout - - Current Source Current-to-Voltage Converter SkW variable voltage 0-5V Figure 4. Current- to- voltage converter 3.- Current-to-Voltage Converter An op amp can be used to produce a voltage proportional to a given current as shown in fig. 4 a) (5 points) Derive the formula for the output voltage Vout. For full credit show all the steps of the formula derivation in a clear way, and indicate which...
Shoney Video Concepts produces a line of videodisc players to be linked to personal computers for video games. Videodiscs have much faster access time than tape. With such a computer/video link, the g...
Shoney Video Concepts produces a line of videodisc players to be linked to personal computers for video games. Videodiscs have much faster access time than tape. With such a computer/video link, the game becomes a very realistic experience. In a simple driving game where the joystick steers the vehicle, for example, rather than seeing computer graphics on the screen, the player is actually viewing a segment of a videodisc shot from a real moving vehicle. Depending on the action of...
Question 1 Figure 1 below shows part of the review of the night cream by a...
Question 1
Figure 1 below shows part of the review of the night cream by
a beauty blogger in her beauty review database (Microsoft
Access).
Figure 1: “Cosmetics” table
(a) Which field is the most appropriate field to act as the
primary key of the given table? Give explanation to your
answer.
(b) What should be the data type for the field
“Recommendation”?
(c) If “Number” were set as the data type of “Price” and
“Weight”, which data type should...
BACKGROUND The first part of this assignment focuses on the thermodynamics of enzyme-catalysed reactions. To answer the questions posed you will need apply the following two equations. Note that you...
BACKGROUND The first part of this assignment focuses on the thermodynamics of enzyme-catalysed reactions. To answer the questions posed you will need apply the following two equations. Note that you may need to re- arrange these equations to determine the value you need. You also need to take care with the units of the values you use and determine. The first equation defines the relationship between the change in free energy (AG ") and the equilibrium between the products and...
3) Out of the following, name which kind of attack you carried out in part 1...
3) Out of the following, name which kind of attack you carried out in part 1 and part2: a. ciphertext only, b. known plaintext, c. chosen plaintext, d. chosen ciphertext. Explain your answer Problem 3 10 points] A 4-bit long message was encrypted using one-time pad to yield a cipher-text “1010” Assuming the message space consists of all 4-bit long messages, what is the probability that the corresponding plaintext was “1001”? Explain your answer. Problem 4 Assume we perform a...
would you like please answer all questions in part 3 THEVENIN'S THEOREM AND MAXIMUM POWER TRANSFER...
would you like please answer all questions in part 3
THEVENIN'S THEOREM AND MAXIMUM POWER TRANSFER 131 Part 3 Maximum Power Transfer (Experimental Approach) (a) Construct the network of Fig. 11.8. Insert the measured value of each resistor R EIOV 95.732 218S2 325 2 . 424e R FIG. 11.8 Eths Vabs 6.8v Rths Resissn (b) The Thevenin equivalent circuit will now be determined for the network to the lel of the terminals a-b without disturbing the structure of the network....
PART C PLEASE!!! IF YOU KNOW HOW TO CODE MATLAB PLEASE HELP
THANK YOU
Write a Matlab/Python script which computes the trajectory of P
according to the system of equations (1) and the corresponding
(non-dimensional) range for given values of (α,φ,0), varying values
of φ 0 Plot the trajectories for 6 values of φ 0 of your choice in
the interval 0< φ0 π/2.
Compute the corresponding range reached by each trajectory.
Note: Special attention will be given to the...
Part Two. Can you help me with the binomial probability
distribution? Please see instructions below.
Please show all steps to understand better. Thank you in
advance.
5. Use the binomial distribution table to find the binomial probabilities for these cases: a) n=10, p=1, k= 3 b) n=14, p = 6, k = 7 c) n =25, p=5, k = 14 6. Consider a binomial experiment with n = 20 and p=0.70. Use the binomial formula to calculate: a) P(x =...
I do not understand what theta m is in part a? Please complete
problem and explain what theta m is. Thank you!
1) (25 points) A 1-kg collar is attached to a spring and slides without friction along a circular rod which lies in a vertical plane. The spring has a constant k-0.60 kN/m and is undeformed when the collar is at point B. The collar is release from rest at point C. Calculate 0m, where θm is the maximum...
Hide/Show Time Remaining Part 1 of 1- Question 1 of 38 When designing a new database, the first question users should ask themselves is O A. How much information is going to be stored in this database? B. Where should this database be stored? O C. Who is going to use this database? O D. What questions should this database be able to answer? Question 2 of 38 When linking two tables in a relational database, a user will use...
please answer all questions neatly and use Matlab for part C
Vout - - Current Source Current-to-Voltage Converter SkW variable voltage 0-5V Figure 4. Current- to- voltage converter 3.- Current-to-Voltage Converter An op amp can be used to produce a voltage proportional to a given current as shown in fig. 4 a) (5 points) Derive the formula for the output voltage Vout. For full credit show all the steps of the formula derivation in a clear way, and indicate which...
Question 1
Figure 1 below shows part of the review of the night cream by
a beauty blogger in her beauty review database (Microsoft
Access).
Figure 1: “Cosmetics” table
(a) Which field is the most appropriate field to act as the
primary key of the given table? Give explanation to your
answer.
(b) What should be the data type for the field
“Recommendation”?
(c) If “Number” were set as the data type of “Price” and
“Weight”, which data type should...
BACKGROUND The first part of this assignment focuses on the thermodynamics of enzyme-catalysed reactions. To answer the questions posed you will need apply the following two equations. Note that you may need to re- arrange these equations to determine the value you need. You also need to take care with the units of the values you use and determine. The first equation defines the relationship between the change in free energy (AG ") and the equilibrium between the products and...
would you like please answer all questions in part 3
THEVENIN'S THEOREM AND MAXIMUM POWER TRANSFER 131 Part 3 Maximum Power Transfer (Experimental Approach) (a) Construct the network of Fig. 11.8. Insert the measured value of each resistor R EIOV 95.732 218S2 325 2 . 424e R FIG. 11.8 Eths Vabs 6.8v Rths Resissn (b) The Thevenin equivalent circuit will now be determined for the network to the lel of the terminals a-b without disturbing the structure of the network....
Most questions answered within 3 hours.
-
While rotating the tires on your car you notice a rock [mass =
0.1 Kg] stuck...
asked 1 hour ago -
Using MARS simulator, write MIPS programs according to
the following scenarios: Receive a positive integer number...
asked 2 hours ago -
An object in front of a concave mirror has a real image that is
11.5 cm...
asked 3 hours ago -
Consider the reaction, C3 H8 + O2 --> CO2 + H2O. How many
moles of O2...
asked 4 hours ago -
You and your opponent both roll a fair die. If you both roll the
same number,...
asked 5 hours ago -
In a study of the accuracy of fast food drive-through orders,
Restaurant A had 257 accurate...
asked 5 hours ago -
Identify and describe in detail the four categories of
institutions that could be included in a...
asked 5 hours ago -
In python
class Customer:
def __init__(self, customer_id, last_name, first_name, phone_number, address):
self._customer_id = int(customer_id)
self._last_name =...
asked 5 hours ago -
What is an example of a limitation in implementing a new
ERP system and how it...
asked 5 hours ago -
In a section of 9.7cm of an artery with a radius of 2.6mm there
is a...
asked 5 hours ago -
the two carboxylic acid groups of aspartic acid have different
acidities with pKa values of 2.1...
asked 5 hours ago -
Would CuCO3 aqueous salt combined with calcium chloride
form a solid precipitate? If so, what would...
asked 5 hours ago