CdS is illuminated with a light source with hf = 3.11 eV. (a) Calculate the corresponding...
A surface whose work function is 1.8 eV is illuminated by a light whose wavelength is 167 nm. What is the maximum velocity of a photoelectron emitted from the surface? The speed of light is 3 × 108 m/s and Planck’s constant is 6.63 × 10−34 J · s.
please show all work
4) A metal having a work function of 2.5 eV is illuminated with white light that has a continuous wavelength band from 400 nm to 700 nm. For which one of the following ranges of the wavelength band in this white light are photoelectrons NOT produced? (h-6.626 x 10-34 J s, c 3.00 x 108 m/s. 1 eV- 1.60 x 10-19 J) Aner Answer oibn MAW od voa 5) A metal having a work function of...
When a metal is illuminated by light, photoelectrons are observed provided that the wavelength of the light is less than 606 nm. What is the metal's work function? (c - 3.00 x 10 m/s, h = 6.626 x 10-34 J·s, 1 eV = 1.60 x 10-19)) 25 ev 2.2 eV 24ev 21ev
(1 point) A Silver surface (work function = 4.26 eV) is illuminated with 270 nm light from a 3 mW laser. How many photons per second are emitted by the laser? 4.0909E15 photons/s Only a small fraction of these photons can interact with electrons at the surface. Suppose this fractional efficiency is 0.00031%. What is the current in the detector assuming all the emitted electrons are captured? пA Note that current is charge(in Coulombs) per second. The charge of one...
Example Key Parameters A silicon solar cell (bandgap 1.12 eV) is uniformly illuminated by monochromatic light of wavelength 600 nm and intensity 40 mW/cm2. Given that its external quantum efficiency at this wavelength is 0.9 the ideality factor is 1.5, and the dark saturation current density is 3 pA/cm2 i calculate the short circuit current of the cell if its area is 2 cmA2 calculate the open circuit voltage iii) fill factor iv) energy conversion efficiency
Calculate the energy in eV corresponding to the 411 nm of light inside a medium with refractive index 1.3. Round your answer to 2 decimal points
The work function of palladium is 5.22 eV. A) What is the minimum frequency of light required to observe the photoelectric effect on Pd? B) If light with a 110 nm wavelength is absorbed by the surface, what is the velocity of the emitted electrons?
a) The frequency of light coming out from a laser source is 297 MHz. What is the wavelength corresponding to the light in meter provided that the speed of light inside the medium is 1.9 x10^8 m/s? Round your answer to 2 decimal points. b) Calculate the energy in eV corresponding to the 585 nm of light inside a medium with refractive index 1.3. Round your answer to 2 decimal points. c) A light ray in air is incident on...
Can You See a Single Photon? The wavelength corresponding to the maximum sensitivity of the human eye is 510 nm, the limit of sensitivity of the dark-adapted eye has been shown to be correspond to a 100 ms flash of light of total energy 240 eV. (Little Shop of Physics- Colorado State University) 1 J = 6.241509 x 1018 eVa) What is the energy of a single photon at this wavelength?b) How many photons does the flash contain?c) If 60%...
Surface Recombination: Suppose I have a sample of 10 μm thick silicon illuminated under 775 nm wavelength light (absorption coefficient 10' cm) at an intensity of 50 mW/cm2. The surface recombination velocity and bulk minority carrier lifetime are 10 em/s (for both respectively. Assume Δη and Δp are » no or po- surfaces) and 10 us, Why is surface recombination referred as a velocity? What is the estimated short circuit current assuming no bulk or surface recombination and perfect transmittance...