5) The content of a 4-bit shift register is initially 1101. The register is shifted six...
Question #5 (3 marks): The content of a 4-bit register is initially 1001. The register is shifted six times to the right, with the serial input (SI) being 010010. What is the content of the register after each shift? --------- --------- Serial in (SI) Serial in (SI) NO D1Q1 - D 2 Q2 Io D3 03 _ Dr D3 Q3 DO QO Serial out (SO) CE CE HCE LACE 1 Shift Clock - Q3 Q2 Q1 QO 1 0 0...
A 4-bit register is initially at 1011. The register is parallel-loaded with 1010, and then right-shifted with Din 1. The final state of the register is (a) 0011 (b) 0100 (c) 0101 (d) 1010 (e) 1101 9.
7) Consider an 8-bit shift register, with initial condition 1001110, which is shifted right six times, while the shift-in data is the following sequence: 0-1-1- 0- 0-0-I Show the sequence of output bits, and give the final state 7) Consider an 8-bit shift register, with initial condition 1001110, which is shifted right six times, while the shift-in data is the following sequence: 0-1-1- 0- 0-0-I Show the sequence of output bits, and give the final state
Assume that the 4-bit bidirectional shift register initially contains 0011, and the input data is High,. If the control pin for right/left is High for 2 clock pulses and Low for three more clock pulses , what are the contents after the fifth click pulse? (show detail answer)
With a 7494 parallel in serial out shift register, when you have 1101 loaded in the register what happens when you set the serial input to low and pulse the clock input 6 times? set to high and pulse 6 times?
Question 7 [10 points] Shift register A & B in the following circuit have 4 bits each. The initial content of A & B are the following: A 1011, B 0101. The shift register is shifted 5 times to the right. What is the content of the register A & B after each shift? sI Shift register A Shift register B CLK CIA Clock
2. Serial shift registers Draw missing connections to implement various shift registers 1. Shift right: All bits of the register move right by one position, and a new bit value from a serial input is stored in the most significant bit (leftmost flip-flop below). Serial input -02 az 02 a Do ao Serial indino 2. Shift left: All bits of the register move left by one position, and a new bit value from a serial input is stored in the...
Using D FFs and selectors, design a 4-bit shift register (SR) (with only serial inputs) that can shift its content one or two bits to the left or right.
Problem 2 (10 points): Consider the serial adder shown in Figure below. It uses two 4-bit serial shift registers A and B. Initially, register A holds the binary number 0110 and register B holds 0011, while the carry flip-flop is reset to 0. Note that the serial input for shift register B is connected to the logic value zero Use the given table to list the binary values in register A, register B, the S signal, and the carry flip-flop...
I need a Matlab code for a 4-bit parallel in serial out shift register.