Q An ideal regenerative steam power cycle operates so that steam enters thet MPa, 500°C and...
thermodynamic
2. A ste am power plant operates on an ideal regenerative Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is condensed in the condenser at 10 kPa. Steam is extracted from the turbine at 0.5 MPa to heat the feedwater in an open feedwater heater. Water leaves the feedwa ter heater as a saturated liquid. The plant has a net power output of 150 MW. Show the cycle on a T-s dingram, and determine (a)...
Consider an ideal steam regenerative cycle in which steam enters the turbine at 3.0 MPa, 400°C, and exhausts to the condenser at 10 kPa. Steam is extracted from the turbine at 0.8 MPa to an open feedwater heater. The feed water leaves the heater as saturated liquid. The appropriate pumps are used for 2 the water leaving the condenser and the feed-water heater. Calculate (a) the thermal efficiency of the cycle, (b) the net work per kilogram of steam, and...
Consider a steam power plant that operates on the ideal
regenerative Rankine cycle with a closed feedwater heater as shown
in the figure. The plant maintains the turbine inlet at 3000 kPa
and 3508C; and operates the condenser at 20 kPa. Steam is extracted
at 1000 kPa to serve the closed feedwater heater, which discharges
into the condenser after being throttled to condenser pressure.
Calculate the work produced by the turbine, the work consumed by
the pump, and the heat...
a) A steam power plant operates on an ideal reheat-regenerative Rankine cycle. Steam enters the high-pressure turbine (HPT) at a pressure of 10 MPa and temperature of 550°C. The steam expands through the HPT stage to a pressure of 0.6 MPa. Some of the steam at the end of the expansion process in HPT is extracted for a regeneration process in a closed-type feedwater heater. The steam leaves the heater as a saturated liquid and then is throttled to the...
10-55 Consider a steam power plant that operates on the ideal regenerative Rankine cycle with a closed feedwater heater as shown in the figure. The plant maintains the turbine inlet at 3000 kPa and 350°C and operates the condenser at 20 kPa. Steam is extracted at 1000 kPa to serve the closed feedwater heater, which discharges into the condenser after being throt- tled to condenser pressure. Calculate the work produced by the turbine, the work consumed by the pump, and...
10-48 Consider a steam power plant that operates on the ideal regenerative Rankine cycle with a closed feedwater heater as shown in the figure. The plant maintains the turbine inlet at 3000 kPa and 350°C; and operates the condenser at 20 kPa. Steam is extracted at 1000 kPa to serve the closed feedwater heater, which discharges into the condenser after being throttled to condenser pressure. Calculate the work pro- duced by the turbine, the work consumed by the pump, and...
2) A steam power plant operates on an ideal regenerative rankine cycle with superheated steam leaving the boiler, entering the turbine at 10 mPa,600C. X fraction of steam is extracted from the turbine at 0.6 mPa pressure for the high pressure open feedwater heater. Then x fraction more of steam is extracted from the turbine at 0.2 mPa pressure for the low pressure open feedwater heater . The condenser pressure in the cycle is 5 kPa. The mass flow rate...
A steam power plant operates on ideal regenerative Rankine cycle with 2 feedwater heaters, a shown in Fig. 4. Steam enters the turbine at 100 bar and 630 °C and exhaus at 1.1 bar. Steam is extracted from the turbine at 60 bar and 20 bar. The mass flow rate steam through the boiler is 1 kg/s. ts to the condenser of (a) Show the cycle on a T-s diagram. (b) Use the attached T-s diagram to determine h1, h3,...
A steam power plant operates on an ideal Rankine cycle with two
of its feedwater heater closed as shown in the figure below and
with a net power output of 105MW. The mass flow rate of the steam
is 70kg/s and enters the high-pressure turbine at 6MPa and
and leaves at 1.5 Mpa. a fraction of x of steam is extracted at
this pressure to the closed feedwater. a fraction of y of steam is
extracted from the second stage...
In a regenerative ideal Rankine cycle, hot water steam enters the turbine at 10 MPa and 480°C. condenser inlet pressure is 10 kPa. Some steam is taken from the turbine at a pressure of 0.7 MPa, feeds a Closed Feed water heater and is sent to the condenser as a saturated liquid at a pressure of 0.7 MPa at the outlet. The other outlet (cold) is at a pressure of 10 MPa and a saturation temperature of 0.7 MPa. According...