Draw the indicated influence lines,
Draw the indicated influence lines, 77% Influence Lines for: RA RC MA VA VB Mc VC,...
Draw the influence lines for reactions RA, and RC of the beam below-given a=6 ft, b=6 ft, c=4 ft. Assuming that the span can be loaded with a 3.7 kips/ft uniform load of variable length, determine the maximum negative (down)value of the reaction RA in kips. Do not include the - sign. 000 Rc - a - obstaco
Using the Clapeyron's three moment theorem, calculate MA, VA, VB and VC for the beam shown below. EI is constant. In addition, sketch the bending moment and shear force diagrams. 50 kN 6 kN/m 6 m fi Im.
6b.1 Draw the influence lines for: All reactions (MA, Rc, Re, Rg, MH) Shear at B,D and F And moment at C, E, and G *Note: Node H only resists rotation, allows both vertical and horizontal motion H B D E 7 @ 5' 6b.1 Draw the influence lines for: All reactions (MA, Rc, Re, Rg, MH) Shear at B,D and F And moment at C, E, and G *Note: Node H only resists rotation, allows both vertical and horizontal...
GIVEN: Beam below REQ'D: Draw designated influence lines VB MB
draw an ohmeter and ampermeter on the PICTURE.Drawing connection cables as using lines. 20.35 mA VA 9 volts mA VA A COM 2.2 kohm VA 9 volts O А CAF mA vad ТА COM
Chapter 6- Influence Lines Draw the influence line for the shear and moment at C for the beam shown below. The support at A is a roller and the support at B is a pin. The beam is subjected to a uniform load of 5 kip/ft over its entire length and a single 12 kip concentrated force. Deternmine the maximum values of Ve and Mc and the position of the applied concentrated force for each condition. Answer: VC: +0.5 at...
Q.3 (15 pts) For the beam shown below draw the influence line for Rc, Rp. VB, and Mg using either the equilibrium method or the Muller-Breslau principle. Use the influence line for MB to compute the absolute maximum and absolute minimum bending moment produced at B due to a uniformly distributed live load of 10 k/ft that may or may not be present anywhere on the beam. Use the influence line for Veto compute the absolute maximum shear force produced...
Problem 1. For the beam below, use either the "tabulated values" method or the influence-line equations" method to: (a) Draw the influence lines for reactions A, and MA. (b) Draw the influence lines for the reaction at C. (c) Draw the influence lines for the moment at C. (d) Determine the maximum positive and negative values of the reactions at A and C if the span can be loaded with a 1.2kips/ft uniform load of variable length and a Skips...
Draw the influence lines for Ay, Dy, Fy, VC, and VE, MD, ME and MB. step by step A в C E >e ><- 4 4 6' 4'
(Influence Line Use) Problem 2. The INFLUENCE LINES ARE GIVEN for the beam below. DRAW THE PLACEMENT OF THE LOADS AND CALCULATE THE VALUES FOR THE MAXIMUM NEGATIVE SHEAR at "B", and MAXIMUM POSITIVE MOMENT at "B" due to a concentrated point load of 1400 lb, uniform live load of 800 lb/ft, and a uniform dead load of 600 lb/ft. (12 points) B с 10 ft 6 A 2A 2 ft Vs. 2.25 IL RA -0.25 1.25 0.25 IL VB...