Sketch shear and moment diagrams including deflected shapes. (Indicate exact values) 2.1) PP 2PP L/2 Shear...
Draw the shear and moment diagrams including deflected shapes. 12. 3L14 Shear Shear Moment Moment Deflected shape Deflected shape w2 12 Shear Shear Moment Moment Deflected shape Deflected shape
Draw the Shear & Moment Diagrams and sketch the deflected shape for the beams shown below (Indicate values at points of change and minimums and maximums. Also indicate units near values or on each drawing axis) Scan or photograph when completed. Submit on Moodle as a .pdf or .jpg 10k w = 200 lb/ft 2k W = 800 lb/ft 10 ft 5 ft 5ft > 10 ft ** 5+ > 5 > M M D D
a Determine the reactions b) Draw the shear and moment diagrams c) Sketch the deflected shape
For beam given below Draw the shear- and moment diagrams. Label all important values of shear and moment. nclude the conventions for shear and moment directly on the diagrams Sketch the deflected shape To reeiv leredr you mus ue astraighto sbwg ns 3 kips 12 kip-ft 4 ft 4 ft 4 ft
Analyze the Frames shown below. Draw the shear and moment diagrams and sketch the approximate deflected shape Settlement at A = 1” and at C = .5” E = 30000 kis, I = 240 in4 2k/ft 8 k B EI EI 36 k-ft С 12'1 EI A 12' 8'
Construct the shear and bending moment diagrams and the qualitative deflected shape for each of the beams shown. 5.45) 20 kips 2 kips/ft Hing 10' 10' 30
Draw the shear and bending moment diagrams and the qualitative deflected shape for the beam shown in Fig. 5.10(a)
1-(25%) Draw shear and moment diagrams for the beam shown in Figure P-1 . Draw a sketch of the deflected shape. The spans are 30-ft long each (total of 90-ft), the concentrated loads are each 120 kips, and placed at the center of left span and the free end. El is constant. Left support is a pin and the other two are roller supports. 120 kips 120 kips Figure P-1 1-(25%) Draw shear and moment diagrams for the beam shown...
3. Without writing shear and moment equations, draw shear and moment diagrams and indicate the values at all critical locations. 20 kN 40 kN/m 20 kN/m 1.2m 4m 4m
For each beam, draw the shear and moment curves label the maximum values of shear and moment, locate points of inflection, and sketch the deflected shape. 200 kip. ft 170 kip. ft 100 kip ft D E