Homework Answers
Add Answer to:
3. The voltage waveform shown below was observed at the sending end of a lossless transmission...
In response to a step voltage, the voltage waveform shown in the accompanying figure was observed at the midpoint of a lossless transmission line with Zo-50 Ω and up 2 x 108 m/s. Determine: i) the le...
In response to a step voltage, the voltage waveform shown in the accompanying figure was observed at the midpoint of a lossless transmission line with Zo-50 Ω and up 2 x 108 m/s. Determine: i) the length of the line, ii) ZL, iii) Rg and iv) Vg. L, 111 Vl/2, 1) 12 V1 15 21 (us) 3VF--
In response to a step voltage, the voltage waveform shown in the accompanying figure was observed at the midpoint of a lossless transmission...
3-8. A lossless transmission line is terminated in an open circuit. The sending end is ener gized...
3-8. A lossless transmission line is terminated in an open circuit. The sending end is ener gized by a generator which has an open-circuit output voltage of V, (rms) and an inter- val impedance equal to the characteristic impedance of the line. Show that the sending- end voltage is equal to the output voltage of the generator.
3-8. A lossless transmission line is terminated in an open circuit. The sending end is ener gized by a generator which has an...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect...
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect a sinusoidal source with internal resistance Rs=50 2, and 10 Volts peak value to feed a load of ZL=300 Q. At an operating signal wavelength of do, the length of the transmission line is L=2.25o. Determine the followings: a) Standing wave ratio on the line b) Average power delivered to the load in dBm. c) The voltage and current phasor expressions on the transmission...
A lossless transmission line with characteristic impedance of 75Ω measures 1.4λ at a certain working frequency....
A lossless transmission line with characteristic impedance of 75Ω measures 1.4λ at a certain working frequency. The line is powered by a generator with negligible impedance and an open circuit voltage of Vg=10∠0° [V]. A load of 50-i50Ω is connected at the end of the line. Find a) The reflection coefficient. b)The stationary wave ratio. c)The input impedance of the line. d)The voltage at the entrance of the line. e)The voltage at the load. f)The average power delivered to the...
3, A lossless transmission line of length 1 = 1.57λ and characteristic 17 +j60Ω. impedance Z,...
3, A lossless transmission line of length 1 = 1.57λ and characteristic 17 +j60Ω. impedance Z, = 50Ω is loaded with an impedance of ZL Compute the following: (a) Reflection coefficient at the load in both rectangular and polar form. (b) SWR, and RL (c) Input impedance at the generator. (d) Reflection coefficient at the input to the transmission line in both rectangular and polar form
Problem 2.25 A lossless transmission line is terminated in a short circuit. How long (in wavelengths)...
Problem 2.25 A lossless transmission line is terminated in a short circuit. How long (in wavelengths) should the line be in order for it to appear as an open circuit at its input terminals? Problem 2.27 A 75-Ω resistive load is preceded by a λ/4 section of a 50-Q lossless line, which itself is preceded by another λ/4 section ofa 100-Q line. What is the input impedance? Problem 2.31 A generator with 300 V and Znected to a load ZL...
A lossless transmission line with 50 Ω characteristic impedance has a 50 V step function placed...
A lossless transmission line with 50 Ω characteristic impedance has a 50 V step function placed on it, generated from a source impedance of 10 Ω. Assume the velocity of the signal on the line is 106 m/s, the line is 100 m long, and is terminated in a load impedance of 100 Ω. (a) What is the source voltage? (4 marks) (b) How long does the step function take to reach the termination load impedance? (2 marks) (c) What...
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i....
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i. Determine the length of an open circuit 50Ω line required to create a 0.1 nH inductor at a frequency of 10 GHz. (6 marks) ii. Determine the input impedance of the line in part () if the open circuit is changed to a short circuit. (3 marks)...
4. A 120- lossless transmission line is terminated in an impedance of-j 60. If the amplitude...
4. A 120- lossless transmission line is terminated in an impedance of-j 60. If the amplitude of the incident-wave voltage at the load is 100 V, calculate the amplitude of the total voltage at the load. Also determine the distance from the load to the first voltage minimum and the amplitude of the ac voltage at this minimum
In response to a step voltage, the voltage waveform shown in the accompanying figure was observed at the midpoint of a lossless transmission line with Zo-50 Ω and up 2 x 108 m/s. Determine: i) the length of the line, ii) ZL, iii) Rg and iv) Vg. L, 111 Vl/2, 1) 12 V1 15 21 (us) 3VF--
In response to a step voltage, the voltage waveform shown in the accompanying figure was observed at the midpoint of a lossless transmission...
3-8. A lossless transmission line is terminated in an open circuit. The sending end is ener gized by a generator which has an open-circuit output voltage of V, (rms) and an inter- val impedance equal to the characteristic impedance of the line. Show that the sending- end voltage is equal to the output voltage of the generator.
3-8. A lossless transmission line is terminated in an open circuit. The sending end is ener gized by a generator which has an...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect a sinusoidal source with internal resistance Rs=50 2, and 10 Volts peak value to feed a load of ZL=300 Q. At an operating signal wavelength of do, the length of the transmission line is L=2.25o. Determine the followings: a) Standing wave ratio on the line b) Average power delivered to the load in dBm. c) The voltage and current phasor expressions on the transmission...
3, A lossless transmission line of length 1 = 1.57λ and characteristic 17 +j60Ω. impedance Z, = 50Ω is loaded with an impedance of ZL Compute the following: (a) Reflection coefficient at the load in both rectangular and polar form. (b) SWR, and RL (c) Input impedance at the generator. (d) Reflection coefficient at the input to the transmission line in both rectangular and polar form
Problem 2.25 A lossless transmission line is terminated in a short circuit. How long (in wavelengths) should the line be in order for it to appear as an open circuit at its input terminals? Problem 2.27 A 75-Ω resistive load is preceded by a λ/4 section of a 50-Q lossless line, which itself is preceded by another λ/4 section ofa 100-Q line. What is the input impedance? Problem 2.31 A generator with 300 V and Znected to a load ZL...
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i. Determine the length of an open circuit 50Ω line required to create a 0.1 nH inductor at a frequency of 10 GHz. (6 marks) ii. Determine the input impedance of the line in part () if the open circuit is changed to a short circuit. (3 marks)...
4. A 120- lossless transmission line is terminated in an impedance of-j 60. If the amplitude of the incident-wave voltage at the load is 100 V, calculate the amplitude of the total voltage at the load. Also determine the distance from the load to the first voltage minimum and the amplitude of the ac voltage at this minimum
Most questions answered within 3 hours.
-
Rice Products in Bangladesh
Business behavior is derived in large part from the basic cultural
environment...
asked 45 minutes ago -
The following base sequence is found for a mRNA fragment from
wild-type E. coli: 5'- UAUCAGUAGAUAAUGUAACC-3'...
asked 1 hour ago -
For this exercise, round all regression parameters to three
decimal places.
One of the two tables...
asked 1 hour ago -
What is the 5% level of significance for mean = 3.60, standard
deviation = 0.94, and...
asked 1 hour ago -
Prior to beginning work on this discussion, please read the
article by Hayley Peterson, 15 Companies...
asked 1 hour ago -
Which pair of aqueous solutions, when mixed, will form a
precipitate?
A) NaNO3 and AgC2H3O2
B)...
asked 2 hours ago -
1-Write an algorithm to get two numbers from the user (as
inputs) and calculate the sum...
asked 5 hours ago -
Define white-collar crime. What is the difference between
offender and offense-based definitions of white-collar crime? What...
asked 6 hours ago -
Consider a reaction which is 1st order with respect to A and 1st
order with respect...
asked 6 hours ago -
c++
The length of the hypotenuse of a right-angled triangle is the
square root of the...
asked 6 hours ago -
When a metal rod is heated, not only its resistance but also its
length and cross‐sectional...
asked 6 hours ago -
write a c++ program that computes the L^1 - Norm of a given
vector (L^1 norm...
asked 6 hours ago