Please solve it clearly and by steps 8.1 For an NMOS differential pair with a common-mode...
URGENT The NMOS in the shown figure has Vt = 0.8V, kn = 5 mA/V2, and VA = 40 V. The circuit also has Vdd = 5V, VSS = -5V, RG = RLD = 1 M2, and RLS = 0 A. [3 marks] Neglecting the channel length modulation effect, find the value of Rs so that the NMOS operates in saturation with Ip = 0.4 mA B. [2 marks] Neglecting the channel length modulation effect, find the largest possible value...
1. Consider NMOS transistor in the circuit that has u.Cox = 0.4 mA/V?, W/L = 25, and V.=0.4V. (20 pts) (a) Find the value of Vas that results in saturation mode operation with a lp current of 0.1 mA. Neglect the Early effect. (2.5 pts) +1.5 V in BRD (b) Find the value of Rp that results in a de drain voltage of 0.5V. (2.5 pts) = = = (e) Find gw and r, at the de operating point specified...
please answer 1-3 thanks 1. Consider an n-channel MOSFET with tax = 6 nm, 1. = 425 cm /V., V,=0.8 V, and W/L = 15. What is the v of k,? (4 points) Identify the region of operation and find the drain current in the following four cases. (4 po each) (Total 20 points) Use &= 3.9 for Silicon. a. Vos = 2.5 V and Vps = 1.5 V b. Vos = 2.0 V and vps = 2.5 V c....
V.+w Operation in the triode reglon Condition v. e Wov 20 Vos uov os os-V (2) p V, so onl+Pala Characteristics Same relationships as for NMOS trasistos tCharacteristics: a CuGs- V,) ®os- } ip.C Replace .and NA with p,,and Nprespectively. V.V V, and yare negative. 2 wov ps For vos 2( -V) e Conditions for operation in the triode region ip lvi Q1. (10 points) For the following configuration of the given figure below, with the following parameters: VDD= +10...
please solve with a clear line 1) Explain the operation of E-MOSFET as a switch [3 marks] 2) Using the same transistor, design a circuit to switch ON an LED for two seconds and switch OFF for one second b) In your project you need to design a JFET CS amplifier with medium voltage gain Design a self-biased JFET amplifier. Assume Vpp = +15V, Ro=1kg. [4 marks] The Q-point is set to be Ip=3mA Given: loss = 10 mA, Vp...