Homework Answers
Add Answer to:
Design a device for measuring the level of liquid in a 5 m high tank and...
just need the truth tables sop and circuits CET 363 Digital Circuits Design Project Liquid storage...
just need the truth tables sop and circuits
CET 363 Digital Circuits Design Project Liquid storage tank control unit In this projact you will design the control unit for a liquid storage tank. The control unit monitors temperature and liquid levels. The unit will maintain the appropriate liquid level by controlling input and output valves. The control unit also controls a heater to maintain the correct temperature range. Finaly, an alarm is activated if the liquid is too hot or...
Four large tanks at a chemical plant contain different liquids being bested. Liquid-level sensors are used...
Four large tanks at a chemical plant contain different liquids being bested. Liquid-level sensors are used to detect whenever the level in thanks A and B rises. Above a predetermined level Temperature sensor in tanks C and D detect when the temperature in these drops below a prescribed temperature limit. Assume that the liquid-level sensor outputs(A and B)are LOW (0) when the level is satisfactory and HIGH(1)when the level is too high. Also, the temperature-sensor outputs (C and D)are LOW(0)when...
Liquid Level 1. You are using a 1 turn rotatory potentiometer to design a level sensor...
Liquid Level 1. You are using a 1 turn rotatory potentiometer to design a level sensor to measure liquid level on a tank. The total resistance of the potentiometer R = 10K and the output voltage that is measured by an Arduino is IV. Find the angle of turned in the potentiometer as well as the height of liquid level in the tank. 2. A platinum resistance coil is to be used as a temperature sensor (Rthermal) and has a...
1. A large tank structure 5 m high is to be constructed on the site as...
1. A large tank structure 5 m high is to be constructed on the site as shown below on Figure 1. The intention is to fill the tank with water. Determine the vertical total stress, vertical effective stresses and pore water pressure at the centre point of both the clay layer and the sand layer (a) before the tank is constructed (b) immediately after the tank is first filled with water. (c) Many years later assuming the tank remains full...
A new concrete water tank (unit weight= 24 kN/m3) with inner diameter of 13.8 m with...
A new concrete water tank (unit weight= 24 kN/m3) with inner diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is proposed for construction to cover the water shortage of government officers’ quarters of UNIMAS that located near to an existing 6.0 m high concrete water tank with similar diameter. The existing water tank sits on a concrete foundation of diameter 15.0 m and thickness of 0.6 m which is below the finished surface level. The...
I am a student of EST, and now I have a group open project, which required us to design a device ...
I am a student of EST, and now I have a group open project, which required us to design a device using components as shown below. We can choose maximum 9 credits worth of components, and the credits are marked after each component. I am asking for some good ideas. Please describe what can be made and what components should be used. Please provide ideas as more as possible. 1-101-Ultrasonic Sensor-Credit 1 2-102-Sound Wave Sensor (MAX9812)- Credit 2 3-103-Microphone Sound...
A new concrete water tank (unit weight= 24 kN/m3) with inner diameter of 13.8 m with...
A new concrete water tank (unit weight= 24 kN/m3) with inner
diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is
proposed for construction to cover the water shortage of government
officers’ quarters that located near to an existing 6.0 m high
concrete water tank with similar diameter. The existing water tank
sits on a concrete foundation of diameter 15.0 m and thickness of
0.6 m which is below the finished surface level. The existing water...
A new concrete water tank (unit weight= 24 kN/m3) with inner diameter of 13.8 m with...
A new concrete water tank (unit weight= 24 kN/m3) with inner
diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is
proposed for construction to cover the water shortage of government
officers’ quarters that located near to an existing 6.0 m high
concrete water tank with similar diameter. The existing water tank
sits on a concrete foundation of diameter 15.0 m and thickness of
0.6 m which is below the finished surface level. The existing water...
A new concrete water tank (unit weight= 24 kN/m3) with inner diameter of 13.8 m with...
A new concrete water tank (unit weight= 24 kN/m3) with inner
diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is
proposed for construction to cover the water shortage of government
officers’ quarters that located near to an existing 6.0 m high
concrete water tank with similar diameter. The existing water tank
sits on a concrete foundation of diameter 15.0 m and thickness of
0.6 m which is below the finished surface level. The existing water...
A new concrete water tank (unit weight= 24 kN/m3) with inner diameter of 13.8 m with...
A new concrete water tank (unit weight= 24 kN/m3) with inner
diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is
proposed for construction to cover the water shortage of government
officers’ quarters that located near to an existing 6.0 m high
concrete water tank with similar diameter. The existing water tank
sits on a concrete foundation of diameter 15.0 m and thickness of
0.6 m which is below the finished surface level. The existing water...
just need the truth tables sop and circuits
CET 363 Digital Circuits Design Project Liquid storage tank control unit In this projact you will design the control unit for a liquid storage tank. The control unit monitors temperature and liquid levels. The unit will maintain the appropriate liquid level by controlling input and output valves. The control unit also controls a heater to maintain the correct temperature range. Finaly, an alarm is activated if the liquid is too hot or...
Four large tanks at a chemical plant contain different liquids being bested. Liquid-level sensors are used to detect whenever the level in thanks A and B rises. Above a predetermined level Temperature sensor in tanks C and D detect when the temperature in these drops below a prescribed temperature limit. Assume that the liquid-level sensor outputs(A and B)are LOW (0) when the level is satisfactory and HIGH(1)when the level is too high. Also, the temperature-sensor outputs (C and D)are LOW(0)when...
Liquid Level 1. You are using a 1 turn rotatory potentiometer to design a level sensor to measure liquid level on a tank. The total resistance of the potentiometer R = 10K and the output voltage that is measured by an Arduino is IV. Find the angle of turned in the potentiometer as well as the height of liquid level in the tank. 2. A platinum resistance coil is to be used as a temperature sensor (Rthermal) and has a...
1. A large tank structure 5 m high is to be constructed on the site as shown below on Figure 1. The intention is to fill the tank with water. Determine the vertical total stress, vertical effective stresses and pore water pressure at the centre point of both the clay layer and the sand layer (a) before the tank is constructed (b) immediately after the tank is first filled with water. (c) Many years later assuming the tank remains full...
A new concrete water tank (unit weight= 24 kN/m3) with inner
diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is
proposed for construction to cover the water shortage of government
officers’ quarters that located near to an existing 6.0 m high
concrete water tank with similar diameter. The existing water tank
sits on a concrete foundation of diameter 15.0 m and thickness of
0.6 m which is below the finished surface level. The existing water...
A new concrete water tank (unit weight= 24 kN/m3) with inner
diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is
proposed for construction to cover the water shortage of government
officers’ quarters that located near to an existing 6.0 m high
concrete water tank with similar diameter. The existing water tank
sits on a concrete foundation of diameter 15.0 m and thickness of
0.6 m which is below the finished surface level. The existing water...
A new concrete water tank (unit weight= 24 kN/m3) with inner
diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is
proposed for construction to cover the water shortage of government
officers’ quarters that located near to an existing 6.0 m high
concrete water tank with similar diameter. The existing water tank
sits on a concrete foundation of diameter 15.0 m and thickness of
0.6 m which is below the finished surface level. The existing water...
A new concrete water tank (unit weight= 24 kN/m3) with inner
diameter of 13.8 m with 0.1 m wall thickness, and 9.0 m high is
proposed for construction to cover the water shortage of government
officers’ quarters that located near to an existing 6.0 m high
concrete water tank with similar diameter. The existing water tank
sits on a concrete foundation of diameter 15.0 m and thickness of
0.6 m which is below the finished surface level. The existing water...
Most questions answered within 3 hours.
-
Calculate the pH of each of the following solutions.
0.50 M HBr
3.1×10−4 M KOH
4.2×10−5...
asked 18 minutes ago -
For the year ended December 31, Depot Max’s cost of merchandise
sold was $85,600. Inventory at the...
asked 17 minutes ago -
Week 10 - Professional Memo Assignment
Professional Memo Assignment
Your mission for this week, should you...
asked 22 minutes ago -
Write a Python program that stores the data for each
player on the team, and it...
asked 32 minutes ago -
In
the last 3 months, mike never knows when he is going to get his
allowance...
asked 56 minutes ago -
Is Ca(OH)2 a Bronsted base, Lewis base, or both? Why?
asked 46 minutes ago -
1A- Why don’t voters complain about U.S. tariffs on imported
sugar?
Because sugar is only a...
asked 55 minutes ago -
Cash Payback Period
Primera Banco is evaluating two capital investment proposals for
a drive-up ATM kiosk,...
asked 53 minutes ago -
Create a button in Swift (Xcode) that will create a charge,
create a charge using Stripe's...
asked 53 minutes ago -
The reaction rate of CO and NO2 in the reaction
CO(g) + NO2(g) → CO2(g) +...
asked 55 minutes ago -
Imagine that a chemist puts 6.40 mol each of
C3H8 and O2 in a 1.00-L container...
asked 1 hour ago -
How much money should be invested today in order to have $8340
at the end of...
asked 1 hour ago