plz give correct answer Q5. We are collecting an analog signal ranging from oV to SV...
measurements. please show work to all. Thanks! Remark Do not use computer software. Use a calculator only, and show your calculation process Q1. We have an analog signal Y[V] sin(2π*St). We are collecting this signal with a sampling frequency 20 Hz with analog-to-digital (A/D) converter. Draw the output of A/D converter. (0.4pt) Voltage Voltage YIV] sin(2n*5t) 0.5 0.0 0.5 Time (s) 0.0 0.0 0.2 0.4 0.10 0.20 0.30 0.40 Time (s) Q2. Calculate the resolutions for the 2-bit, 8-bit, 12-bit,...
Oil estion 2 (9%) The voltage output from a J-type thermocouple referenced 0°C is to be used to measure temperatures from 50 to 70°C. The output voltages vary linearly over this range from 2.585 to 3.649 mV 1. If the thermocouple voltage is input to a 12-bit A/D converter having a +5V range, estimate the percent quantization error in the digital value; 2. If the analog signal can be first passed through an amplifier circuit, compute the amplifier gain required...
1900) An analog input module uses an A/D converter with 8-bit resolution. The module range is -10 volts to +10 volts. Calculate the module output (digital count) when the input voltage is 3.7 volts. 1) floating point calculation, 2) discrete rounded result (actual digital count), 3) answer-2 minus answer-1 and 4) voltage resolution or smallest detectable change (volts). Assume the minimum digital value is zero. ans:4 thats all that was given to me
Q1) Digital-to-Analog Conversion The signal shown in the figure below is inserted to a 5-bit ADC converter Considering, the useful range of the converter is 0-3V, draw the values obtained in the ADC output register when the sampling time is a) 1ms, and b) 0.5ms 3 1.5 16 [ms] 8 0 12 a) 4t ms Reg. value 16 ms] 12 4 0 b) 4t 0.5ms Reg. value 16 t [ms] 12 4 8 Q1) Digital-to-Analog Conversion The signal shown in...
Problem 2 (25 pts.) A thermocouple is to be used with a 16 bit A/D converter that has an input range of ov to sv. The voltage output of the thermocouple varies linearly with the temperature over the temperature range of 50°C to 70°C; the corresponding voltages at these temperatures are 2.585 mV and 3.649 mV respectively. Parta) 5 pts. Compute the quantization error of the A/D convertor and the temperature resolution for the entire system. Part b) 10 pts....
When designing an Analog to Digital System all of the range values for the system must be defined from input to output. This input will be used to drive a 3. PWM output signal to operate an LED. Assume the PWM is calibrated to read minimum to maximum based on the binary input range given. Potentiometer - 10 KS2 (0 degrees to 180 degrees) VDC for Potentiometer 12 V Analog Converter Module 10 bit, Vref 8 V PWM Module-8 bit,...
Questions 4-20. Questions 4-20. QUESTION 4 the output becomes The longer a signal is applied to the input of an integrator op amp, the a smaller b. larger QUESTION 5 the output becomes. The faster the voltage applied to the input of a differentiator changes, the a smaller . b. larger QUESTION 6 voltage than for a negative-going signal. A Schmitt trigger switching threshold for a positive-going input signal is at a a lesser . b.greater QUESTION 7 If a...