LTC plate A mixture of compounds A, B and C was spotted on a TLC plate...
4. Consider the following silica gel TLC plac or compounds A, B, and hexines: developed in Fo-o- og a) Determine the Rr values of compounds A, B, and C run on a silica gel TLC plate using hexanes as the solvent b) Which compound, A, B, or C. is the most polar? values if you used acetone instead c) What would you expect to happen to the of hexanes as the eluting solvent? 5) Consider a sample that is a...
8.5 TLC is commonly employed with column chromatography to monitor the separation of colorless compounds. The column is allowed to elute into many containers, usually test tubes. This is followed by a TLC on a long plate containing the same stationary phase as the column chromatography. Since a large number of tubes must be spotted, by spotting only every other (or every three etc.) tube on the plate. After visualization (by UV), the TLC plate is used to judge which...
1. What is the retention factor for the following TLC plate if the baseline is 1 cm, elute solvent traveled 5cm, and the spot of interest traveled 2.5cm? a) 0.50 b) 1.6 c) 0.63 d) 1.4 10. Column chromatography employs both a stationary and a mobile phase. Which of the compounds listed below is commonly used as the stationary phase in column chromatography? a) decolonizing charcoal b) sodium bicarbonate c) benzoic acid d) silica gel
What is the main purpose of running a column chromatography? Similar to TLC. column chromatography is based on analytes being partitioned between a stationary phase (not moving) and a mobile phase (moving). What is most commonly used as stationary phase in a column? Is this material polar or non-polar? In this experiment, you will use different solvents to run column chromatography separation of different pigments extracted from spinach leaves. These solvents are a mixture of acetone and hexanes. (a) What...
2. An unknown compound was analyzed using thin layer chromatography, its constituted of two components (A and B) as shown in the TLC (Silica coated stationary phase; Chloroform and Ethyl acetate as mobile phase). The mixture was then loaded onto column with silica as the stationary phase and the same solvent system was used. (2 points) Column Chromatography TLC time A В Predict the order of elution of the compounds (A and B). which one would be eluted first/last and...
6. Silica gel was used as the solid support for the TLC plate.
Which of the three compounds (A, B, or C) in the APPLIED MIXTURE is
the least polar? (See the figure attached.)
8. Which compound below will have the highest Rf on a TLC
plate? Explain your reasoning. (See figure attached.)
10. The following TLC plates have been spotted with two
different compounds and are about to be eluted. For each plate,
explain if it has been spotted...
2. What are the phases involved in TLC? 3. What is coated on the TLC plate? 4. What is the purpose of lining the wall of the TLC chamber with paper? 5. Why is it important to use a small amount of the mobile phase? 6. Why should you remove the TLC plate before the mobile phase reaches the top? 7. What type of compounds are visible with UV light? 8. With a polar stationary phase and non-polar mobile phase,...
TLC Consider the following silica gel TLC plate of compounds A, B, and developed in hexanes: solvent front 0 D origin A B C 22. Determine the Ry values of compounds A, B, and Crun on a silica gel TLC plate using hexanes as the solvent. 23. Which compound, A, B, or C, is the most polar? 24. What would you expect to happen to the Ry values if you used acetone instead of hexanes as the eluting solvent? 25.TLC...
1. What are the main differences between thin layer chromatography (TLC) and column chromatography (CC)? 2. Are CC and TLC operations conducted concurrently? Explain. 3. Name a few packing materials used in packing columns in Column Chromatography operations. 4. Explain the role of eluting solvent(s) in column chromatography procedures. 5. When performing column chromatography, which of the following compounds would you expect to elute first: Ferrocene of acetylferrocene? Explain why.
1. What is the purpose of Thin-Layer Chromatography (TLC)? 2. What are the phases involved in TLC? 3. What is coated on the TLC plate? 4. What is the purpose of lining the wall of the TLC chamber with paper? 5. Why is it important to use a small amount of the mobile phase? 6. Why should you remove the TLC plate before the mobile phase reaches the top? 7. What type of compounds are visible with UV light? 8....