Find all the reaction forces Ax, Ay,Dx,Dy
Find all the reaction forces Ax, Ay,Dx,Dy Problem 1 The frame shown in the figure has...
Ax, Ay, Dx, Dy, Md? Determine the magnitude and direction of all support reactions for the pin-jointed structure shown below. 450 lb
Find Ax, Ay, Dx, Dy and Md Determine the magnitude and direction of all support reactions for the pin-jointed structure shown below. 450 bift + 47 D Question 1 Points out of 1.00 Remove itag Answer saved Ax= Select one a. 7200 lbs
QUESTION 1 In the frame shown below dimension His 7m, y is 3m, L is 7m, x is 4m, I is 4m, h is 3m. External loads are: the horizontal point load P of 2kN is applied at B, the clockwise moment M of 5kNm is applied at D, the vertical uniformly distributed load w of 1kN/m is applied on bar FJ. Calculate reactions of supports. Note that this frame has two internal pins; at Cand at F. What is...
Q1. The frame shown has two pin supports at points A and B. The horizontal reaction at B is -1.83kN (1.83kN to the left). Calculate the remaining reactions for the frame and draw the bending moment diagram, calculating and marking all local maximum moments. Also sketch the deflected shape, noting any points of inflexion 2kN 5 m 1.5 m 0.75 kN/m 4m Deflected BMD Shape
Learning Goal: To solve for the support reactions of a frame. The frame shown in (Figure 1) is supported by a pin at A and a pin at D. The two members are connected by a pin at C. The dimensions are H = 1.4 m, H2 = 2.1 m, and L = 1.5 m The applied force P = 18 kN acts at the midpoint of BC, and the distributed load has intensity w = 1.4 kN/m Part C...
What is the reaction Ax to the nearest 0.01 kN for the following frame? El are constant and the same for all members. Consider only bending energy. W = 67 kN/m w -5 m-+ 10 m ---5 m 5 m А B 422 CHAPTER 10 ANALYSIS OF STATICALLY INDETERMINATE STRUCTURES BY THE FORCE METHOD 10.5 Force Method of Analysis: Frames The force method is very useful for solving problems involving statically indeterminate frames that have a single story and unusual...
Question I.5 Figure 1.5 shows a frame with loads at A and D. Select the closest value for the magnitude of the total reaction at B. Assume the weight of the frame is zero. 40 kN VE 96.2 kN (a) (Ь -40 kN 5 m (c) -87.5 kN 30 kN (d) 57 kN 4m ao 1 m (e) 50 kN Figure L.5 Low mass frame Question I.6 In the shear and bending moment equations for beams, which of the following...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...