An engine is lifted with the frictionless pulley shown. -1.8 m 1.8 m 74 kg If...
As shown, a frictionless pulley hangs from a system of springs and a cable. The pulley is equidistant between the two supports attaching the springs to the ceiling. The distance between the supports is d=1.50 m . The cable cannot stretch and its length between the two springs is 1.8 m. (figure 1) (FIgure 2) A)As shown, a mass is hung from the pulley. This mass causes a tensile force of 17.0 N in the cable and the pulley to...
The upper end of the homogenous, constant cross-section, straight bar AB leans against the frictionless vertical wall, at B. If the bar has a mass of 35 kg, determine the tension in cable BC and the magnitude of the total force exerted by the ball-and-socket joint at A. 3. The upper end of the homogenous, constant cross-section, straight bar AB leans against the frictionless vertical wall, at B. If the bar has a mass of 35 kg, determine the tension...
Determine the tension in cables AB, BC, and CD necessary to support the 11-kg and 17-kg traffic lights at B and C, respectively. Also, find the angle θ. 15°) в OP OP OP Q Tap image to zoom Part A Determine the tension in cable AB. Part A Determine the tension in cable AB Express your answer to three significant figures and include the appropriate units. TAB= 417N Correct Part B Determine the tension in cable BC Express your answer...
2.50 Two slender links, AC and BC, extend from a wall and support a pulley at C. A cable, tied at D, passes over the small pulley at C and experience an 80-lb force at its free end E. If the pulley is frictionless and of negligible determine the forces developed in members AC and BC. An inextensible (cannot stretch) cable AC and spring CB are originally horizontal. A 100-N weight is attached to point C, and the system is...
Problem (3) A motor M and a frictionless pulley-cable system are used to lift the 850 lb crate shown at a constant acceleration. The motor has an efficiency of E = 0.6 and the input power to it is 92 hp at the instant when the load has been hoisted s = 15 ft starting from rest. Determine the tension force in the cable. Neglect the mass of the pulleys and cable.
An object of mass -20 kg is lifted by a standard man with the aid of a pulley, as shown in the figure below. The upper arm is held vertical and the lower arm has an angle of θ·33° with the horizontal. The label c.m. marks the centre of mass of the lower arm. Consider the force due to the weight of the object M, the weight of the lower arm and hand, the tension due to the triceps muscle,...
help with part 5 1. A 125-kg load is lifted 12.0 m vertically with an acceleration a -0.32g by a single cable. Determine: (a) the tension in the cable, (b) the net work done on the load, (c) the work done by the cable on the load, (d) the work done by gravity on the load, and (e) the final speed of the load assuming it started from rest. 2. A 1.60-m tall person lifts a 2.10-kg book from the...
A 13.5 m boom, AB, of a crane lifting a 3,000 kg load is shown below. The center of mass of the boom is at its geometric center, and the mass of the boom is 2,800 kg. For the position shown, calculate the following. tension T in the cable (in N) N the force at the axle A (Give the magnitude in newtons and the direction in degrees counterclockwise from the +x-axis. Assume that the +x-axis is to the right.)...
An object with mass m1 = 4.70 kg, rests on a frictionless horizontal table and is connected to a cable that passes over a pulley and is then fastened to a hanging object with mass m2 = 11.7 kg, shown in the figure. as (a) Find the magnitude of the acceleration of each object m/s2 a1= m/s2 a2 (b) Find the tension in the cable N
A 8.2-kg box is being lifted by means of a light rope that is threaded through a single, light, frictionless pulley that is attached to the ceiling. If the box is lifted, at constant acceleration, from rest on the floor to a height of 1.8 m above the floor in 0.42 s, what average power is delivered by the person pulling on the rope? Answer in kW