We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
Problem 1. Find the current I and V, in the circuit. Turn on voltage of the...
1. (20 points) For the 2 following circuits solve for the labeled current I and voltage V. Use the constant- voltage-drop diode model (VD-0.7V). +5V +5V 10k2 -5V -5V
2. For the circuit shown below, find the current ip and voltage V1. Assume the forward bias voltage of the diode is 0.7V V1 5 V 5 V 2. For the circuit shown below, find the current ip and voltage V1. Assume the forward bias voltage of the diode is 0.7V V1 5 V 5 V
Assume the diode turn-on is .7 for each diode. Determine Vo when VI is a) 5v and b) -5v 5. Assume the diode turn-on voltage is Vy=0.7V for each diode in the circuit. Determine Vo when (a) Vi =5V, and (b) Vi =5V (10 pts) 5.7 Žion SION wt 3102
can someone please explain how to solve this problem? thanks 4. Current and Voltage Source with Diode: For the circuit shown below, find the voltage vo. The current-voltage relationship for the diode is, as usual, I = VT = 0.026 V. Io (e/Vr 1 where Io = 10-12 A and + vf 10 15 + 10 V (+ 1 A Vo 5 mH 4. Current and Voltage Source with Diode: For the circuit shown below, find the voltage vo. The...
Can Someone explain how to do this problem? 4. Current and Voltage Source with Diode: For the circuit shown below, find the voltage vo. The current-voltage relationship for the diode is, as usual, Io(e"s/V 1) where Io 10-12 A and VT 0.026 V 10Ω 10 V (+ 5 mH Uo 1 A 4. Current and Voltage Source with Diode: For the circuit shown below, find the voltage vo. The current-voltage relationship for the diode is, as usual, Io(e"s/V 1) where...
ONLY QUESTION 7 Problem 7. Find voltage V and current I. Diodes have nonideality factor n1.5, reverse saturation current Is-10-14 A and reverse breakdown voltage bigger than Vo IOUl 0,9 V Problem 8. Consider two circuits below with Vs being sinewave of the 10V amplitude. Use constant voltage source diode model with turn-on voltage of 0.5 V. Sketch the waveforms of V
For the equivalet circuit of the PV cell assume Diode voltage 0.6 V Photocurrent, Isc 6 A Resistance Rp 10 Ohms Reverse saturation current 30 pA and kT/q- 25.7 mV CA Load Figure P84 Problem 5- Calculate the diode current, in Amps Problem 6- The current in the parallel resistance, in Amps Problem 7- The load current I, in Amps Problem 7-B. calculate the electric power delivered by the cell, in Watts 5.8 5.9 I-V characteristic I-lo (exp(qv/kT)-1) Open circuit...
Problem 3: (20 points) A zener-diode voltage regulator circuit is shown belkw zener diode has breakdown voltage Vz 8.0V and the zener resistance is nsumed to be 0 ohms. The power supply voltage Vps can vary between 10V and 14V and the lod resistance Ri can vary between 100 ohms and 1 kohm, 圧 1. Find a value of R such that the zener diode remains properly biased over the range of variation of Vps and RI (hint: the minimum...
Please please solve this problem carefully, I have to turn this in by Monday and If I get this wrong, I can't graduate....because I don't get enough GPA.. Problem 4. (20 points) (a) Find iz in the following OP amp circuit if Va-5V. (10 pts) (b) Specify the range of voltage source values that will not cause the OP amp to saturate. (10 pts) 20 V 10 k? 20 V 6V
The zener diode in the circuit below has voltage Vzo = 5V, Iz = 0. It is modeled as a 0.7V drop in the forward direction. a) Determine the value of resistor R, that would result in a DC current 10 = 1 mA. b) Determine the DC output voltage V c) The circuit is subjected to a +-7V square wave as shown below. Capacitor Cis chosen such that at the square wave frequencies it acts as a short circuit....