- 3. A propane storage tank is constructed by welding two hemispherical end caps onto a...
A cylindrical pressure vessel of 250 mm mean diameter and 6 mm wall thickness is fabricated from a 1.2 m length of spirally welded pipe AB as shown. Tank gauge pressure is 4 MPa and centric axial forces P and P1 of 240 kN act through rigid end plates. Determine: (a) Net longitudinal and hoop stresses. (b) Normal stress acting perpendicular to weld and shear stress parallel to weld (show sketch of Mohr’s circle). (c) Determine the Factor of Safety...
Problem 1 The gas storage tank has a longitudinal welded seam on its cylindrical section. The tank has an inner diameter of 1.40 m and a wall thickness of 6.0 mm. Determine the magnitude of normal stress on the weld if the internal tank pressure is 1.2 MPa. a) 170 MPa b) 140 MPa c) 96 MPa d) 53 MPa e) 1.7 MPa f) 250 kPa WELDED SEAM
A cylindrical tank holding oxygen at 5000 kPa pressure has an outside diameter of 500 mm and a wall thickness of 10 mm. It has been determined that a critical point on the tank is subjected to the tensile stress of 465 MPa in x-direction, compressive stress of 350 MPa in y-direction and shearing stress of 600 MPa. By using Mohr’s Circle; Sketch the plane stresses element for the critical point. Determine the principal stresses and their locations. Determine the...
A cylindrical tank holding oxygen at 4000 kPa pressure has an outside diameter of 500 mm and a wall thickness of 10 mm. It has been determined that a critical point on the tank is subjected to the tensile stress of 464 MPa in x-direction, compressive stress of 340 MPa in y-direction and shearing stress of 600 MPa. By using Mohr’s Circle; Sketch the plane stresses element for the critical point. Determine the principal stresses and their locations. Determine the...
Q3 (30) A cylindrical pressure vessel is constructed from a long, narrow steel plate by wrapping the plate around a mandrel and then welding along the edges of the plate to make a helical joint α 55° with the longitudinal axis. The vessel has inner radius r-1.8 m and wall thickness t 20 mm. The material is steel with modulus E: 200 GPa and Poisson's ratio0.30. The internal pressure p is 800 kPa Helical weld . The helical weld makes...