QUESTION 12 Given that vo- 2.6V and RI 2.6kohm, what is ij in the figure? o...
Given Vo in the network in the figure, find IA 12 V 2 mA the tolerance is +/-100
Vo Q1. Assume that Op-Amp as shown above is ideal. Given that RI is 0.23 Ohm, R2 is 1.78 Ohm, R3 is 1.61 Ohm, R4 is 2.225 Ohm. Calculate Vo, V2 & 13. V2 (Volts) Submit Answer Tries 0/5 13 (Amps) Submit Answer Tries o/s Vo (Volts) Submit Answer Tries 0/5 R1 Vo Q2. Assume that Op amp shown is ideal. Given that R1 is 19 Ohm, R2 is 82 Ohm, R3 is 9.5 Ohm, R4 is 205 Ohm. Calculate...
For the given circuit, Solve for VO , ID , IL , and IZ for the
following cases. Take VS=1 V , VD=0.25 V , RD=15Ω , and VZ=0.7 V
.a) R1=800 Ω , RL=200 Ω
b) R1=500Ω , RL=500
Ω
c) R1=200Ω ,
RL=800Ω
d) R1=50Ω ,
RL=950Ω
(1 point) Ov: 141 ŠR lo vo @ 0 For the given circuit, Solve for Vo, ID, IL, and Iz for the following cases. Take Vs = 1V, Vp = 0.25...
Q1: For the circuit shown below, Vs(t)=18.965cos(1200rt) vollt. What is the peak value of Vo? Vpst Vs 09 Vps - RL Vo QUESTION 2 Q2: For the circuit shown below. Vs1 is 12.168 volt and Vs2 is 29.305 volt. What is the value of Vo? Ri=10K W Rp=10K w +15 R2-20K 2 6 + Vs2 13+ - 15 10K VE Rx=3.3K
Question 1 (20 marks) Consider the circuit in Figure Q1. Ri WW R2 6T OB Figure Q1 (a) To analyze the circuit, we apply the mesh current analysis. This is achieved by assuming the current in the left and right loops are ii and i2 as shown in Figure Q1. Apply the KVL and write down two equations corresponding to those two loops (4 marks) (b) If Vo=10 V, Ri=512, R2=512, Io=1A, what are the values of ii and i2?...
R1 R2 R4 Is vo R3 Vs Given that Vs is 18v,is is 6 A, Rİ İS 2 Ohm, R2 is 2 아nn and R3 is 1 Ohr" and R4 is 4 Ohm. Use the superposition, principle to find Vo in the circuit. (Unit : V) Subenit Answer Tries o/s SstentAsaer Thies 5
Internal resistance problem. Suppose that in Figure 3.3, Vo=13V,
R1=150kΩ, R2=375kΩ, and Ri=2MΩ. Initially, the voltmeter is
disconnected.
If the internal resistance of the meter were 12 M Ω, what is the
voltage across R2?
Volts:
For the network given in Figure 1.3 determine the following (a) Voso and Ino (b) Voco, Vo, Va, and Vs 3. 22k2 IM2 1.6k +3V Figure 13: Fixed-bias circuit configuration For the network given in Figure 1.4 determine the following (a) ID (b) Vos (c) Vo (d) Vs 4. o +20V E 068k Figure 1.4: Problem 1.4
For the network given in Figure 1.3 determine the following (a) Voso and Ino (b) Voco, Vo, Va, and Vs 3. 22k2 IM2...
Question 1 Find Vo in the circuit in the figure below using superposition. /a 2 mA 9 ks2 7 k2 5 k2 0 Vo with only Va turned on H with only Vb turned on Vo with only Ia on
Ri vo(t) = 0 Figure 19: Bandpass filter Use Matlab to plot the magnitude and phase of the frequency response. Make sure the frequency range is wide enough to show enough details. Assume R1 = R2 = 1k1, C1 = 7.5nF, and C2 = 2.5uF.